Bikemate 22970 Manual

Bikemate Cykel computer 22970

Læs nedenfor 📖 manual på dansk for Bikemate 22970 (2 sider) i kategorien Cykel computer. Denne guide var nyttig for 12 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

(j) max. 30 cm max. 30 cm

max. 60 cm

Scope of delivery

A Bicycle computer

B Bracket for bicycle computer

C Rubber base for bracket

D Sensor

E Rubber base for sensor

F Magnet with magnet holder

G 2 x button cell (2 x type CR 2032)

H 6 x cable tie

Technical data

Bicycle computer, wireless with solar

Item No.: 90305

Batch: PO30000529

Model number: 22970

Power supply:

Operating voltage: 3 V

Sensor button cell: 3 V / Type: CR2032

Bicycle computer button cell: 3 V / Type:

CR2032

Protection type: IP44 (splashproof)

Transmission frequency and transmission power

Bicycle computer: Frequency band: 12 5 kHz ± 10 kHz

Sensor: Frequency band: 125 kHz ± 10 kHz

Maximum transmittable power: < 5 dBm

Weight: approx. 72 g (incl. accessories)

Bicycle computer measurements:

approx. 6.3 x 4 x 1.5 cm (L x W x D)

Date of production: 2019

Guarantee: 3 years

1. Introduction

Explanation of symbols

The following symbols and signal words are used in

these operating instructions, on the bicycle comput-

er or on the packaging.

WARNING!

This signal symbol/word indicates a hazard with a

medium level of risk which, if not avoided, may re-

sult in death or serious injury.

CAUTION!

This signal symbol/word indicates a hazard with a

low level of risk which, if not avoided, may result in

minor or moderate injury.

NOTE!

This signal word warns of possible property damage.

This symbol provides you with useful

additional information about operation.

This symbol indicates potential danger to

children.

Conformity declaration (see Chapter

“Conformity declaration”): Products that

are marked with this symbol fulﬁl all

applicable Community regulations of the

European Economic Area.

This symbol means direct current.

This symbol indicates the Protection

Class IP44 (protection against splashing

water from all sides).

This sign indicates how the button cell is

inserted.

INCLUDED

BATTERY

This symbol indicates that batteries are

included in the necessary scope of deliv-

ery.

This symbol indicates potential danger

in relation to explosions.

This symbol indicates potential danger

from handling batteries / rechargeable

batteries.

0-5

DANGER if swallowed

This symbol indicates dangers of swal-

lowing batteries.

Widely

Recycled

These symbols inform you about the

disposal of the packaging and prod-

uct.

2. Intended use

The bicycle computer is exclusively designed for

displaying and collecting information (e.g. average

speed, time etc.) while using a bicycle. It is only

intended for private use and is not suitable for the

commercial sector. Only use the bicycle computer as

described in these operating instructions. Any other

use is considered to be improper use and may result

in property damage or even personal injury. No lia-

bility is assumed for damage or injury resulting from

non-observance of these operating instructions or

improper use.

3. Safety instructions

Read the safety instructions thor-

oughly.

This bicycle computer can be used

by children from the age of eight

and above, as well as by persons

with impaired physical, sensory

or mental capabilities or a lack

of experience and knowledge, if

they are supervised or have been

briefed on the safe use of the fore-

arm trainer and the resulting haz-

ards. Children are not permitted

to play with the bicycle computer.

Cleaning and user maintenance

must not be performed by children

without supervision.

WARNING!

DANGER! RISK OF DEATH

AND INJURY.

Keep children away from packaging ma-

terial. Danger of suﬀocation, amongst other things!

The bicycle computer contains small parts. Children

can swallow these while playing and choke on

them. Keep the small parts away from children.

DANGER FROM BUTTON CELLS!

The button cell operation occurs with button cell

type CR 2032.

NOTE!

4. Risk of damage!

- Improper handling of the bicycle computer can

lead to damage.

- Operate the bicycle computer in an ambient tem-

perature of between -10° C and +50° C.

- Do not expose the bicycle computer to any perma-

nent moisture.

- Avoid dust, heat and long-lasting direct sunlight

- Never repair the bicycle computer yourself. In case

of technical problems, contact the service address

provided on the guarantee card.

- If the button cell compartment can no longer be

closed securely with the housing lid, dispose of

the bicycle computer as described in the “Disposal”

chapter.

- To avoid premature depletion of the button cell,

the magnet should not be directly in contact with

the sensor while the bike is left standing for a

longer period of time. Please remove the button

cells, if the bicycle computer is not being used for

a longer period of time.

5. Safety instructions regarding

button cells:

WARNING!

THERE IS A RISK OF INJURY!

0-5

DANGER if swallowed

- Button cells should be stored where

they are inaccessible for children.

Button cells may be fatal if swal-

lowed, so this bicycle computer and

its button cells must be stored out of reach for

small children.

WARNING!

EXPLOSION HAZARD: With im-

proper replacement of the button

cells.

- Button cells to be replaced may only be replaced

with the same type of button cells. Pay attention

to the correct polarity, when replacing the button

cells. If necessary, clean the button cell and the

contacts of the bicycle computer prior to insertion.

EXPLOSION HAZARD: Never re-

charge non-rechargeable button cells, do

not short-circuit and/or open them. This

may result in overheating, risk of ﬁre or bursting.

ATTENTION! Leaked or damaged but-

ton cells may cause acid burns if they

come into contact with skin. Do not

touch leaked button cells with bare hands; there-

fore, ensure that you wear appropriate protective

gloves in such a case!

- If a button cell has been swallowed, please consult

a doctor without delay.

