TC Electronic UniTune Clip Manual


Læs nedenfor 📖 manual på dansk for TC Electronic UniTune Clip (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 21 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
UNITUNE CLIP
Clip-On Tuner with Strobe and
Chromatic Modes and 108 LED Matrix Display
for Uncompromised Tuning Quality
Quick Start Guide
(1) POWER button turns Unitune Clip on and o . Unitune Clip
turns o automatically after 5 minutes.
(2) REFERENCE TONE button can be used to adjust the reference
pitch used for tuning up or down from the default setting (A =
440 Hz). See “Changing the Reference Pitch” for instructions.
(3) DISPLAY MODE button toggles between Needle and Strobe
tuning modes.
(4) ADAPTIVE DISPLAY ORIENTATION INDICATORS show the
current display direction. The display will automatically  ip to
stay oriented for viewing at all times.
(5) MAIN DISPLAY shows the individual pitch of the currently-
tuned string in Needle/Strobe Tuning Mode.
(6) SECONDARY DISPLAY shows the detected note name for the
currently-tuned string.
Visit tcelectronic.com to download the full manual
(5)
(4) (3) (2) (1)
(6) Needle Mode
In Needle Mode, a single string’s pitch is indicated by a column of  ve
LEDs in the MAIN DISPLAY, and the target pitch’s name appears in the
SECONDARY DISPLAY.
Tune the string until the column of LEDs are centered and “on target
(left =  at; right = sharp).
Strobe Mode
In Strobe Mode, a single string’s pitch has two indicators:
Red LEDS to the left ( at) or right (sharp)
of the center LED column
“Rotating” segments in the display
Tune the string until the rotating segments slow down and stop,
and only the center column of LEDs lights up.
Changing Reference Pitch
The default reference pitch (A = 440 Hz) can be changed by following
these steps:
1. Press REFERENCE TONE button. The display will show the
current reference pitch (e.g., “440” for 440 Hz).
2. To increase the reference pitch in 1 Hz steps, press the
REFERENCE TONE button.
3. To decrease the reference pitch in 1 Hz steps, press the DISPLAY
MODE button.
4. To store the currently-displayed reference pitch, refrain from
pressing either button for 2 seconds. The set reference pitch
will blink 3 times.


Produkt Specifikationer

Mærke: TC Electronic
Kategori: Ikke kategoriseret
Model: UniTune Clip

Har du brug for hjælp?

Hvis du har brug for hjælp til TC Electronic UniTune Clip stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret TC Electronic Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Märklin

Märklin 72886 Manual

24 Januar 2025
Märklin

Märklin 72797 Manual

24 Januar 2025
Märklin

Märklin 7001 Manual

24 Januar 2025
Hilti

Hilti KCC-WF Manual

24 Januar 2025
Märklin

Märklin 7051 Manual

24 Januar 2025
ATen

ATen KH1516Ai Manual

24 Januar 2025
Adonit

Adonit PD-3A2C Manual

24 Januar 2025
Adonit

Adonit Dash 4 Manual

24 Januar 2025