AMX NXD-500iW-MW Manual

AMX overvåge NXD-500iW-MW

Læs nedenfor 📖 manual på dansk for AMX NXD-500iW-MW (2 sider) i kategorien overvåge. Denne guide var nyttig for 19 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

Installation Guide

NXD-500IW 5" Water-Resistant Wall/Flush Mount Touch Panel

For more detailed installation, configuration, programming, file transfer, and operating

instructions, refer to the NXD-500i Operation/Reference Guide, available online at

www.amx.com.

Overview

The NXD-500IW widescreen color panel is designed for use in high-humidity INDOOR

environments ranging between 50 and 95% relative humidity. It includes a built-in

microphone, speakers, a mini-USB port for programming and audio output, and one

NetLinx-programmable button. All power is supplied via Power Over Ethernet (PoE),

utilizing a PS-POE-AF PoE Injector (FG423-80) or equivalent PoE device. The 

NXD-500IW comes in Mystique black (NXD-500IW-MB, FG2261-09) and Mystique

white (NXD-500IW-MW, FG2261-12).

The NXD-500IW supports Intercom functionality, which allows two communicating

panels (controlled by the NetLinx Master) to transmit full-duplex audio signals over a

network in order to be used as an Intercom system.

Specifications

IP Rating Compliance (Indoor Use Only)

The NXD-500IW is IP Rating 51 compliant. Ingress of dust is not entirely prevented,

but it will not enter in sufficient quantity to interfere with the satisfactory operation of

the device; complete protection against contact. Dripping water (vertically falling

drops) shall have no harmful effect.

Panel Connectors and Wiring

FIG. 2 shows the connectors located on the NXD-500IW Modero panel. The mini-USB

port is used both for programming the touch panel and for audio output. The mini-USB

port automatically detects the presence of a headphone adaptor, allowing the port to

be used for headphone connectivity.

For more information on connection and use of the Panel Connectors, as well as

information on programming and headphone connectivity, please refer to the

NXD-500i Operation/Reference Guide, available at www.amx.com.

Front Bezel Button

The NXD-500IW has only one button on the front of the device, in the center of the

bezel. This button has several uses:

• Press the button once to start a previously programmed function, or to turn off

the display if not previously programmed.

• Press and hold the button for 6 seconds to put the device into Setup Mode.

• Press and hold the button for 9 seconds to enter Calibration Mode.

• Press and hold the button for 20 seconds to reboot the panel.

FIG. 1 NXD-500IW-MW 5" Modero Widescreen WallMount Touch Panel

NXD-500IW (FG2261-09/12) Specifications

Dimensions (HWD): • NXD-500IW (with bezel): 4.15" x 5.59" x 1.97" 

(10.50 cm x 14.20 cm x 5 cm)

• CB-TP5 Rough-In/Wallbox (optional): 4.27" x 5.14" x 3.40" 

(10.86 cm x 13.06 cm x 8.64 cm)

Power 

Requirements:

• PoE Powered - No local Power Supply needed

• Max power draw: 5.5W.

Memory (Factory

default):

• 128 MB SDRAM

• 256 MB integrated Flash Memory (not upgradeable - factory

programmed)

Weight: • 0.80 lbs (0.36 kg)

Certifications: • FCC Part 15 Class B

• CE

• IEC 60950

• RoHS

Panel LCD 

Parameters:

• Aspect ratio: 16 x 9

• Maximum brightness (luminance): 200 cd/m2

• Channel transparency: 8-bit Alpha blending

• Contrast ratio: 250:1

• Display colors: 256 thousand colors (18-bit color depth)

• Dot/pixel pitch: 0.14 mm

• Panel type: TFT Color Active-Matrix

• Screen resolution: 800 x 480 pixels (HV) @ 60 Hz frame

frequency

• Viewing dimensions: 4.3" x 2.58" (109.2 mm x 65.2 mm)

Active Screen Area: • 4.25” x 2.55” (10.80cm x 6.48cm)

Viewing Angles: • Up/Down/Left/Right: 85/85/85/85

IR Reception Angle: • Horizontal: + 25° (left and right from center)

• Vertical: + 15° (up and down from center)

Supported Audio

Sample Rates:

• 48000Hz, 44100Hz, 32000Hz, 24000Hz, 22050Hz, 16000Hz,

12000Hz, 11025Hz, and 8000Hz.

