Zephyr ZRC-00MI Manual

Zephyr Emhætte ZRC-00MI

Læs nedenfor 📖 manual på dansk for Zephyr ZRC-00MI (76 sider) i kategorien Emhætte. Denne guide var nyttig for 4 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/76
WWW.ZEPHYRONLINE.COM
NOV20.0101
Airow Control Technology
TM
C
Milano
ZMI-M90CS, ZMI-M90CG
EN Use, Care, and Installation Guide
FR Guide d’utilisation, d’entretien et d’installation
3
Milano Use, Care, and Installation Guide
ZEPHYRONLINE.COM
Contents
Page
Safety Information ............................................................................ 4-6
Types of Safety Warnings ................................................................... 4
General Safety ..................................................................................4-5
Operation ........................................................................................... 6
Electrical Requirements ...................................................................... 6
Federal Communication Commission Interface Statement ................. 6
List of Materials ................................................................................... 7
Installation Instructions .....................................................................8-17
Ducting Calculation Sheet .................................................................. 8
Mounting Height, Clearance, & Ducting ...........................................9-10
Ducting Options ................................................................................. 11
Hood Specifications ............................................................................12
Electrical Supply .................................................................................13
Cable Lock .........................................................................................13
Mounting the Hood .......................................................................... 14-15
Ductless Recirculation ..................................................................... 16-17
Features & Controls ..........................................................................18-24
Proximity Controls ...........................................................................18-20
Zephyr Connect .............................................................................. 21-22
Optional RF Remote Control ............................................................23-24
Maintenance ................................................................................... 25-27
Hood & Filter Cleaning .....................................................................25-26
LumiLight LED ................................................................................... 27
ACT™ Conversion ............................................................................ 28-30
Airflow Control Technology (ACT™) ................................................... 28
Enabling ACT™ ................................................................................29-30
Wiring Diagram .................................................................................. 31
Troubleshooting............................................................................... 32-34
List of Parts & Accessories .................................................................. 35
Notes .................................................................................................. 36
Limited Warranty ............................................................................... 37
Product Registration ........................................................................... 38
14 Milano Use, Care, and Installation Guide
M I L A N O
WA L L
C O R E
Installation Instructions
Mounting the Hood
At least two installers are required due to the
weight and size of the hood.
CAUTION
1. Measure from range top to hood bottom and
mark line A. (24” minimum from range top).
2. Plum and mark center line.
3. Mark mounting height line B. (18-5/8” from line
A).
4. Mark mounting spread from C/L. (11-1/4”).
5. Fasten (2) #6 x 1-1/2” screws into studs on line B
but do not tighten all the way.
Wood blocking may need to be added behind
the drywall if no studs are present. Wall anchors
may also be used but check local codes for
compliance. Failure to use suitable wall anchors
and screws to hold the weight of the hood could
result in personal injury or damage to cooking
surface or counter.
WARNING
FIG. B
Brackets are
pre-installed
2
24” min.
1
11-1/4”
C/L
C/L
B
A
18-5/8”
Duct Cover
Bracket
6. Remove tape and (2) screws securing electronics mounting bracket to hood. Reposition electronics
mounting bracket as shown in (FIG. A3) and secure to motor housing using the (2) previously
removed screws.
7. Remove (2) screws securing electrical junction box to electronics mounting plate. Remove junction
box. (FIG. A1).
8. Remove the (1) aluminum mesh filter.
15
Milano Use, Care, and Installation Guide
ZEPHYRONLINE.COM
Installation Instructions
9. Hang hood onto the mounting screws and hand tighten each screw. (FIG. B1) Secure the third #6 x
1-1/2” screw through inside of hood into wall for extra support. (FIG. B2).
10. Center and attach duct cover mounting bracket to wall just below the ceiling or sot using (2) #6
x 1” screws.
11. Install electrical and duct work. Seal duct work with aluminum duct tape. Re-install electrical
junction box with cable lock and install the electrical. (FIG. A2).
12. Unwrap the blue antenna wire and position it behind the duct cover from step 14. There is no need
to secure it.
13. Power up hood and check for leaks around duct tape.
14. Place telescopic duct covers onto hood and extend inner (top) duct cover upwards and secure to
duct cover bracket using (2) M3.5 x 8 screws.
15. Place canopy over hood body and secure it to hood body using (4) 3/16 x 1/4 screws through filter
opening. Hand tighten screws only.
16. Reinstall aluminum mesh filter.
NOTE: If using hood in recirculating mode you must secure the air diverter plate onto wall before
installing duct work and duct covers. Turn to page 19 for more details.
Mounting the Hood
17
Milano Use, Care, and Installation Guide
ZEPHYRONLINE.COM
Installation Instructions
5. Enable recirculating mode on the proximity
controls. (Refer details to pg. 20)
6. Charcoal filters must be replaced after every
200 hours of use (or approximately every 3 to 6
months based on the average of 1 - 2 hours of
daily cooking time). After 200 hours of use, the
notification bell icon will display. When the bell
is tapped, the LCD display will cycle between
showing “REPLACE CHARCOAL FILTER” and
“HOLD UP TO RESET” every 2 seconds.
Charcoal Filter Replacements
Hood Model Part Number Quantity to
Order
ZMI-M90CS Z0F-C002 2
ZMI-M90CG Z0F-C002 2
DO NOT WASH CHARCOAL FILTERS. Charcoal
filters may need to be changed more often
depending on cooking habits.
FIG. C


Produkt Specifikationer

Mærke: Zephyr
Kategori: Emhætte
Model: ZRC-00MI

Har du brug for hjælp?

Hvis du har brug for hjælp til Zephyr ZRC-00MI stil et spørgsmål nedenfor, og andre brugere vil svare dig




Emhætte Zephyr Manualer

Zephyr

Zephyr AK0722 Manual

12 December 2024
Zephyr

Zephyr ZRC-01AN Manual

11 December 2024
Zephyr

Zephyr AK0860AS Manual

11 December 2024
Zephyr

Zephyr AK0736BS Manual

11 December 2024
Zephyr

Zephyr ZRC-01OM Manual

11 December 2024
Zephyr

Zephyr AK0754BS Manual

11 December 2024
Zephyr

Zephyr BRC-0007 Manual

11 December 2024
Zephyr

Zephyr ZRC-00RE Manual

11 December 2024

Emhætte Manualer

Nyeste Emhætte Manualer

Pando

Pando E-217 Manual

5 Januar 2025
Pando

Pando E-245 Manual

5 Januar 2025
Trade-Wind

Trade-Wind 7254 Manual

5 Januar 2025
BEKO

BEKO HCA92641WH Manual

5 Januar 2025
Pando

Pando E-240 Manual

5 Januar 2025
NuTone

NuTone NU230WW Manual

5 Januar 2025
NuTone

NuTone NU330SS Manual

5 Januar 2025
NuTone

NuTone NU330BL Manual

5 Januar 2025
BEKO

BEKO HNS 61212 WH Manual

5 Januar 2025