Acros AS8818A Manual

Acros Køleskab AS8818A

Læs nedenfor 📖 manual på dansk for Acros AS8818A (2 sider) i kategorien Køleskab. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

Dispensing water:

Press a container or a glass against the lever until the

desired level of water is completed.

The container to collect water retains any

drops that may fall while you are dispensing water.

Use a dry cloth to clean or dry the container to collect water.

Cleaning the tank:

Clean the tank frequently. For cleaning, never use the

dishwasher. Remove the water tank by turning it and

withdrawing it in the direction indicated in the ﬁ gure.

Support the tank and remove the lid.

Disengage the tip of the valve by turning it to the

left until you feel that the piece is loose.

Remove it and clean it carefully.

Use sponge or soft cloth moistened with

detergent or neutral soap. Rinse well

and dry with a clean dry cloth.

Important:

Do not remove the body of the

valve, indicated in the ﬁ gure.

Reﬁ lling the tank:

Fit and lock the valve again, as shown in the ﬁ gure.

Important:

Before replacing the tank, verify that the

valve is correctly installed.

Install the tank on the side hooks

and in the hole in the door.

Verify that the tank is ﬁ rmly installed.

Note the absence of spaces between the support

and the door.

Your refrigerator has a system that allows you to dispense cold water without

opening the door, thus avoiding excessive door openings, consequently,

reducing energy consumption.

Filling tank:

To ﬁ ll up water in the tank, turn the lid on and

ﬁ ll it with a jug. After ﬁ lling, close the funnel

cover, turning it to the initial (closed) position.

Important:

Exclusive use for water.

Any other liquid may cause malfunction of the product.

Only use potable water to ﬁ ll the tank.

The manufacturer is not responsible for damage caused to the system if the

tank is supplied with any other type of liquid other than water.

Adjust the refrigerator’s racks according to the way the refrigerator is used.

To remove the shelves:

1. Remove all items from the shelves.

2. Lift the top.

3. Slide the grill out.

To replace the shelves:

1. Ensure that the molding tab is positioned up,

according to the image.

2. Place the back of the shelf

on the rails located on the side walls.

3. Guide the front of the grill onto the rails.

4. Slide it in until it stops.

Procedure for cleaning doors and cabinets with signiﬁ cant rust stains:

Keep the refrigerator in a dry environment. As moisture builds up, the metal

rusts and rust will keep developing.

Manual cleaning method

Remove the shelf

Care of your refrigerator

To defrost, follow these instructions:

1. Press the button on the temperature control.

Defrost starts automatically.

2. Once the defrosting is complete, remove the meat tray and / or

defrost, empty the water and insert the tray again.

3. Thoroughly dry the freezer and the entire interior of the refrigerator with

a soft cloth.

4. The refrigerator, once the defrosting is ﬁ nished, will automatically work

again without having to re-select the temperature.

NOTE: Do not use sharp or pointy objects to

remove frost from the freezer.

This will damage the evaporator.

1. Moisten a

sponge in

water with

detergent.

2. Use the soft

surface of the

sponge to rub

over the rust

stain. The

rubbing should

be in the

same sense of

polishing.

3. Use the hard

surface to rub

over the rust

stain.

The rubbing

should be in the

same direction

of the grain.

4. Rinse the

sponge with

tap water until

the detergent is

removed.

5. Moisten the ﬁ ber

in water.

6. Dry the

surface of the

unit well with

the sponge.

7. Use a piece of

dry cloth and

rub on the wet

surface. It is

recommended

to use a

stainless steel

cleaner for a

shiny ﬁ nish.

A- Hard surface

B- Smooth

surface

Tools needed:

• Piece of dry cloth

• Soft / hard surface sponge

Water dispenser (some models)

Tank

Turn the funnel lid outwards to ﬁ ll the tank

Recipient to

collect water

Lever

VERY IMPORTANT

IT IS THE RESPONSIBILITY OF THE USER TO VERIFY THE FOLLOWING

INFORMATION BEFORE CALLING THE TECHNICIAN:

If you followed the instructions in the installation, use and care manual

correctly, and have questions about the operation of the refrigerator, this guide

offers solutions to problems you can detect and correct in your home.

IF THE REFRIGERATOR DOES NOT WORK

• Connect the plug directly, DO NOT USE CORD EXTENSIONS.