Intercom: • Full duplex VoIP capabilities.

Front Panel Components:

Light Sensor: • Photosensitive light detector for automatic adjustment of the

panel brightness.

Motion Sensor

(PIR):

• Proximity Infrared Detector to wake the panel when panel is

approached.

Front Bezel Button: • Provides both access to the Setup and Calibration pages and

toggles the panel between a “sleep” or “wake” state. This button

is also user-programmable.

Front Bezel Button Bezel

Speaker

Touch screen

Microphone

NXD-500IW Specifications (Cont.)

Front Panel Components (Cont.)

Microphone: • Frequency response of 300 to 3400Hz; used for intercom

applications.

Speaker: • Output of 4Ohm, 2 Watts, with a 300Hz low cutoff frequency.

Side Panel Connectors:

Ethernet 10/100

Port:

• RJ-45 port for 10/100 Mbps communication. The Ethernet port

automatically negotiates the connection speed (10 Mbps or 100

Mbps), and whether to use half duplex or full duplex mode.

Power is supplied through Power Over Internet (PoE). NXD-

500IW panels communicate with the NetLinx Master using the

ICSP protocol over Ethernet. LEDs show communication activity,

connections, speeds, and mode information:

L/A-link/activity - Yellow LED lights On when the Ethernet cables

are connected and terminated correctly and then blinks when

receiving Ethernet data packets.

SPD-speed - Green LED lights On when the connection speed is

100 Mbps and turns Off when the speed is 10 Mbps.

Mini-USB

Connector:

• 5-pin Mini-USB connector used for programming, firmware

update, and touch panel file transfer between the PC and the

target panel. The connector is also used for providing audio

output for external speakers.

Operating /Storage

Environments:

• Operating Temperature: 0° C (32° F) to 40° C (104° F)

• Operating Humidity: 5% - 95% relative humidity

(non-condensing)

• Storage Temperature: -20° C (-4° F) to 60° C (140° F)

• Storage Humidity: 5% - 85% RH

• Indoor Installation and Operation ONLY

Included 

Accessories:

• NXD-500IW Installation Guide (93-2261-09)

Other AMX 

Equipment:

• CB-TP5i Rough-In/Wallbox (FG038-11)

• Back Cover for the CB-TP5i Rough-In/Wallbox (FG038-12)

• PS-POE-AF PoE Injector (FG423-80)

• CC-USB Type-A to Mini-B 5-wire programming cable 

( )FG10-5965

• USB to Headphone Adaptor (FG5966-23)

FIG. 2 Connector layout on the NXD-500IW

Ethernet 10/100 port

Mini-USB port

Back box

Produkt Specifikationer

Mærke:	AMX
Kategori:	overvåge
Model:	NXD-500iW-MW

Har du brug for hjælp?

Hvis du har brug for hjælp til AMX NXD-500iW-MW stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

overvåge AMX Manualer

AMX MXD-1001-P Manual

27 August 2024

27 August 2024

27 August 2024

27 August 2024

27 August 2024

27 August 2024

AMX MXT-1000-NC Manual

27 August 2024

AMX NXD-435 Manual

27 August 2024

AMX MXD-1901-PAN-L Manual

27 August 2024

AMX MXD-1900L-PAN-NC Manual

27 August 2024

overvåge Manualer

Nyeste overvåge Manualer

Philips 233V5LHAW Manual

21 December 2024

Philips 206V3LSB2 Manual

21 December 2024

HP Z23i Manual

21 December 2024

Philips Evnia 24M1N3200ZA Manual

21 December 2024

Philips Evnia 27M1N3200ZA Manual

21 December 2024

Philips Momentum 5000 27M1N5500Z Manual

21 December 2024

HP 2511x Manual

21 December 2024

Philips 86BDL4511D Manual

21 December 2024

Philips 271S9A Manual

21 December 2024

Viewsonic VX2457-HD-PRO Manual

21 December 2024