Whirlpool WED6605MW Manual

Whirlpool Tørretumbler WED6605MW

Læs nedenfor 📖 manual på dansk for Whirlpool WED6605MW (2 sider) i kategorien Tørretumbler. Denne guide var nyttig for 17 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

Dryer Quick Start Guide

OPERATING INSTRUCTIONS

WARNING

Fire Hazar d

No washer can completely remove oil.

Do not dry anything that h as ever had any type of oil

on it (including cooking oils).

Items containing foam, rubber, or plastic must be

dried on a clothesline or by using an Air Cycle.

Failure to follow these instructions can result in

death or fi re.

WARNING

Expl o sion Hazard

Keep flammable materials and vapors, such as

gasoline, away from dryer.

Do not dry anything that has ever had anything

flammable on it (even after washing).

Failure to follow these instructions can result in

death, explosion, or fire.

WARNING: To reduce the risk of fire, electric shock, or injury to persons,

read the IMPORTANT SAFETY INSTRUCTIONS, located in your

appliance's Owner's Manual, before operating this appliance.

Step 1. Clea n Lint Screen

Step 2. Load Clothes; then Close

Door

Step 3. Power On/Cancel

Step 4. Select Cycle and Settings

Step 5. Press Start/Pause

Cycle Guide - Normal Cycle

This dryer has a unique user interface to help you select the best cycle you need for your load. The "What to Dry"

"How to Dry" layout guides you to the optimal cycl e in two easy steps: First determine what items are in the load

that you are trying to dry. Use that to guide your "What to Dry" selection. Then determine how you want the dryer to

dry them and select the appropriate "How to Dry" selection. Modifiers are preset for t he items being dried, but can

be changed if desired.

To get the most energy savings and enhanced fabric care from your dryer, use the Automatic cycles. These cycles

measure the drying air temperature and moisture levels to turn the dryer off once the load reaches the selected

dryness level. Dryer performance and results may vary with service voltage less than 240.

Items to Dry: “What to Dry”: “How to Dry”: Description:

Baby clothes,

Blankets, Cotton

undergarments,

Colored napkins

Regular

Bulky Items

Whites

Sheets

Colors

Normal Automatic Sensor cycle stops when dryness level

is reached.

See online “Cycle Guide” for details.

NOTE: Government energy certifications for this model were based on the Regular + Normal Cycle, Highest

temperature setting, Normal Dryness Level, EcoBoost ™On. The as-shipped defaults were the same as the

Government Energy Certification Settings except the default Temperature Setting of Medium was adjusted to the

Highest temperature setting.

Online Ordering Information

For detailed installation instruction and maintenance information, winter storage, and transportation tips, please

see the Owner’s Manual included with your machine.

For information on any of the following items, a full cycle guide, detailed product dimensions, or for complete

instructions for use and installation, please visit https://www.whirlpool.com/owners, or in Canada

https://www.whirlpool.ca/owners. This may save you the cost of a service call.

However, if you need to contact us, use the information listed below for the appropriate region.

United States:

1–800–253–1301

Whirlpool Brand Home Appliances

Customer eXperience Center

553 Benson Road

Benton Harbor, MI 49022–2692

Canada:

1–800–807–6777

Whirlpool Brand Home Appliances

Customer eXperience Centre

200–6750 Century Ave.

Mississauga, Ontario L5N 0B7

Button Descriptions

1. POWER/CANCEL

Touch to turn the dryer on and off. Touch to stop/cancel a cycle at any time.

2. WHAT TO DRY/HOW TO DRY

Once a “What to Dry” is selected, the dryer automatically selects t he

recommended or l ast-used “How to Dry” option, as well as the recommended/

last-used modifiers. Both the “How to Dry” and modifiers can be changed if

desired. See the online “Cycle Guide” for details.

3. START/PAUSE

Touch and hold until LED counts down “3-2-1” and the dryer starts; then let go

to start a cycle, or touch once while a cycle is in process to pause it.

4. MODIFIERS

Use to select available modifiers for your dryer. Not all cyc les and options are

available on all models. See the online “Cycle Guide” for details.

Temp

When using Timed Dry/Quick Cycle, you may s elect a dry temperature based

on the type of load you are drying. Use the warmest setting that is safe for the

garments in the load. Follow garment label instructions.

Not all features, cycles, and options are available on all models. Appearance may vary.

NOTE: The control panel features a sensitive surface that responds to a light touch of your finger. To ensure your selections are registered, touch the control

panel with your finger tip, not your fingernail. When selecting a setting or option, simply touch its name.

NOTE: Automatic Cycles will give you up to 4 temperatures to adjust,

depending on the “What to Dry” or “How to Dry” selections that have been

made.

Dryness

You may adjust the Dryness on Automatic Cycles (except for the Sanitize

cycle), if desired.

NOTE: Dryness is for use with Automatic Cycles only.

More Time/Less Time

Touch More Time or Less Time with Timed Dry/Quick Dry Cycles to increase

or decrease the length of the cycle.

5. OPTIONS

Use to select available options for y our dryer. Not all cycles and options are

available on all models.

Wrinkle Shield™ Option

If you will be unable to remove a load immediately, touch Wrinkle Shield™ to

add up to 150 minutes of periodic tumbling to help reduce wrinkling. You may

select the “+ Steam” setting (on some models only) to add a short steam

cycle after 60 minutes to help smooth out wrinkles.

NOTE:If you open the dryer door prior to the end of the Wrinkle Shield ™

option, the dryer will pause.

