Viper 37-0108 Manual


Læs nedenfor 📖 manual på dansk for Viper 37-0108 (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 32 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Laser Dart Line Mounting Instructions #37-0108
AVOID EXPOSURE LASER RADIATION IS EMITTED FROM THE APERTURE
AVOID DIRECT EYE EXPOSURE
Max Output <5mW, Wavelength 650nm-660mm, Class II Laser Product
Complies with FDA Radiation Performance Standards 21 CFR Chapter 1, Subchapter J
GLD Products, Muskego, WI 53150, Model #37-0108
ACCESSION NO:1410047-000
When the laser beam dims, or stops operating, replace batteries
Dispose of batteries promptly and properly, Do not burn them
Use only fresh batteries of the required size and type
Do not mix old and new batteries, or different types
If you do not plan to use the Laser Dart Line for a month or more remove batteries,
batteries can leak chemicals that can damage electronic parts
WARNING! Never look directly into the laser
WARNING! Keep away from children
WARNING! Never point the device towards anyone’s eyes
WARNING! Laser light can also be dangerous when refl ected on a mirror-like surface
WARNING! Use of controls or adjustments, or the performance of procedures other than specifi ed herein,
can result in hazardous radiation exposure
Read all instructions carefully before mounting the Laser Dart Line.
The Laser Dart Line can be mounted directly to a wall or the underside of a dartboard cabinet.
Required tools: pencil, screws, screwdriver, tape measure, drill, drill bit, and level.
Instructions
1) Mount your dartboard or dart cabinet. With one hand, place the Laser Dart Line on the wall or cabinet directly below
and centered to the dartboard. With your other hand, level the Laser Dart Line.
Backboard
Dartboard
Laser Dart Line
Level
Cabinet
Dartboard
Laser Dart Line
Level
Cabinet
Door
Laser Dart Line
Side View
2) Locate the two mounting holes on the front of the Laser Dart Line. Use a pencil, marker, or nail to mark the center of
the holes on the wall or cabinet.
Mounting Holes
Close Up
Make sure your mark
is centered in the oval
OFF ON
3) Drill a pilot hole on each mark that you created in step two. If using plastic anchors for dry wall, plaster, or cement, drill
the holes so that the anchors fi t snugly. Insert the plastic anchor. If drilling into a wood cabinet or wood stud, only pilot
holes will be necessary.
4) Align the Laser Dart Line with the anchors or pilot holes and screw the Laser Dart Line into place. The screws will
expand the plastic anchors. Before tightening the screws, check that the Laser Dart Line is level.
5) Remove the front battery cover and insert 4 AA batteries. The Laser Dart Line can also be powered by an AC to 5v
1000 mA adapter with DC plug polarity con gured as positive (+) outside and negative (-) inside. (4 AA Batteries and
adapter not included). Adapter item #42-9987 is available from GLD Products.
DANGER
CAUTION: The power adapter is not a battery charging device.
Do not plug in the power adapter when the Laser Dart Line is turned on.
Remove all the batteries before plugging in the power supply.
GLD Customer Service:
Email: info@gldgames.com
www.gldproducts.com
Publication 37-0108 Rev C
August 2017


Produkt Specifikationer

Mærke: Viper
Kategori: Ikke kategoriseret
Model: 37-0108

Har du brug for hjælp?

Hvis du har brug for hjælp til Viper 37-0108 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Viper Manualer

Viper

Viper AS510B Manual

23 August 2024
Viper

Viper AS380/15 Manual

23 August 2024
Viper

Viper AS4325B Manual

23 August 2024
Viper

Viper AS5160T Manual

23 August 2024
Viper

Viper AS5160 Manual

23 August 2024
Viper

Viper DR1500H Manual

20 August 2024
Viper

Viper AS7190TO Manual

20 August 2024
Viper

Viper AS4335C Manual

7 Marts 2024
Viper

Viper AS7690T Manual

16 November 2023

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Rittal

Rittal SZ 2500.100 Manual

12 November 2024
Voltcraft

Voltcraft SNPS-65 Manual

12 November 2024
Hertz

Hertz CAPRI H100 Manual

12 November 2024
Nuki

Nuki Keypad 2.0 Manual

12 November 2024
Schellenberg

Schellenberg 20023 Manual

12 November 2024
Schellenberg

Schellenberg 20262 Manual

12 November 2024
Silverline

Silverline KUL23 Manual

12 November 2024
ORNO

ORNO OR-ZL-1602 Manual

12 November 2024
Biltema

Biltema 26-2030 Manual

12 November 2024
Biltema

Biltema 47-7005 Manual

12 November 2024