Whirlpool AFG 6516-B WP Manual

Whirlpool Fryser AFG 6516-B WP

Læs nedenfor 📖 manual på dansk for Whirlpool AFG 6516-B WP (4 sider) i kategorien Fryser. Denne guide var nyttig for 22 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
INSTRUCTIONS FOR USE
Has the packaging been removed from under the appliance?
Note: gurgling noises from the refrigerating circuit after the
compressor cuts out are perfectly normal.
3. The green LED (if provided) is off and the appliance is
not working.
Is there a power failure?
Is the plug properly inserted in the socket?
Is the electric cable intact?
4. The green LED (if provided) is off and the appliance is
working.
The green LED is not working. Contact the After Sales
Service for a replacement.
5. The compressor runs continuously.
Have hot foods been put in the appliance?
Has the appliance lid been left open for a long time?
Is the appliance positioned in a very warm room or near heat
sources?
Is the thermostat setting correct?
Has the fast freeze function (depending on model) been
pressed by mistake?
6. Too much ice on the upper edge.
Are the defrost water drainage plugs correctly positioned?
Is the appliance lid properly closed?
Is the appliance lid seal damaged or deformed? (See chapter
"Installation")
Have the 4 protection pieces been removed? (See chapter
"Installation")
7. Condensation forms on the external walls of the
appliance
It is normal for condensation to form under certain
atmospheric conditions (humidity above 85%) or if the
appliance is located in a damp or poorly ventilated room. The
performance of the appliance is in no way affected.
8. The layer of ice on the internal walls of the appliance is
not uniform.
This phenomenon is quite normal.
SAFEGUARDING THE ENVIRONMENT
1. Packing
The packaging material is entirely recyclable, and marked with
the recycling symbol. Follow local regulations for scrapping.
Keep the packaging materials (plastic bags, polystyrene parts,
etc.) out of reach of children, as they are potentially dangerous.
2. Scrapping
The appliance is manufactured using recyclable material .
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE).
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment
and human health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the documents
accompanying the product, indicates that this appliance may not
be treated as household waste. Instead it shall be handed over to
the applicable collection point for the recycling of electrical and
electronic equipment.
Before scrapping, make the appliance unusable by cutting off the
power cable and removing the doors and shelves so that
children cannot easily climb inside the appliance.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal. Deliver the
appliance immediately to an authorized dump; do not leave it
unattended even for a few days, since it is potentially dangerous
for children. For more detailed information about treatment,
recovery and recycling of this product, please contact your local
city office, your household waste disposal service or the shop
where you purchased the product.
Information:
This appliance does not use CFC. The refrigerant system
contains either R134a (HFC) or R600 (HC). Refer to the rating
plate inside the appliance.
Appliances with Isobutane (R600a): isobutane is a natural gas
without environmental impact, but is flammable. Therefore,
make sure the refrigerant circuit pipes are not damaged.
This product may contain Fluorinated Greenhouse Gases
covered by the Kyoto Protocol; the refrigerant gas is inside a
hermetically sealed system.
Refrigerant gas: R134a has a Global Warming Potential of (GWP)
1300.
Declaration of conformity
This appliance is intended for storing food and is
manufactured in conformity with European regulation (EC)
No. 1935/2004.
This product has been designed, manufactured and marketed
in compliance with:
- the safety objectives of Low Voltage Directive 2006/95/EC
(replacing 73/23/EEC and subsequent amendments);
- the protection requirements of Directive "EMC"
2004/108/CE.
The electrical safety of the appliance can only be guaranteed if
the product is connected to an approved earth connection.
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. See if you can solve the problem yourself.
2. Switch the appliance on again to see if the problem has
been solved. If it has not, disconnect the appliance from the
power supply and wait for about an hour before switching
on again.
3. If the problem persists after this course of action, contact
After-Sales Service.
Specify:
the nature of the fault,
the model,
the service number (the number after the word SERVICE on
the rating plate on the rear of the appliance)
your full address,
your telephone number and area code.
INSTRUCTIONS FOR USE
GB
1. Lid handle.
2. Lock (if provided).
3. Seal.
4. Divider (if provided).
5. Defrost water drain plug.
6. Control panel.
7. Side motor cooling grille.
8. Upper edge.
9. Condenser (located at the rear)
INSTALLATION
Please refer to the chapter "BEFORE USING THE
APPLIANCE".
Unpack the appliance.
Remove the 4 protection pieces inserted between
lid and appliance.
Ensure that the defrosting water drainage plug (if
provided) is correctly positioned (5).
For best operation of the appliance and in order to
avoid damage when the lid is opened, leave a space of
at least 7 cm from the rear wall and 7 cm at the sides.
Fit the accessories (if provided).
1. Temperature adjustment thermostat.
2. Red LED (if provided) : Indicates that the appliance
temperature is not sufficiently low.
3. Green LED (if provided): indicates that the appliance is on.
4. Yellow/orange illuminated button (if provided):
activates/deactivates the fast freeze function. It lights up
when the fast freeze function is active.
The exact configuration of the controls may vary
according to the model.
Switching on the appliance
The appliance is factory set for optimum operation at a
temperature of -18°C.
Plug in the appliance.
The green LED lights up (if provided).
Also the red LED (if provided) will switch on because the
temperature inside the appliance is not yet sufficiently low
for food storage. The red LED will normally switch off
within the first six hours after the appliance is switched on.
After connecting the appliance to the mains supply and when
the optimal temperature has been reached (this phase takes
about 1 hour during which the lid will not open), ensure that
the fast freeze button is not pressed (the yellow LED, if
provided, is off).
Place food inside the product only when the red LED (if
provided) has switched off.
Thanks to the efficient lid seal, the appliance lid will not re-
open easily immediately after closing. Wait a few minutes
before re-opening the lid of the appliance.
Temperature Adjustment
Use the thermostat to select the ideal storage temperature. To
adjust the internal temperature, proceed as follows:
Turn the thermostat knob to 1 for a storage temperature
that is less cold.
Turn the thermostat knob to 6 / for a colder storage
temperature.
For partial loads, or when the load indicator is below the "e"
symbol inside the appliance, it is advisable to move the
thermostat to the lower position (on "e", if present on the
thermostat scale)
CO Big
Climatic Class Amb. T. (°C) Amb. T. (°F)
SN From 10 to 32 From 50 to 90
N From 16 to 32 From 61 to 90
ST From 16 to 38 From 61 to 100
T From 16 to 43 From 61 to 110
. 5019 613 01124/B


Produkt Specifikationer

Mærke: Whirlpool
Kategori: Fryser
Model: AFG 6516-B WP

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool AFG 6516-B WP stil et spørgsmål nedenfor, og andre brugere vil svare dig




Fryser Whirlpool Manualer

Fryser Manualer

Nyeste Fryser Manualer