Steam Refresh (steam models only)

This cycle is best for reducing wrinkles and odors from dry items. Cycl e time

will increase, depending on number of items. This is an independent cycl e

that cannot be combined with any other cycle.

Cycle Signal

Use this to turn the signal indicating the end of a drying cycle to low, medium,

high, or off. The volume you select here will also be applied to the Damp Dry

Signal.

NOTE: You may also turn off the tones that sound when a feature, setting, or

option is touched. Touch and hold Cycle Signal for about 3 seconds to turn

sounds to low, medium, high, or off.

Damp Dry Signal

Touch to select the Damp Dry Signal on or off. When selected, a series of

beeps will sound when the load is damp, but not completely dry. This will

allow you to take clothes out of the load that do not need to dry completely.

The Damp Dry Signal is selected as a default for the Bulky Items cycles, as a

reminder t o manually reposition bulky loads midway through the cycle. This

option is not available for all cycles. See the online “Cycle Guide” for details.

Reduce Static (on some models)

Touch to add this option to selected Automatic Cycles. The dryer will

automatically tumble, pause, and introduce a small amount of moisture into

the load to help reduce static. This option adds approximately 3 minutes to

the total cycle time

Control Lock

Use this option to lock the controls of the dryer and avoid an accidental

change in cycle options or preferences during a drying cycle. Touch and hold

Control Lock or Damp Dry Signal (depending on the model) for 3 seconds to

lock or unlock the controls of the dryer. During this time, the LED Display will

count down “3-2-1.” Once the controls are locked, the LED Display will display

“Loc.”

NOTE: The Control Lock function may be enabled when recovering from a

power failure. To unlock the control, touch and hold Control Lock or Damp Dry

Signal (depending on the model) for at least 3 seconds.

EcoBoost™ Option

The EcoBoost™ option will default on only for the Regular/Normal cycle and

is only available on that cycle. This option allows you to increase your energy

savings by using a slightly lower heat level. The EcoBoost™ option will

increase drying times by approximately 40 minutes, which will be reflected on

the LED display. If optimal time is desired, touch ECOBOOST to turn off this

option.

6. LED DISPLAY

When you select a cy cle, its default settings will light up and the estimated

time remaining (for Automatic Cycles) will vary depending on “What to Dry”

and “How to Dry” selections or act ual time remaining for Timed Dry cycles (for

Manual Cycles) will be displayed.

CYCLE STATUS

The Cycle Status indicators show the progress of a cycle. Not all indicators are

available on all models.

Sensing

The Sensing indicator will light periodically during Sensor Cycles to indicate that the

moist ure sensor on the dryer is operating. This indicator will not light during Timed

Cycles or options such as Wrinkle Shield™.

Wet

The load is still wet and/or the cy cle just started.

Damp

This indicator shows that the load is partially dried and items that you may wish to

hang up or iron while still damp may be removed.

Cool Down

The dryer has finished drying with heat and is now tumbling the load without heat to

cool it down and reduce wrinkling.

Check Vent

The Check Vent indicator is a feature available for Automatic Cycles only. This

indicator will show the status of airflow through the dryer and the dryer v ent system for

the dryer’s life. During the sensing phase at the beginning of the cycle, the Check Vent

light will come on if a blocked vent or low airflow issue is detected. This light will stay

on for the entire cycle. Should the Check Vent light illuminate, refer to the online

“Troubleshooting” section for potential solutions to the issue.

The light will be cleared upon completion of the cycle, touching Power, or opening the

door. The Check Vent light will continue to illuminate during the cycl e unless the root

cause is resolved.

NOTE: The dryer will continue to operate even while the indicator is lit, but poor

airflow can impact dry times and overall performance. See “Check Your Vent System

for Good Airflow” in the Owner’s Manual.

NOTE: If there are other error issues during a cycle, the Check Vent indicator will not

light up. See the online “Troubleshooting” section.

End

This will indicate that the selected cycle has ended and the load may be removed from

the dryer. If Wrinkle Shield ™has been selected, the dryer may continue to tumble the

load, even if “End” is displayed.

Control Lock

This will illuminate once the controls are locked.

W11355749A

W11355965A-SP

Produkt Specifikationer

Mærke:	Whirlpool
Kategori:	Tørretumbler
Model:	WED6605MW

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool WED6605MW stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Tørretumbler Whirlpool Manualer

Whirlpool awz 8813 Manual

18 December 2024

Whirlpool W7 D93WB Manual

9 December 2024

Whirlpool ST U 93E EU Manual

8 December 2024

Whirlpool FFT M11 82 SPT Manual

8 December 2024

Whirlpool FFT CM11 8XB FR Manual

8 December 2024

Whirlpool FFT M11 8X3B IT Manual

8 December 2024

Whirlpool FFT M11 9X2BY EE Manual

8 December 2024

Whirlpool FFT M11 8X3 EE Manual

8 December 2024

Whirlpool FFT M11 82 IT Manual

8 December 2024

Whirlpool FFTN M11 82 IT Manual

4 December 2024

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

LG RH90V9ZVEN Manual

19 December 2024

LG TD-C70030EB Manual

19 December 2024

LG RH80V5AV0N Manual

19 December 2024

Bosch WTN832M1NL Manual

18 December 2024

Altus ADP80W Manual

17 December 2024

Ufesa Pro Ionic Style Manual

17 December 2024

Ufesa Pro Ionic-Shine Manual

17 December 2024

Haier HD100-A3959E-IT Manual

17 December 2024

Haier HD110-A3959E-IT Manual

17 December 2024

Haier HD100-A3959RE-IT Manual

17 December 2024