Adam Hall 87471USB Manual


Læs nedenfor 📖 manual på dansk for Adam Hall 87471USB (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 19 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Adam Hall GmbH · Daimlerstr. 9 · 61267 Neu-Anspach · Germany
Tel.: (+49) 60 81 / 94 19 0 · Fax: (+49) 60 81 / 94 19 1000 · eMail: mail@adamhall.com
SAFETY INFORMATION
1. Please read these instructions carefully.
2. Keep all information and instructions in a safe place.
3. Follow the instructions.
4. Observe all safety warnings. Never remove safety warnings or other information from the equipment.
5. Use the equipment only in the intended manner and for the intended purpose.
6. Use only sufficiently stable and compatible stands and/or mounts (for fixed installations). Make certain
that wall mounts are properly installed and secured. Make certain that the equipment is installed securely
and cannot fall down.
7. During installation, observe the applicable safety regulations for your country.
8. Never install and operate the equipment near radiators, heat registers, ovens or other sources of heat. Make
certain that the equipment is always installed so that is cooled sufficiently and cannot overheat.
9. Never place sources of ignition, e.g., burning candles, on the equipment.
10. Ventilation slits must not be blocked.
11. Do not use this equipment in the immediate vicinity of water (does not apply to special outdoor equipment
- in this case, observe the special instructions noted below. Do not expose this equipment to flammable
materials, fluids or gases.
12. Make certain that dripping or splashed water cannot enter the equipment. Do not place containers filled
with liquids, such as vases or drinking vessels, on the equipment.
13. Make certain that objects cannot fall into the device.
14. Use this equipment only with the accessories recommended and intended by the manufacturer.
15. Do not open or modify this equipment.
16. After connecting the equipment, check all cables in order to prevent damage or accidents, e.g., due to
tripping hazards.
17. During transport, make certain that the equipment cannot fall down and possibly cause property damage
and personal injuries.
18. If your equipment is no longer functioning properly, if fluids or objects have gotten inside the equipment or
if it has been damaged in another way, switch it off immediately and unplug it from the mains outlet (if it is
a powered device). This equipment may only be repaired by authorized, qualified personnel.
19. Clean the equipment using a dry cloth.
20. Comply with all applicable disposal laws in your country. During disposal of packaging, please separate
plastic and paper/cardboard.
21. Plastic bags must be kept out of reach of children.
FOR EQUIPMENT THAT CONNECTS T O THE POWER MAINS:
22. If the equipment has been exposed to strong fluctuations in temperature (for example, after transport), do
not switch it on immediately. Moisture and condensation could damage the equipment. Do not switch on
the equipment until it has reached room temperature.
23. Before connecting the equipment to the power outlet, first verify that the mains voltage and frequency
match the values specified on the equipment. If the equipment has a voltage selection switch, connect
the equipment to the power outlet only if the equipment values and the mains power values match. If the
included power cord or power adapter does not fit in your wall outlet, contact your electrician.
24. Do not step on the power cord. Make certain that the power cable does not become kinked, especially at
the mains outlet and/or power adapter and the equipment connector.
25. When connecting the equipment, make certain that the power cord or power adapter is always freely
accessible. Always disconnect the equipment from the power supply if the equipment is not in use or if
you want to clean the equipment. Always unplug the power cord and power adapter from the power outlet
at the plug or adapter and not by pulling on the cord. Never touch the power cord and power adapter with
wet hands.
26. Whenever possible, avoid switching the equipment on and off in quick succession because otherwise this
can shorten the useful life of the equipment.
27. To disconnect the equipment from the power mains completely, unplug the power cord or power adapter
from the power outlet.
28. Unplug the power cord and power adapter from the power outlet if there is a risk of a lightning strike or
before extended periods of disuse.
CAUTION:
CAU T I O N
RIS K OF SELE CTRIC HOCK
DO N O NOT PE
Never remove the cover, because otherwise there may be a risk of electric shock. There are no user serviceable
parts inside. Have repairs carried out only by qualified service personnel.
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to
the presence of uninsulated “dangerous voltage within the product’s enclosure that may be of sufficient
magnitude to constitute a risk of electrical shock.
The exclamation mark within an equilateral triangle is intended to alert the user to the presence of
important operating and maintenance instructions.
MANUFACTURER’S WARRANTY & LIMITATION OF LIABILITY
You can find our current warranty conditions and limitation of liability at: http://www.adamhall.com/media/shop/
downloads/documents/manufacturersdeclarations.pdf
To request warranty service for a product, please contact Adam Hall GmbH, Daimler Straße 9, 61267 Neu Ans-
pach / Email Info@adamhall.com / 49 (0) 6081 / 9419-0
PROPER DISPOSAL OF T HIS PRODUCT
(WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT)
(Valid in the European Union and other European countries with waste separation)
This symbol on the product, or the documents accompanying the product, indicates that this appliance may not
be treated as household waste. This is to avoid environmental damage or personal injury due to uncontrolled
waste disposal. Please dispose of this product separately from other waste and have it recycled to promote
sustainable economic activity.
FEATURES
Rated @ 250 V, 16 A
Aluminium housing with 4 outlets
2 USB charging ports
2 m power cord
Mounting angles included
INTRODUCTION
The 87470USB features four type F grounded safety outlets plus two type A USB ports to charge most USB
devices. This professional power strip comes in a rugged aluminium housing with permanently attached 2 m
power cord and mounting angles that provide four mounting positions. The wide spacing of the 45° angled
outlets easily accomodates multiple AC adapters side by side.
SPECIFICATIONS
Model name: 87470USB
Product type: Multiple socket
Type: 30cm
Number of outlets (earting contact/ IEC 7/4): 45° angled, 4
Number of USB outlets: 2
USB connector: Typ A
Max. charge current: 1A
Power input: Cable
Cable Length: 2 m
Cable connector: Earthing contact (CEE 7/7), angled
Conductor cross-section: 3 x 1.5 mm²
Operating Voltage: 250 V
Max. current: 16 A
Housing material: aluminium
Colour: black
Width: 300 mm
Height: 44 mm
Depth: 44 mm
Other Features: Mounting brackets can be used in 4 positions
Weight: 0.57 kg
87471USB
4-Outlet Power Strip With Dual USB Charging Ports


Produkt Specifikationer

Mærke: Adam Hall
Kategori: Ikke kategoriseret
Model: 87471USB

Har du brug for hjælp?

Hvis du har brug for hjælp til Adam Hall 87471USB stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Adam Hall Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer