Whirlpool WNF 711 E X Manual

Whirlpool Køleskab WNF 711 E X

Læs nedenfor 📖 manual på dansk for Whirlpool WNF 711 E X (12 sider) i kategorien Køleskab. Denne guide var nyttig for 12 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/12
EN
Quick guide
* Available only on certain models
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT
In order to receive a more complete assistance, please
register your product on www . whirlpool . eu/ register
Before using the appliance carefully read the Safety
Instruction.
FIRST TIME USE
After installation, wait at least two hours before connecting the
appliance to the power supply. Once connected, it will start working
automatically. The ideal temperature settings are preset from the
factory.
After turning the appliance on, wait 4-6 hours for it to reach the correct
food storage temperature.
CONTROL PANEL
1. Indicator Leds (to display the current temperature set point or the
Fast Cooling function)
2. On/Stand-By Button / Temperature Button
ON/STAND BY
To put the product in Stand-by, press and hold the On/Stand-By button
for more than 3 seconds.
Press again to reactivate the appliance.
TEMPERATURE SETTING
Press the Temperature button on the control panel to adjust the
temperature from the warmest through the lower to the coldest
level. Pressing the Temperature button, the temperature setting will
change cyclically. At rst plug-in of appliance temperature setpoint is
present at medium position (factory setting). Following table shows
temperature setpoints:
OFF ON
High temp.
Med-high temp.
Medium temp.
Med-low temp.
Low temp.
Fast Cooling
Recommended setting:
• Refrigerator compartment: +C or MED
• Freezer compartment: -1C or -20°C
Note: Displayed set points correspond to the average temperature
throughout the whole refrigerator.
FAST COOLING
The use of this function is recommended when placing a very high
quantity of food to be frozen in the freezer compartment.
24 hours before freezing fresh food, press and hold for 3 seconds the
Fast Cooling button / Temperature button on the control panel till all
the 3 LEDs will turn on, to activate the Fast Cooling function.
After 24 hours place the food to be frozen in the freezing zone drawer
of freezer compartment.
The function is automatically deactivated after 48 hours and return to
previous selected set point.
The function can be manually deactivated by pressing and holding for
3 seconds the Temperature button on the control panel.
LED LIGHT
This product contains a light source of energy eciency class G.
If the LED light system does not work, please contact the Service to
replace it.
Important: The refrigerator compartment light switches on when
the refrigerator door is opened. If the door is kept open for more than
8 minutes the light will be automatically switched o.
6TH SENSE
This function automatically works to ensure the optimal conditions
to preserve the stored food. The “6th Sense” function is automatically
activated when:
a large amount of food is loaded into the refrigerator
the refrigerator door is left open for a long time
a prolonged power failure takes place, causing the internal
temperature of the appliance to increase to values that cannot
guarantee safe storage of food.


Produkt Specifikationer

Mærke: Whirlpool
Kategori: Køleskab
Model: WNF 711 E X

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool WNF 711 E X stil et spørgsmål nedenfor, og andre brugere vil svare dig




Køleskab Whirlpool Manualer

Køleskab Manualer

Nyeste Køleskab Manualer

Faure

Faure FRA22800WA Manual

21 November 2024
Faure

Faure FRT23101XA Manual

21 November 2024
Faure

Faure FRT27103WA Manual

21 November 2024
Faure

Faure FRT27102XA Manual

21 November 2024
Faure

Faure FRT27102WA Manual

21 November 2024
Faure

Faure FRT27100WA Manual

21 November 2024
Eqtemp

Eqtemp ACR22GLHD Manual

20 November 2024
SanGiorgio

SanGiorgio SB54NFXD Manual

20 November 2024