Whirlpool W7 D94WB CS Manual

Whirlpool Tørretumbler W7 D94WB CS

Læs nedenfor 📖 manual på dansk for Whirlpool W7 D94WB CS (12 sider) i kategorien Tørretumbler. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/12
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance,
please register your product on
www.whirlpool.eu/register
EN
PLEASE SCAN THE QR CODE ON YOUR APPLIANCE IN ORDER TO REACH MORE INFORMATION.
Quick guide
Before using the appliance carefully
read the Safety Instruction.
CARE LABEL
Always check the care labels, especially when placing garments in
the tumble dryer for the  rst time. Below are the most commonly
used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
NAVIGATION
The " " and " " buttons are used to navigate the available UP DOWN
menus.
Press the button to conrm the selection.
Press the option button at the symbol, where present on the
display, to return to the previous screen.
If no selection is conrmed, after about 10 seconds, the display
return to the main screen.
SETTINGS
To access the Settings menu, press and hold the relevant button for
a few seconds.
Set language shows the available languages on the display.
Sounds allows to enable or disable the sounds (some sounds, as
warnings, will remain active anyway).
Brightness allows to modify the display brightness.
Factory Default allows to reset the default settings. After having
selected the setting, press and hold the button for a few
seconds.
FIRST TIME USE
When starting the appliance the rst time, the control panel
will automatically show the set language menu. The UP and
DOWN buttons are used to show the languages available in
the machine. Press the button to conrm. The machine
cannot be used without having selected the language.
Make sure that the water tank is correctly inserted.
The dryer must be installed in a room with a temperature
ranging between 5°C and 35°C to ensure proper operation.
Before using the dryer make sure it has been in an upright
position for at least 6 hours. Should you wish to change the
opening side of the door, please contact our After-sales
Service. (See phone number in the warranty booklet).
DAILY USE
Doing this will keep your machine working at its BEST:
- remember to empty your water tank after each drying cycle.
- remember to clean your lters after each drying cycle.
Refer to the Care & Maintenance section.
1. Plug the dryer into the power supply socket.
2. Open the door and load garments; always refer to instructions on
clothing labels and the max loads indicated in the programme
section. Empty pockets. Make sure garments do not get caught
between the door and/or the doorlter. Do not load items that
are dripping wet. Do not tumble dry large, very bulky items. For
optimal drying result, garments should be loaded one by one.
3. Close the door.
4. Press the "On/O" button.
5. Select the most suitable programme
for the type of fabric in
that load.
6. Select the options, if necessary.
7. Press the "
Start/Pause"
button to begin drying.
8. At the end of the drying cycle, a buzzer will beep. An indicator
on the control panel signals the end of the cycle. Turn the
machine o by pressing the "On/O" button, open the door and
pull the clothing immediately out to prevent the formation of
creases on laundry.
If the machine is not switched o manually, after about a quarter
of an hour from the end of the cycle , the appliance turns o
automatically to save energy.
Note that some models perform a nal cool tumble phase, for this
reason the fabrics may not feel hot.
In case of power failure, it is necessary to press the "Start/Pause"
button to restart the cycle.
Eco Monitor
This indicator shows the energy consumption level according to
the programme and the options set. The consumption is
proportional to the lines on the display, by the ecomonitor icon.
Opening the door during the cycle
The tumble dryer door can be opened at any time during the cycle
to check progress and remove any garments already dry.
However, since opening the door can extend the drying time, the
recommendation is to keep the door closed throughout the cycle
process to save time and energy.
After closing the door, press the "Start/Pause" button within 15
minutes to resume the machine operation.
NOTE: in any case, the drying cycle must be completed to ensure
the condenser auto-cleaning phase is nalized.
INDICATORS
Cycle phase: Drying - Cool Down
Empty water tank - Clean secondary lter - door - Clogged lters Autoclean - Eco Monitor
Refer to Troubleshooting section: Failure call After-sales Service
CONTROL PANEL
1 Programme selection knob
2 On/O button
3 Start/Pause button
Options buttons
4 FreshCare+
5 Cycle End Signal
6 Rapid
7 Cycle Options (hold for Settings)
8 Dryness Level
9 Timed Drying
10 Start Delay
Navigation buttons and Key Lock
11 UP
12 DOWN
13 CONFIRM (hold for Key Lock)
1
SYNTHETICS
1:35
-:-- -:--
5
6
7
11
12
13
2
3
4
8 9 10


Produkt Specifikationer

Mærke: Whirlpool
Kategori: Tørretumbler
Model: W7 D94WB CS

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool W7 D94WB CS stil et spørgsmål nedenfor, og andre brugere vil svare dig




Tørretumbler Whirlpool Manualer

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

GE

GE GTX33 Manual

1 December 2024
GE

GE GFDS170 Manual

1 December 2024
GE

GE DDG9580R Manual

1 December 2024
GE

GE GFDS175 Manual

1 December 2024
GE

GE HTX26GASWWS Manual

26 November 2024
Vivax

Vivax CDR-0816SHP Manual

24 November 2024
Orima

Orima ORC-82 Manual

24 November 2024
Orima

Orima ORBC-83 Manual

24 November 2024
GE

GE GTDX400EDWS Manual

24 November 2024