Whirlpool W6 D93WB EE Manual

Whirlpool Tørretumbler W6 D93WB EE

Læs nedenfor 📖 manual på dansk for Whirlpool W6 D93WB EE (20 sider) i kategorien Tørretumbler. Denne guide var nyttig for 7 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/20
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance, please
register your product on www.whirlpool.eu/register
EN
Quick guide
Before using the appliance carefully read the Safety
Instruction.
Eco Monitor
This indicator shows the energy consumption level according to
the programme and the options set. The consumption is
proportional to the lines on the display, by the ecomonitor icon.
OPENING THE DOOR DURING THE CYCLE
Laundry can be checked while the drying cycle runs and any
garments already dry can be removed, while drying continues for
the remaining items. After closing the door, press the "Start/Pause"
button to resume machine operation.
Keep the door closed until the cycle end to save time and energy.
NAVIGATION
The " " and " " buttons are used to navigate the available UP DOWN
menus.
Press the button to conrm the selection.
Press the option button at the symbol, where present on the
display, to return to the previous screen.
If no selection is conrmed, after about 10 seconds, the display
return to the main screen.
SETTINGS
To access the Settings menu, press and hold the relevant button for a
few seconds.
Set language shows the available languages on the display.
Sounds allows to enable or disable the sounds (some sounds, as
warnings, will remain active anyway).
Brightness allows to modify the display brightness.
Factory Default allows to reset the default settings. After having
selected the setting, press and hold the button for a few
seconds.
FIRST TIME USE
When starting the appliance the rst time, the control panel will
automatically show the set language menu. The UP and DOWN
buttons are used to show the languages available in the
machine. Press the to conrm. The machine cannot button
be used without having selected the language.
Make sure that the water tank is correctly inserted.
The dryer must be installed in a room with a temperature
ranging between 5°C and 35°C to ensure proper operation.
Before using the dryer make sure it has been in an upright
position for at least 6 hours.
Should you wish to change the opening side of the door, please
contact our After-sales Service. (See phone number in the
warranty booklet).
DAILY USE
Doing this will keep your machine working at its BEST:
- remember to empty your water tank after each drying
cycle.
- remember to clean yourlters after each drying cycle.
Refer to the Care & Maintenance section.
1. Plug the dryer into the power supply socket.
2. Open the door and load garments; always refer to instructions on
clothing labels and the max loads indicated in the programme
section. Empty pockets. Make sure garments do not get caught
between the door and/or the door lter. Do not load items that
are dripping wet. Do not tumble dry large, very bulky items.
3. Close the door.
4. Press the "On/O" button.
5. Select the most suitable programme
for the type of fabric in
that load.
6. Select the options, if necessary.
7. Press the "
Start/Pause"
button to begin drying.
8. At the end of the drying cycle, a buzzer will beep. An indicator on
the control panel signals the end of the cycle. Pull the load out
immediately to prevent the formation of creases on laundry.
9. Turn the machine o by pressing the "On/O" button, open the
door and pull the clothing out. If the machine is not switched o
manually, after about a quarter of an hour from the end of the
cycle , the appliance turns o automatically to save energy.
Note that some programme/option accords with "Crease Care"
system. This means that for some hours, after the end of the
drying cycle, the drum rotates at regular intervals to prevent the
formation of creases.
In case of power failure, it is necessary to press the "Start/Pause"
button to restart the cycle.
CARE LABEL
Always check the care labels, especially when placing garments in
the tumble dryer for the  rst time. Below are the most commonly
used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
INDICATORS
Cycle phase: Drying - Cool Down
Empty water tank - Clean secondary lter - door - Clogged lters Autoclean - Eco Monitor
Refer to Troubleshooting section: Failure call After-sales Service -
DEMO
Demo Mode
CONTROL PANEL
1 Programme selection knob
2 On/O button
3 Start/Pause button
Options buttons
4 FreshCare+
5 Cycle End Signal
6 Rapid
7 Cycle Options (hold for Settings)
8 Dryness Level
9 Timed Drying
10 Start Delay
Navigation buttons and Key Lock
11 UP
12 DOWN
13 CONFIRM (hold for Key Lock)
1
SYNTHETICS
1:35
-:-- -:--
5
6
7
11
12
13
2
3
4
8 9 10


Produkt Specifikationer

Mærke: Whirlpool
Kategori: Tørretumbler
Model: W6 D93WB EE

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool W6 D93WB EE stil et spørgsmål nedenfor, og andre brugere vil svare dig




Tørretumbler Whirlpool Manualer

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

Faure

Faure FDH7334PZ Manual

21 November 2024
Faure

Faure FDP7206PZ Manual

21 November 2024
Nabo

Nabo TK 7001 Manual

21 November 2024
Smeg

Smeg SACD7 Manual

20 November 2024
SanGiorgio

SanGiorgio SDR9P Manual

20 November 2024
SanGiorgio

SanGiorgio SDR8P Manual

20 November 2024
Miele

Miele TDD 130 WP Manual

16 November 2024
AEG

AEG TR8G82OW Manual

16 November 2024
Electrolux

Electrolux EDI621B85B Manual

15 November 2024
Constructa

Constructa CWK6B200 Manual

15 November 2024