Anker PowerWave Evo Manual


Læs nedenfor 📖 manual på dansk for Anker PowerWave Evo (3 sider) i kategorien Oplader til mobil enhed. Denne guide var nyttig for 47 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/3
EN
LED Indicator Status
Solid blue for 3
seconds, then
off
Connected to power
Solid blue Charging mobile device
Flashing blue
- Metal or abnormal temperature detected
- Using a non-Quick Charge™ 3.0 wall
charger
T
 For the fastest and safest charge, use the
supp lie d Anker® cha rger or a charger
compliant with the Quick Charge 3.0
Standard (supporting 12V). Other chargers
may not work well with this device.
 Using an ultra-thick protective phone case
or a case with a magnetic/iron plate is not
recommended as it may affect the wireless
charging function.
Important Safety Instructions
 Avoid dropping.
 Do not disassemble.
 Do not expose to liquids.
 For the safest and fastest charge, use original or
certified cables.
 This product is suitable for moderate climates only.
 The maximum ambient temperature during use of
this product must not exceed 40°C.
 Open flame sources, such as candles, must not be
placed on this product.
 Only use a dry cloth or brush to clean this product.
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Warning: Changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna. (2)
Increase the separation between the equipment and
receiver. (3) Connect the equipment into an outlet on
a circuit different from that to which the receiver is
connected. (4) Consult the dealer or an experienced
radio / TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
minimum distance of 10 cm between the radiator &
your body.
IC Statement
This device complies with RSS-216 of Industry Canada.
Operation is subject to the condition that this device
does not cause harmful interference.
Specifications
Input 12 V 1.5 A
Output 5 W / 7.5 W / 10 W
Size 82 x 68 x 118 mm / 3.2 x 2.7 x 4.6 in
Weight 127g/ 4.5 oz
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the
product type A2525 is in compliance with Directive
2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
https://www.anker.com/products
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road,
Mongkok, Kowloon, Hong Kong
DE
LED-Anzeige Status
Leuchtet 3 Sekunden
lang blau, dann aus
An Stromversorgung
angeschlossen
Leuchtet blau Mobilgerät lädt
Blinkt blau
- Metall oder ungewöhnliche
Temperatur erkannt
- Verwendung eines anderen
Ladegeräts als Quick Charge™ 3.0
T
 Am schnellsten und sichersten erfolgt der
Ladevorgang mit dem Anke Ladegerät aus
dem Lieferumfang oder mit einem Quick
Charge 3.0-kompatiblen Ladeget (mit
12-V-Unterstützung). Andere Ladegeräte
funktionieren bei diesem Gerät u. U. nicht.
 Vo n d e r Ve r w e n d u n g e x t r a st a r k e r
Smartphone-Schutzhüllen oder Schutzhüllen
mit Magnet- bzw. Metalleinsätzen wird
abgeraten, da diese die kabellose Ladefunktion
beeinträchtigen können.
Wichtige Sicherheitsinformationen
 Nicht fallenlassen.
 Nicht zerlegen.
 Keinen Flüssigkeiten aussetzen.
 Zum sichersten und schnellsten Laden nur Original-
oder zertifizierte Kabel verwenden.
 Das Produkt ist nur zur Verwendung in gemäßigten
Klimazonen konzipiert.
 Die maximale Umgebungstemperatur während
der Verwendung des Produkts darf 40 °C nicht
übersteigen.
 Offene Flammen wie z. B. Kerzen dürfen nicht auf das
Produkt gestellt werden.
 Reinigen Sie das Produkt nur mit einem trockenen
Tuch oder einem Pinsel.
Technische Daten
Eingang 12 V 1.5 A
Ausgang 5 V / 7.5 W / 10 W
Abmessungen 82 x 68 x 118 mm
Gewicht 127g
01 02 03 04
JP
LED インジケーター 意
青色に 3 秒間点灯後に消灯 電源に接続
青色の点灯 モバイル機器の充電中
