Winix A230 Manual

Winix Luftrenser A230

Læs nedenfor 📖 manual på dansk for Winix A230 (2 sider) i kategorien Luftrenser. Denne guide var nyttig for 2 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

A231 / A 230

WHERE TO USE

MODEL PART DIAGRAM

12~18 in

Allow 12 ~ 18 in. of space between TVs, radios, and other electronics

Electromagnetic interference from certain electronics may cause

product malfunction.

Place indoors away from direct sunlight

Direct exposure may cause product malfunction or failure.

Only place on hard, flat surfaces

Flimsy or slanted surfaces may result in abnormal noise and vibrations.

Allow 12 ~ 18 in. from walls

For maximum air flow.

01. Filter Replacement Indicator

LED light indicates when it is time to change the filter.

02. Filter Reset Button

After replacing the 360º All-in-One True HEPA Filter, use a small object such as a paper clip, to press and hold the

Filter Reset Button for at least 5 seconds until the Filter Replacement Indicator turns off.

03. Auto Mode Button

The unit will default to Auto with PlasmaWave® enabled when first powered on.

•Auto Mode automatically adjusts fan speeds according to your indoor air quality. The fan speed will adjust

to low when air quality is good, medium when fair, and to high when poor.

CONTROL PANEL

04. Air Quality Indicator

Color coded LED light indicates one of three levels of Air Quality:

Red (poor), Amber (fair), and Blue (good).

05. Sleep Mode Button

When Sleep Mode is activated, the Air Quality Indicator LED light is disabled.

•Fan speed will automatically set to minimum speed (lower than 'Low') which will be nearly silent.

•When Sleep Mode is active, PlasmaWave® will be disabled, but it can be turned back on.

06. PlasmaWave

Button

Enables or disables PlasmaWave®

"When the unit is running, you may hear a chirping or buzzing sound. The sound is from large particles passing

through PlasmaWave®, it is normal and does not signify product failure."

Press the PlasmaWave® Technology button when the unit is on to enable or disable this feature.

07. Fan Speed Indicator Buttons

Indicates the current fan speed.

•Use the Fan Speed arrow buttons to set the desired fan speed. Fan speeds cycle over in this sequence:

Auto, Low, Medium, High, Auto.

Low Medium High

08. Power Button

Turns the unit on or off. During the first 30 seconds of power, the Air Quality Indicator will cycle through

Blue, Amber and Red colors.

•Odor Sensor takes approximately 4 minutes to detect the air quality in the environment before normal

operation begins.

When to Replace Filters

Filter Indicator L i ght When to ser vice When to replace

360º All-in-One

True HEPA Filter

Clean once every 14 days Lasts Approx. 12 months

•When the Check Filter indicator LED is on, it is time to replace the All-in-One True HEPA Filter.

•Intervals between filter replacement may vary depending on environment.

MAINTENANCE

Activated Carbon Filter

Fine Mesh Pre-Filter

True HEPA Filter

PlasmaWave

4-STAGE AIR PURIFICATION

01. Fine Mesh Pre-Filter

Designed to catch larger airborne particles found

indoors.

02. True HEPA Filter

Captures 99.97%* of airborne allergens including; pollen,

mold spores, dust, pet dander, microbes, and smoke

(*Particles as small as 0.3 microns in size).

03. Activated Carbon Filter

Reduces VOCs and household odors from cooking,

pets, and smoke.

04. PlasmaWave

PlamaWave creates Hydroxyls which can help to

reduce the presence of airborne Bacteria, Viruses*

(*Based on independent laboratory test conducted on

Influenza A Virus H3N2, E. coli, Pseudomonas aeruginosa,

Staphylococcus aureus, Salmonella typhimurium).

INITIAL OPERATION

1. Turn the product upside down.

2. Grab the handle at the bottom of the product, turn

counter-clockwise, and pull out the filter cover.

3. Remove the protective vinyl from the filter

installed inside the product.

4. Install the filter top side down into the bottom of unit

until it is fully inserted. The top of the filter shows the

opening and the bottom of the filter is solid.

5. After installing the filter, turn the handle clockwise

to close the filter cover.

6. Return the product to an upright position and

resume normal operation.

1712-0110-00

FILTER

After replacing a filter,

press the Filter Reset Button

for at least 5 seconds.

REPLACING FILTERS

CLEANING CARE

Cleaning the Filters:

Clean with a vacuum or a soft brush.

•Only clean the Pre-Filter.

•This filter be washed.CAN NOT

•Intervals between filter cleaning may vary

depending on the air quality.

N O T I C E

Do not use benzene, alcohol, or other volatile fluids,

which may cause damage or discoloration.

Cleaning the Exterior & Interior:

Wipe with a soft damp cloth using room temperature

water. Afterwards, wipe it down with a clean dry cloth.

After turning the product upside down, remove the filter

cover and clean the interior with a vacuum cleaner.

•For optimal performance, clean every 14 days.

N O T I C E

•When cleaning the unit, always unplug the power cord

first and then wait until the unit has cooled down.

•Never disassemble, repair, or modify this unit yourself.

•Do not use flammable sprays or liquid detergents.

•Do not allow children to clean or maintain the unit.

•Before cleaning or maintaining, ensure unit is unplugged.

Produkt Specifikationer

Mærke:	Winix
Kategori:	Luftrenser
Model:	A230

Har du brug for hjælp?

Hvis du har brug for hjælp til Winix A230 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Luftrenser Winix Manualer

Winix C545 Manual

6 November 2024

Winix AUS-5500 Manual

14 Oktober 2024

Winix Tower Q Manual

30 September 2024

Winix PlasmaWave WACP150 Manual

29 September 2024

Winix A231 Manual

27 September 2024

Winix U300EU Manual

23 August 2024

Winix P300UK Manual

22 August 2024

Winix ZERO+ AUS-1050AZBU Manual

22 August 2024

Winix P450EU Manual

19 August 2024

Winix NK305 - Tower Q Manual

12 August 2024

Luftrenser Manualer

Nyeste Luftrenser Manualer

Electrolux USK10 Manual

22 December 2024

Electrolux Flow A3 UV Manual

21 December 2024

Philips AC2891 Manual

21 December 2024

Philips AC9008/00 Manual

21 December 2024

Philips AC4005 Manual

21 December 2024

Meaco 12L - Low Energy Manual

18 December 2024

Philco Air 4 Manual

16 December 2024

Sharp FU-888SV Manual

15 December 2024

Shark NeverChange5 HP150 Manual

14 December 2024

Mitsubishi MA-83H-W Manual

14 December 2024