Westinghouse PAK804W Manual

Westinghouse Ovn PAK804W

Læs nedenfor 📖 manual på dansk for Westinghouse PAK804W (28 sider) i kategorien Ovn. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/28
Electric Cookers - Rear Control
User Guide and Installation Instructions
2 general warnings
CONDITIONS OF USE
This appliance is intended to be used in household and
similar applications such as:
Staff kitchen areas in shops, offices and other
working environments
• Farm houses
By clients in hotels, motels and other residential
type environments
• Bed and breakfast type environments.
This appliance complies with the requirements of Australian
Standard AS/NZ 60335.2.6
Read the following carefully to avoid an electric shock or fire.
General Warnings
This appliance is not suitable for use by young children
or infirm persons, without supervision.
Young children should be supervised to ensure they
do not play with this appliance.
During use, this appliance becomes hot. Care should be
taken to avoid touching hot surfaces.
This appliance must not be used as a space heater.
Keep vents clear of obstructions.
In order to avoid a fire, the appliance must be kept
clean and vents kept unobstructed.
Do not spray aerosols in the vicinity of the appliance
when it is in operation.
Do not store flammable materials in or under the
appliance, e.g. Aerosols.
Accessible parts will become hot when in use.
To avoid burns and scalds children should be kept away.
If the supply cord is damaged it must be replaced by
a suitably qualified person in order to avoid a hazard.
Oven gloves should be worn when accessing hot
internal parts.
The warming drawer MUST not be used to warm, heat
or preheat food due to health regulations
Grill
Always turn the grill off immediately after use as fat
left there may catch fire.
Do not cover the insert with foil, as fat left there may
catch fire.
Always keep the grill dish clean as any fat left may
catch fire.
Do not leave the grill on unattended.
To avoid a fire, ensure that grill trays and fittings are
always inserted into the appliance in accordance with
the instructions.
Do not place thick portions of food under the grill.
Foods may curl, catch and ignite.
Do not store flammable materials in the grill.
Oven
During use the appliance becomes hot. Care should be
taken to avoid touching hot surfaces inside the oven.
Switch the appliance off before removing the oven light
glass for globe replacement.
To avoid an accident, ensure that oven shelves and
fittings are always inserted into the appliance in
accordance with the instructions.
Do not use the oven door as a shelf.
Do not push down on the open oven door.
Hotplates (Generally)
Do not allow pots to boil dry, as damage to both pan
and hotplate may result.
Do not operate the hotplates for an extended period
of time without a utensil on the hotplate.
Do not allow large cookware to overhang the hob
onto the adjacent benchtop. This will cause scorching
to the benchtop surface.
Do not allow cooking utensils to intrude into the
area which is close to the controls.
Ceramic Glass
If the ceramic glass is accidentally cracked switch off
the appliance to avoid the possibility of electric shock.
Do not place heat resistant mats, wire mats or aluminium
foil under pots or pans.
Do not cook food directly on the ceramic glass surface.
Do not use round bottom woks or similar utensils which
could lead to over heating of hotplates and possible
damage to the cooking surface.
Do not use the ceramic cooktop as extra bench space
or as a cutting board.
Installation, Cleaning and Servicing
An authorised person must install this appliance.
(Certificate of Compliance to be retained)
Before using the appliance, ensure that all packing
materials are removed from the appliance.
In order to avoid any potential hazard, the enclosed
installation instructions must be followed.
Ensure that all specified vents, openings and airspaces
are not blocked.
In order to avoid accidental tipping of the appliance
(for example, by a child climbing onto the open
oven door), the anti-tilt bracket must be installed.
Where the appliance is built into a cabinet, the cabinet
material must be capable of withstanding 85 deg C.
Only authorised personnel should carry out servicing.
(Certificate of Compliance to be retained)
Always ensure the appliance is switched off before
cleaning or replacing parts.
This appliance contains aluminium fittings. Do not
use caustic based cleaners.
Do not use steam cleaners, as this may cause
moisture build up.
Always clean the appliance immediately after any
food spillage.
Do not use harsh abrasive cleaners or sharp metal
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.
To maintain safe operation, it is recommended that
the product be inspected every five years by an
authorised serviceperson.
This appliance must be earthed.
Rear control electric cookers
contents 3
Installation 4
Controls 7
Understanding the cooker 13
Using the hotplates 14
Understanding the functions 15
Cooking guide for ovens 18
Get to know your oven 19
Handling baking &
grilling problems
20
Clocks 21
Cleaning and caring for the cooker 23
Cleaning and caring for the oven 24
Solving problems 25
Warranty 27
Contents
The symbols you will see in this booklet have these
meanings:
warning
Indicates information concerning your personal safety
caution
Indicates information on how to avoid damaging the appliance
tips & information
Indicates tips and information about use of the appliance
environmental tips
Indicates tips and information about economical and
ecological use of the appliance
tips & information
Important – check for any damage or marks
If you find the appliance is damaged or marked, you must
report it within 7 days if you wish to claim for damage/marks
under the manufacturer’s warranty. This does not
affect your statutory rights.
environmental tips
Information on disposal for users
Most of the packing materials are recyclable. Please dispose
of those materials by contacting your local authorities
and ask for the correct method of disposal.
Plastic clip