青色の点滅
- 金属または異常な温度が検出さ
れました
- Quick Charge™ 3.0 非対
器が使用されています
T
すばやく安全に充電するため付属の Anker®
Quick Charge™ 3.0 格(12V
対応)に準拠している充電器をご使用くださ
い。その他の充電器では正常に充電できない
場合があります
ワイヤレス充電がうまく実行されない可能性
があるため、スマートフォンに極端に分厚い
ケースやマグネット式もしくは鉄製のケース
をつけたままのご使用はお控えください
安全上のご注意
過度な衝撃を与えないでください。
危険ですので分解しないでください。
水分に触れないようにしてください。
すばやく安全に電すため、正または証さ
たケーブルをご使用ください。
本製品は極端に暑いもしくは寒い気候での利用には
適しておりません。
本製品の周囲の気温が 40℃ を超える場合、使用し
いでください。
ろうそくのような火がついた物体を本製品の上に置
かないでください。
本製品のお手入をす際は、いた布もくは
ラシのみを使用してください。
05 06 0807
仕様
入力 12 V 1.5 A
出力 5 W / 7.5 W / 10 W
サイズ 82 x 68 x 118 mm / 3.2 x 2.7 x 4.6 in
重量 127g/ 4.5 oz
FR
Indicateur LED État
Bleu fixe pendant
3 secondes, puis s'éteint
En tension
Bleu fixe Appareil mobile en charge
Bleu clignotant
- Présence de métal ou température
anormale détectée
- Utilisation d'un chargeur mural
autre que Quick Charge™ 3.0
T
 Pour le processus de charge le plus rapide et
le plus r, utilisez le chargeur Ankefourni
ou un chargeur compatible avec la norme
Quick Charge™ 3.0 (prenant en charge 12 V).
Les autres chargeurs peuvent ne pas bien
fonctionner avec cet appareil.
 L'utilisation d'un étui de protection ultra-épais
ou avec une plaque magnétique/en fer n'est
pas recommandée : cela risquerait d'affecter
la fonction de charge sans fil.
Instructions importantes de sécurité
 Ne pas faire tomber.
 Ne pas démonter.
 Ne pas exposer à des liquides.
 Pour obtenir la charge la plus sûre et la plus rapide,
utiliser des câbles d'origine ou certifiés.
 Ce produit est adapté uniquement aux climats
modérés.
 La tempé ratu re ambi ant e max ima le pen dan t
l'utilisation de ce produit ne doit pas dépasser 40 °C.
 Ce produit ne doit pas être exposé à des sources de
flamme nue, notamment des bougies.
 Nettoyez ce produit uniquement avec un chiffon sec
ou une brosse.
Spécifications techniques
Entrée 12 V 1.5 A
Sortie
5 W / 7.5 W / 10 W
Taille 82 x 68 x 118 mm / 3.2 x 2.7 x 4.6 in
Poids 127g/ 4.5 oz
IT
Indicatore LED Stato
Blu fisso per 3 secondi, poi
si spegne
Collegato a una fonte di
alimentazione
Blu fisso Ricarica del dispositivo mobile
Blu lampeggiante
- Presenza di metallo o
temperatura anomala rilevata
- Utilizzo di un caricabatterie da
parete non Quick Charge™ 3.0
T
 Per una ricarica rapida e più sicura, utilizzare
il caricabatterie Anker® fornito in dotazione
o un caricabatterie compatibile con lo
standard Quick Charge3.0 che supporti 12
V. Altri tipi di caricabatterie potrebbero non
funzionare correttamente con il dispositivo.
 Si consiglia di non utilizzare custodie protettive
piuttosto spesse o dotate di una
piastra
magnetica o in ferro poiché potrebbero
interferire con la funzione di ricarica wireless.
Informazioni importanti sulla sicurezza
 Non fare cadere il prodotto.
 Non smontare il prodotto.
 Non esporre il prodotto a liquidi.
 Per effettuare la carica in modo rapido e sicuro,
utilizzare i cavi originali o certificati.
 Il prodotto è adatto all'utilizzo in climi moderati.
 Il prodotto deve essere utilizzato in ambienti a
temperatura non superiore ai 40° C.
 Non collocare sorgenti di fiamme libere, ad esempio
candele accese, sul prodotto.
 Per pulire il prodotto, utilizzare esclusivamente un
panno asciutto o una spazzola.
Specifiche
Ingresso 12 V 1.5 A
Uscita 5 W / 7.5 W / 10 W
Dimensioni 82 x 68 x 118 mm
Peso 127g


Produkt Specifikationer

Mærke: Anker
Kategori: Oplader til mobil enhed
Model: PowerWave Evo

Har du brug for hjælp?

Hvis du har brug for hjælp til Anker PowerWave Evo stil et spørgsmål nedenfor, og andre brugere vil svare dig




Oplader til mobil enhed Anker Manualer

Oplader til mobil enhed Manualer

Nyeste Oplader til mobil enhed Manualer