- Only use CR 2032 type button cells from the same

manufacturer for the sensor and bicycle computer.

- Store button cells in a dry and cool, not damp,

place.

- Never throw button cells into ﬁre. Explosion haz-

ard

- Never expose button cells to excessive heat. In-

creased risk of leakage!

- Do not deform button cells. Risk of explosions and

possible injuries to persons.

- Disposable button cells also lose part of their ener-

gy during storage.

- Remove the button cells if the bicycle computer is

not in use.

- Immediately remove depleted button cells from

the bicycle computer and dispose of them cor-

rectly with your local collection centre.

- Store disposable button cells separately from

discharged batteries, in order to avoid mix-ups.

6. Information about solar cells

This bicycle computer is ﬁtted with solar cells,

which convert light energy into electric current.

This extends the service lift of the button cell. But-

ton cells are nevertheless required for the energy

supply in case of darkness and those of the sensor.

7. Check bicycle computer

Prior to initial use, check whether the bicycle com-

puter is complete and undamaged.

8. Assembly

8.1 Assembly point on the bicycle /

There are 2 assembly points for the computer and 1

assembly point for the sensor/magnet, see Fig. (a).

8.2 Assemble bracket and bicycle

computer

Assembly on the stem / Fig. (b-c)

Insert the rubber base C under the bracket of the

bicycle computer B.

Place the bracket B with the rubber base C on

the stem (Assembly Point (1)) and insert two ca-

ble ties H through the designated guides on the

bracket B. Pull the cable ties H tightly, so that

the entire bracket is ﬁrmly attached. Cut oﬀ the

excess ends of both cable ties H with scissors. The

bracket is now assembled.

Assembly on the handlebar stem / Fig. (d)

Place the bracket B with the rubber base C on

the handlebar stem (Assembly Point (2)) and

insert two cable ties H through the designated

guides on the bracket B. Pull the cable ties H

tightly, so that the entire bracket is ﬁrmly attached.

Cut oﬀ the excess ends of both cable ties H with

scissors. The bracket is now assembled.

Assembly of the bicycle computer / Fig. (e)

Slide the bicycle computer A onto the bracket

B until it clicks into place. To remove the bicycle

computer from the bracket, press the locking hook

downwards and pull the bicycle computer out of

the bracket.

8.3. Assemble the sensor and

magnet

Assembly of the sensor / Fig. (f-g)

Place the rubber base E on the sensor D.

NOTE!

The battery cover of the sensor must be facing

away from the spokes during assembly.

Hold the sensor D with the rubber base E on

the fork tube (Assembly Point (3)) and insert two

cable ties H through the designated guides on the

sensor D. Pull the cable ties H tightly, so that the

rubber base E and sensor D are ﬁrmly attached.

Cut oﬀ the excess ends of both cable ties H with

scissors. The sensor is now assembled.

4-colour process (CYMK)

ILLUSTRATOR & PHOTOSHOP Shadow

K:100 M:100 Y:100

B C

(a) (1)

(2)

(3)

(b) B

(c)

(d) B

(e) AA

(f) ED

(g)

E E

D D

(h)

(h-1)

(h-2)

(i)

max. 60 cm

90°

(k)

Coin

Buon cell cover

3V (CR2032)

(l)

Coin

Buon cell cover

3V (CR2032)

User

Manual

BICYCLE COMPUTER

WIRELESS WITH SOLAR

PRODUCED IN CHINA FOR:

ALDI STORES LTD. PO BOX 26, ATHERSTONE

WARWICKSHIRE, CV9 2SH.

ALDI STORES (IRELAND) LTD.

PO BOX 726, NAAS, CO. KILDARE.

YEAR

WARRANTY

AFTER SALES SUPPORT 90305

00800 / 68546854

(free of charge, mobile networks may vary)

MODEl:

22970/PO30000529 04/2020

monz-gb@teknihall.com / monz-ie@teknihall.com

GB IE

Great care has gone into the manufacture of this product and it should

therefore provide you with years of good service when used properly. In

the event of product failure within its intended use over the course of the

ﬁrst 3 years after date of purchase, we will remedy the problem as quickly

as possible once it has been brought to our attention. In the unlikely event

of such an occurrence, or if you require any information about the product,

please contact us via our helpline support services, details of which are to be

found both in this manual and on the product itself.

Produkt Specifikationer

Mærke:	Bikemate
Kategori:	Cykel computer
Model:	22970

Har du brug for hjælp?

Hvis du har brug for hjælp til Bikemate 22970 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Cykel computer Bikemate Manualer

Bikemate 22970 Manual

22 August 2024

Bikemate AS9-FCS-50 Manual

18 August 2024

Bikemate HO-FCS-51 Manual

16 August 2024

Bikemate AS7-FC-2B Manual

16 August 2024

Bikemate MCP30102 Manual

16 August 2024

Bikemate AS7-FC-2C Manual

13 August 2024

Bikemate 22967 Manual

10 August 2024

Cykel computer Manualer

Nyeste Cykel computer Manualer

BBB BCP-35W Manual

12 Oktober 2024

Crivit HG01734A Manual

3 Oktober 2024

Sigma Pure GPS Manual

2 Oktober 2024

Bryton Rider 20 Manual

2 Oktober 2024

Sigma BC 1600 Manual

30 September 2024

Lezyne Mega XL GPS Manual

29 September 2024

Wahoo Elemnt Roam v2 Manual

23 September 2024

Trelock BB 4000i Manual

23 September 2024

Echowell Ui-20 Manual

23 September 2024

Sigma BC 2006 MHR DTS Manual

19 September 2024