Plastic clip
securing points
4 installation
This appliance must be installed by an authorised
person in compliance with
local municipal building codes and any
other relevant statutory regulation.
Wiring connections must be made in accordance with:
New Zealand & Australian Requirements, including AS/NZS
3000 WIRING RULES
Refer to data plate for rating information. The data plate
is positioned on the bottom left corner of the oven front,
viewable with the oven door open. The circuit diagram is
positioned on the control panel back cover.
Electrical connection is 220-240 volts AC 50 Hz.
To gain access to the mains connection terminals,
remove the rear cover by unscrewing the two
assembly screws.
For New Zealand Only:
The cooking range must be connected to the supply by
a supply cord fitted with the appropriately rated plug
that is compatible with the socket-outlet fitted to the
final sub-circuit in the fixed wiring that is intended to
supply this cooking range.
The cooker requires a means of all pole disconnection
incorporated into the fixed wiring. This have a MUST
disconnection gap of 3 mm.
The cooker be earthed. Any damage caused MUST
by failure to earth will not be covered by warranty.
Note: Where connection is made to a multi-phase
220/240V supply, the bridge piece must be removed from
between the active connections on the main terminal block.
Fuse
Should the fuse need servicing it is accessible through
the fuse opening located in the back cover.
Hard wiring detail
1 Remove terminal cover plate from rear panel
of appliance.
2 Fit wires through hole in cover plate and make
connections to terminals.
3 Engage wires into plastic clip. Secure plastic clip with
two long silver screws (supplied in separate bag).
4 Replace cover plate onto rear panel.
Installation
3 Anchors
Minimum
Alternative
Method
Floor
mounted
Floor & skirting
mounted
Preferred
Method
5 Anchors
5mm Clearance min.5mm Clearance min. 596mm
100mm
Minimum
installation 5
Installation dimensions
IMPORTANT NOTICE
Installers responsibility
In ALL cases the anti-tilt bracket MUST be securely
anchored to the floor with suitable fasteners,
and the stability bolt fixed.
The anti-tilt bracket is a mandatory safety restraint.
In order to prevent accidental tipping of the appliance;
for example by a child climbing onto the open door,
the anti-tilt bracket supplied with the cooker be MUST
installed. ensure that the cooker is located so ALWAYS
that the anti-tilt bracket is engaged into the cooker.
Step 1: Positioning
Choose the most practical bracket mounting option
for your cooker.
The anti-tilt bracket can be floor mounted or floor and
skirting mounted depending on the location of the range
plug / socket / connection.
Step 2: Fixing anti-tilt bracket
Position the anti-tilt bracket so that it will fully
engage into the slot at the rear of the cooker. The
bracket is mounted centrally at the rear of the cooker.
Anchor the bracket into position using appropriate fasteners.
The appliance must not be installed in a corner. It
must be installed at least 100mm from the side wall.
Installation
6 installation
Installation
Step 3: Stability bolt
Fasten the stability bolt bracket to the front frame
with the 2 screws supplied.
Reposition the cooker back into the anti-tilt bracket
and then mark the position of the stability bolt hole.
Pull the cooker back out and drill the bolt location hole.
Use a 6.5mm masonry or wood drill. When drilling into
concrete ensure a minimum hole depth of 40mm.
Reposition the cooker back into the anti-tilt bracket,
aligning the stability bolt bracket with the 6.5mm drilled
hole. Then slide the bolt through the bracket into
the hole.
Side rack (fitted to selected models only)
Insert the twin pegged side into the rear access
holes provided, ensuring the pegs are fully inserted.
Then locate the front peg into the front access hole
and push in firmly.
Shelves and trays
The shelves are designed so that they have maximum travel
but cannot be accidentally pulled right out. The trays are
designed the same way and fit straight into the side racks.
Locate the rear edge of the shelf/tray in between 2 guide
rails of the side rack – see diagram. Ensure the same rail
positions on both sides of the oven are being engaged.
With the front edge raised, begin to slide the shelf into
the oven.
Once the detents have passed the front edge of the
side rack, the shelf can be pushed completely in.
When fully inserted the shelf/tray should not interfere
with the closed oven door.
To insert the grill tray in a separate grill product, fully
open the drawer and position the tray so that the slots
on the outer edges fit over the tabs on the slides.
Remove extra trays and dishes before roasting or baking.
1
2
3
4
5 6
7
7
1
2
3
4
5
8 controls
Mercury model 4U600
Colombo model 4U601
1 Hotplate Control Knobs
Adjusts temperature of hotplate. Can be rotated in
either direction.
2 Hotplate Indicator Lamp
Comes on when you turn a hotplate on.
3 Temperature Control Knob
Sets temperature for baking.
4 Oven Indicator Lamp
Comes on when you operate
the oven temperature control
knob. Cycles on and off
automatically when you are
cooking/baking.
5 Function Switch
Sets oven functions.
Bake - with light
Grill - with light
Light - light only
1 Hotplate Control Knobs
Adjusts temperature of hotplate. Can be rotated in
either direction.
2 Hotplate Indicator Lamp
Comes on when you turn a hotplate on.
3 Temperature Control Knob
Sets temperature for baking.
4 Oven Indicator Lamp
Comes on when you operate the oven temperature
control knob. Cycles on and off automatically when
you are cooking/baking.
5 Function Switch
Sets oven functions.
Bake - with light
Grill - with light
Light - light only
6 Timer
Sets reminder time.
7 General Purpose Outlet Switch
Controls (cont.)


Produkt Specifikationer

Mærke: Westinghouse
Kategori: Ovn
Model: PAK804W

Har du brug for hjælp?

Hvis du har brug for hjælp til Westinghouse PAK804W stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ovn Westinghouse Manualer

Ovn Manualer

Nyeste Ovn Manualer