Whirlpool FFT D 8X3B EE Manual

Whirlpool Tørretumbler FFT D 8X3B EE

Læs nedenfor 📖 manual på dansk for Whirlpool FFT D 8X3B EE (24 sider) i kategorien Tørretumbler. Denne guide var nyttig for 7 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/24
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance,
please register your product on
www.whirlpool.eu/register
EN
PLEASE SCAN THE QR CODE ON YOUR APPLIANCE IN ORDER TO REACH MORE INFORMATION.
Quick guide
Before using the appliance carefully
read the Safety Instruction.
Eco Monitor
This indicator shows the energy consumption level according to
the programme and the options set. The consumption is
proportional to the lines on the display,by the ecomonitor icon.
DAILY USE
Doing this will keep your machine working at its BEST:
- remember to empty your water tank after each drying
cycle.
- remember to clean your lters after each drying cycle.
Refer to the Care & Maintenance section.
1. Plug the dryer into the power supply socket.
2. Open the door and load garments; always refer to instructions on
clothing labels and the max loads indicated in the programme
section. Empty pockets. Make sure garments do not get caught
between the door and/or the door lter. Do not load items that
are dripping wet. Do not tumble dry large, very bulky items. For
optimal drying result, garments should be loaded one by one.
3. Close the door.
4. Press the "On/O" button.
5. Select the most suitable programme
for the type of fabric in
that load.
6. Select the options, if necessary.
7. Press the "
Start/Pause"
button to begin drying.
8. At the end of the drying cycle, a buzzer will beep. An indicator on
the control panel signals the end of the cycle. Turn the machine
o by pressing the "On/O" button, open the door and pull the
clothing immediately out to prevent the formation of creases on
laundry.
If the machine is not switched o manually, after about a quarter
of an hour from the end of the cycle , the appliance turns o
automatically to save energy.
Note that some models perform a nal cool tumble phase, for this
reason the fabrics may not feel hot.
In case of power failure, it is necessary to press the "Start/Pause"
button to restart the cycle.
CARE LABEL
Always check the care labels, especially when placing garments in
the tumble dryer for the  rst time. Below are the most commonly
used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
NAVIGATION
The " " and " " buttons serve to navigate the available UP DOWN
menus.
Press the button to conrm the selection.
Press the option button at the symbol , where present on the
display, to return to the previous screen.
If no selection is conrmed, after about 10 seconds, the display
return to the main screen.
SETTINGS
To access the settings menu, keep the relevant button pressed for
some seconds.
Set language shows the available languages on the display.
Sounds allows to enable or disable the sounds (some sounds, as
warnings, will remain active anyway).
Brightness allows to modify the display brightness.
Factory Default allows to reset the default settings. After having
selected the setting, keep the button pressed for some
seconds.
Opening the door during the cycle
The tumble dryer door can be opened at any time during the cycle
to check progress and remove any garments already dry.
However, since opening the door can extend the drying time, the
recommendation is to keep the door closed throughout the cycle
process to save time and energy.
After closing the door, press the "Start/Pause" button within 15
minutes to resume the machine operation.
INDICATORS
Dryness level: Iron dry - Hanger dry - Cupboard dry - Extra dry
Cycle phase: Drying - Cool down - End of cycle.
Empty water tank - Clean door lter - Clean bottom lter - Eco Monitor
Refer to troubleshooting section: Failure: Call after sales service
FIRST TIME USE
When starting the appliance for the rst time, the control panel
will show the set language menu automatically. The UP and
DOWN buttons serve to show the languages available in the
machine. Press the button to conrm. The machine cannot
be used without having selected the language. Make sure that
the water tank is correctly inserted. Make sure that the drain
hose on the back of the dryer is xed correctly, either to the
dryer’s water tank, or to your domestic sewage system.
The dryer must be installed in ambient with a temperature
range between 5-35 °C to ensure its operation.
Before you use your dryer ensure that it has been in a upright
position for at least 6 hours.
CONTROL PANEL
1 On/O button
2 Start/Pause button
Options Buttons
3 FreshCare+
4 Rapid (Add Favourite if long pressed)
5 Cycle Options (Setting if long pressed)
6 Dryness Level
7 Timed Drying
8 Start Delay
Navigation buttons and Key Lock
9 UP
10 DOWN'
11 CONFIRM (Key Lock if long pressed)
3
4
5
9
10
11
SYNTHETICS
1:35
-:-- -:--
6 7 8
1
2


Produkt Specifikationer

Mærke: Whirlpool
Kategori: Tørretumbler
Model: FFT D 8X3B EE

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool FFT D 8X3B EE stil et spørgsmål nedenfor, og andre brugere vil svare dig




Tørretumbler Whirlpool Manualer

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

BEKO

BEKO BM3T39232CW Manual

21 November 2024
Faure

Faure FDH7334PZ Manual

21 November 2024
Faure

Faure FDP7206PZ Manual

21 November 2024
Nabo

Nabo TK 7001 Manual

21 November 2024
Smeg

Smeg SACD7 Manual

20 November 2024
SanGiorgio

SanGiorgio SDR9P Manual

20 November 2024
SanGiorgio

SanGiorgio SDR8P Manual

20 November 2024
Miele

Miele TDD 130 WP Manual

16 November 2024
AEG

AEG TR8G82OW Manual

16 November 2024
Electrolux

Electrolux EDI621B85B Manual

15 November 2024