Behringer ADI21 Manual

Behringer Guitarforstærker ADI21

Læs nedenfor 📖 manual på dansk for Behringer ADI21 (20 sider) i kategorien Guitarforstærker. Denne guide var nyttig for 28 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/20

V-TONE ACOUSTIC DRIVER DI ADI21

Acoustic Amp Modeler/Direct Recording Preamp/DI Box

Thank you for showing your condence in us by purchasing the V-TONE

ACOUSTIC ADI21. This high-quality acoustic guitar driver is designed for all

acoustic guitar players who are looking for more sounds to reach maximum

exibility and creativity. Thanks to its high-performance EQ section

(including parametric mids) and the integrated Tube/Microphone Emulation,

the ADI21 gives your guitar natural sound with smooth saturation, just as if it

were being miked. In addition, the ADI21 functions as a standard ultra-transparent

direct injection box when used in bypass mode.

A DI (Direct Injection) box allows you to send a signal directly from an unbalanced,

high-impedance output (like an electric guitar) and connect it directly to the

balanced mic input of a mixing console.

Whether for stage, recording, rehearsal or warm-up, Behringer’s V-TONE ACOUSTIC

ADI21 is a natural choice for those who are seeking great tone with a simple set-up.

1. Control Elements

Control elements

(1) The TREBLE control governs the high-frequency range of the signal (±12 dB).

(2) The BASS control allows you to boost/cut the low-frequency range (±12 dB).

(3) Use the MID control to boost or cut the mid-range frequencies (±12 dB).

The MID FREQ control lets you select the middle frequency (170 Hz to 3.5 kHz)

that will be boost/cut.

(4) The control adjusts the output level of the ADI21.LEVEL

(5) The BLEND control activates the integrated tube/microphone emulation circuitry.

In most cases, you will probably set it to maximum (100%). If you want to

hear some of the distinct timbre of a piezo pickup or reduce the amount

of compression, simply turn the control counterclockwise.

(6) When activated, the GND LIFT disconnects the ground connection between

input and output. Depending on the grounding of the connected equipment,

this can eliminate hum or ground loops.

(7) The -20 dB PAD switch attenuates the output level of the BAL OUT (see ) (10)

by -20 dB. It should be activated when the output level is too high for the

microphone input of the mixer channel.

◊

◊ ◊ Before using the PAD switch, be sure that it is the mic preamp on the

mixing console that is clipping and not the ADI21. You should only

attenuate the output signal via the PAD switch if the CLIP LED of the

mic channel lights up frequently or remains lit.

(1)

(8)

(5)

(4)

(3)

(2)

(6)

(9)

(7)

(8) Use the footswitch to activate/deactivate all the tone functions

(EQ, microphone/tube emulation). When deactivated, the ADI21

functions solely as a standard transparent DI box.

(9) This LED illuminates when the eect is activated (see (8)).

Connectors

(10) Use this ¼" TS connector to plug in the instrument cable of your INPUT

acoustic guitar or other instruments.

(11) BAL OUT is the ADI21’s balanced mic level output. Use a high-quality,

balanced XLR (microphone) cable to connect the driver to a mixing console.

(12) The unbalanced ¼" TS connector sends the signal to your guitar amp.OUT

Bottom of the ADI21

(13) SERIAL NUMBER. The serial number of the ADI21 is located at the bottom.

(14) BATTERY COMPARTMENT. Open the lid to install or replace the 9 V battery.

◊

◊ ◊ The ADI21 is powered as soon you insert a plug into the INPUT.

The battery is “disconnected” when the plug is removed.

For this reason, the ADI21 has no on/o switch. To prolong

battery life, always disconnect the input when the driver is

not in use.

(15)

Power supply connector

(15) Use the connection to plug in a 9 V power supply (not included).DC IN

(10) (12)

(11)

(14)

(13)

V 5.0

Produkt Specifikationer

Mærke:	Behringer
Kategori:	Guitarforstærker
Model:	ADI21
Bredde:	100 mm
Dybde:	50 mm
Højde:	127 mm
Vægt:	460 g
Produktfarve:	Bordeaux
Indbygget skærm:	Ingen
Produkttype:	Forforstærker
XLR udgående:	1