Bogen KFLDS30T Manual

Bogen Højttaler KFLDS30T

Læs nedenfor 📖 manual på dansk for Bogen KFLDS30T (2 sider) i kategorien Højttaler. Denne guide var nyttig for 20 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Installation Instructions
1. Unscrew wing nut and remove threaded pin to separate the mounting base from
the horn. Use the base as a template for the mounting holes. Drill three
mounting holes and attach the base using appropriate hardware (not included).
See Figure 1
IMPORTANT: Make sure the base sits flat on the mounting surface. Tightening
the base down on an uneven surface could cause the base to fracture.
The speaker can be mounted to an I-beam flange using Bogen's accessory
BC1 Beam Clamp. The slot in the base also allows strapping to be used as a
means of mounting the horn (use a strapping material capable of supporting
the weight of the speaker and any external loads on the horn such as wind).
2. Reassemble horn on base after it has been mounted.
3. Remove the plastic cover to make the electrical connections (see Figure 2).
Connect the 70V or 25V “hot” lead to the #1 terminal and the system common
lead to the #2 terminal. Follow this pattern on all similar speakers to ensure
proper phasing; however, the speakers will work perfectly well if the connec-
tions are reversed.
4. Adjust the tap selector switch to the desired wattage using the chart below and
secure the plastic cover back in place.
5. Loosen Wing Nut, tilt and swivel the horn to the desired orientation, then
re-tighten. Hand tighten wing nuts. Do not use pliers or tools.
KFLDS30T
Wide Dispersion, 30W,
Horn Loudspeaker
© 2005 Bogen Communications, Inc.
Specifications subject to change without notice.
54-2138-01B 0802
Figure 1
Figure 2
BC1 Beam Clamp
(optional accessory)
TAP
SET
1
2
3
4
5
6
7
8
25V
WATTS
70V
WATTS
1.8
3.7
7.5
15
30
*
*
*
0.25
0.5
0.9
1.8
3.7
7.5
15
*
IMPORTANT:
DO NOT
use positions
marked as "*"
ELECTRICAL
CONNECTION
TAP SET
CONTROL
TCSPT1 Terminal & Tap
Selector Fitting
(optional accessory)


Produkt Specifikationer

Mærke: Bogen
Kategori: Højttaler
Model: KFLDS30T

Har du brug for hjælp?

Hvis du har brug for hjælp til Bogen KFLDS30T stil et spørgsmål nedenfor, og andre brugere vil svare dig




Højttaler Bogen Manualer

Bogen

Bogen NEAR S5T Manual

23 September 2024
Bogen

Bogen MPS1 Manual

18 September 2024
Bogen

Bogen OCS1 Manual

18 September 2024
Bogen

Bogen AFI-8 Manual

14 September 2024
Bogen

Bogen NQ-SMS1810-SCG Manual

1 September 2024
Bogen

Bogen CSD1X2 Manual

29 August 2024
Bogen

Bogen CSD2X2 Manual

19 August 2024
Bogen

Bogen KFLDS30T Manual

18 August 2024
Bogen

Bogen SEC4T Manual

18 August 2024
Bogen

Bogen IG8s2M Manual

18 August 2024

Højttaler Manualer

Nyeste Højttaler Manualer