• Check the ELECTRICAL CONTACT, IT COULD BE DAMAGED, connect

another device and test if it works.

• Avoid starting several devices at the same time; THE ELECTRICAL

INSTALLATION MAY OVERLOAD.

• Verify that the TEMPERATURE CONTROL IS IN THE ON-OFF POSITION.

• Make sure the refrigerator is NOT NEXT TO A HEAT SOURCE such as an

oven, stove or direct sunlight.

• THE DOORS MUST CLOSE HERMETICALLY, check the magnetic gasket of

the doors.

• LEVEL THE REFRIGERATOR, remove the wooden bases and adjust the

leveling screws (ﬁ gure 1).

• DO NOT OVERLOAD THE REFRIGERATOR, the circulation of cold air will

be deﬁ cient.

• Set the TEMPERATURE control knob to MED (medium cold) and wait at least

24 hours before making a new temperature change.

THE REFRIGERATOR WORKS FOR EXTENDED PERIODS

• Check that the CONDENSER IS FREE OF DUST AND LINT (ﬁ gure 1)

• AVOID OPENING THE DOOR CONTINUOUSLY or for prolonged periods.

• DO NOT STORE HOT FOODS and keep them covered.

IF YOU HEAR STRANGE SOUNDS

•

Check that there are NO OBJECTS OVER OR BEHIND THE REFRIGERTOR.

• The COMPRESSOR DOES NOT WORK PROPERLY, it may be that a low

voltage is present, verify the intensity of the light, if it is low this indicates that

it has a low voltage, speak to your company of light to correct the power supply

(ﬁ gure 1).

Before calling the technician

MAGNETIC GASKET

LEVELING SCREWS

CONDENSER

COMPRESSOR

IF AFTER FOLLOWING

THESE INSTRUCTIONS,

THE REFRIGERATION IS

MALFUNCTIONING, PLEASE

CONTACT OUR TECHNICAL

SUPPORT CENTER

Figure 1

Procedimiento para limpieza de puertas y gabinetes con mancha de oxido Importante :

Mantén el refrigerador en un ambiente seco. Al haber acumulación de humedad, el metal

se oxida y se produce herrumbre.

Método de limpieza manual

1. Humedezca una

esponja en agua

con detergente.

2. Use la ƐƵƉĞƌĮĐŝĞ

suave de la esponja

para frotar sobre la

mancha de oxido.

El frote debe ser

en el mismo

Cuidado de su refrigerador

3. Use la ƐƵƉĞƌĮĐŝĞ

dura para frotar

sobre la mancha de

oxido. El frote debe

ser en el mismo

4. Enjuague la

esponja con agua

simple hasta eliminar

el detergente.

. de R.L. de C.V

W11347727 Rev. A STM W11202260 Rev. C

AS8950G

1. Garantizar que la pestaña de la moldura este posicionada

para arriba, de acuerdo con la image.

Accesorio de alambrón

ĐĐĞƐŽƌŝŽƷƟůǇƉƌĄĐƟĐŽ

para acomodar productos

ĞŶϮĂůƚƵƌĂƐĚŝƐƟŶƚĂƐ

͘

ENGLISH - 4 ESPAÑOL - 1

MANUAL W11347727 - W11354967.indd 1-2

MANUAL W11347727 - W11354967.indd 1-2 24/04/19 15:11

24/04/19 15:11

Produkt Specifikationer

Mærke:	Acros
Kategori:	Køleskab
Model:	AS8818A

Har du brug for hjælp?

Hvis du har brug for hjælp til Acros AS8818A stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Køleskab Acros Manualer

6 September 2024

5 September 2024

5 September 2024

5 September 2024

5 September 2024

5 September 2024

18 August 2024

Køleskab Manualer

Nyeste Køleskab Manualer

Equator WRD2-108 Manual

2 December 2024

Electrolux EBE5002SD Manual

2 December 2024

Liebherr CNd 2003 Manual

1 December 2024

Liebherr IXRF 5120 Plus Manual

1 December 2024

Liebherr SRsde 5220 Plus Manual

1 December 2024

Liebherr CNsdd 5723 Plus Manual

1 December 2024

Liebherr CBNstd 5783 Manual

1 December 2024

Liebherr CBNd 5723 Plus Manual

1 December 2024

Liebherr TP 1420 Comfort Manual

1 December 2024

Liebherr ICNSe 5123 Plus NoFrost Manual

1 December 2024