Boss ATVB90 Manual

Boss Højttaler ATVB90

Læs nedenfor 📖 manual på dansk for Boss ATVB90 (2 sider) i kategorien Højttaler. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

FCC COMPLIANCE STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause

undesired operation of this device.

This transmitter must not be co-located or operated in conjunction with any other

antenna or transmitter. The Bluetooth antenna cannot be removed (or replaced) by

user. This equipment complies with FCC/ IC radiation exposure limits set forth for

an uncontrolled environment and meets the FCC radio frequency (RF) Exposure

Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This

equipment has very low levels of RF energy that it deemed to comply without

maximum permissive exposure evaluation (MPE). But it is desirable that it should

be installed and operated keeping the radiator at least 20 cm or more away from

person’s body (excluding extremities: hands, wrists, feet and ankles). Alteration

or modications carried out without appropriate authorization may invalidate the

user’s right to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de-

signed to provide reasonable protection against harmful interference in a residen-

tial installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guar-

antee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be

determined by turning the equipment o and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

□ Relocate or reorient the receiving antenna.

□ Increase the separation between the equipment and receiver.

□ Connect the equipment into an outlet on a circuit dierent from that to which the

receiver is connected.

□ Consult the dealer or an experienced radio/TV technician for help.

THIS PACKAGE CONTAINS

1 - ATVB90 All-Terrain Speaker System

1 - Bluetooth Multi-Function Controller

1 - Handlebar Mounting Kit

1 - Quick Connect Power Extension Adaptor

4 - Hi-strength Nylon Mounting Straps

1 - User Manual Quick Start Guide / Poster

1 - Warranty Card

USER MANUAL

QUICK START GUIDE

Thank you for purchasing this

ATVB90 All-Terrain Sound System

Please read through these instructions carefully so you will know

how to operate your model properly.

After you have nished reading the instructions, keep this document

in a safe place for future reference.

INFORMATION TO THE USER

The Bluetooth® word mark and logos are registered trademarks owned by

Bluetooth SIG, Inc. and any use of such marks is under license.

Other trademarks and trade names are those of their respective owners.

CAUTION!!

ADJUSTMENT OR ALTERATIONS OF THIS DEVICE MAY RESULT

IN HAZARDOUS RADIATION EXPOSURE.

GETTING TO KNOW YOUR

ATVB90 MULTIFUNCTION CONTROLLER (MFC)

BEFORE YOU START

IMPORTANT SAFETY PRECAUTIONS

■ Do not operate mobile equipment while driving a motorized vehicle – safe driving and

safety consideration of others should always be your highest priority.

■ In the event you should notice smoke, strange noises or odor from this product, or any

other abnormal signs, immediately turn o the power and consult your dealer or the near-

est authorized BOSS AUDIO Service Center. Using this product in this condition may result

in permanent damage to the system.

■ Set your volume control at a low setting, then slowly increase the sound until you can

hear it comfortably without distortion, or ear discomfort.

■ :BE SURE TO OBSERVE THE FOLLOWING GUIDELINES

- Do not turn up the volume so high that you can’t hear what’s around you.

- Use caution or temporarily discontinue use in potentially hazardous situations.

INSTALLATION PRECAUTIONS

WARNING - Always consult a professional installer

■ Do not attempt to install or service this product by yourself. Installation or servicing of this

product by persons without professional training and experience in electronic equipment

and motorized vehicle accessories may be dangerous and could expose you to the risk of

electric shock, injury or other hazards

■ Refer any repairs to a qualied BOSS AUDIO SYSTEMS Service Center

■ The ATVB90 can be powered from a vehicles cigarette lighter / auxiliary power port, or

hard wired directly to the battery through an optional relay / accessory switch

■ When wiring directly to the vehicles battery, be sure to disconnect the batteries negative

terminal wire before starting any wiring procedures, it is suggested that an optional fuse

and fuse holder (not included) with minimum rating of be in line with the positive 20 Amps

battery terminal

■ The ground cable length should not exceed 18-inches (See wiring diagram)

■ The ATVB90 has a weather resistant design, it should not be submerged under water

under any circumstances

■ Use only the installation parts provided with the ATVB90

■ Ensure the is not mounted behind metalMFC

■ Do not install the next to the vehicles electronicsMFC

■ Never install this product in a heated location

GETTING STARTED

CAUTION!! Using other mounting methods may void this warranty

PAIRING & DISCOVERING A NEW BLUETOOTH CONNECTION

1) Power on the by pressing and holding down the MFC 2 for 3 seconds Power button

2) Press the PLAY/PAUSE 4button for 3 seconds, the 5 BLUE LED will quickly ash,

signalling that the is now ready for pairing. MFC Bluetooth

3) Now that the is in pairing mode:MFC

ANDROID users:

a. Go into the of your deviceSettings Menu

b. Enter the Bluetooth Menu

TURN ON Bluetooth SCANc. and press

d. “BOSS AUDIO ATV” will now be displayed under AVAILABLE DEVICES

e. If prompted, enter passcode: “ ”0000

iOS users:

a. Go into the of your deviceSettings Menu iOS

b. Enter the Bluetooth Menu

. TURN ON Bluetoothc

d. “BOSS AUDIO ATV” will now be displayed

e. If prompted, enter passcode: “ ”0000

4) If BOSS AUDIO ATV is not seen, repeat the above steps and refresh the “Device List”

5) You will hear a tone when the connection is successful, you are now ready to stream

music from your favorite media player to the ATVB90

NOTE: You have 2 minutes before you must restart this procedure over again.

To avoid battery exhaustion, be sure to occasionally run the

vehicles engine while using this product.

Using this product without running the engine can drain the battery.

BLUETOOTH OPERATION BLUETOOTH OPERATION

RECONNECTION

1) Power on the and your last paired device Bluetooth.MFC

2) The unit will now automatically reconnect

3) If your device was previously paired with the , but it wasn’t the last pairedMFC

device:

a. Ensure no other devices are currently paired

b. Enter the on your device being pairedBluetooth Menu

c. “BOSS AUDIO ATV” will display under AVAILABLE DEVICES

d. Choose the “BOSS AUDIO ATV” to reconnect

4) If the device is out of range from the ATVB90, it will disconnect automatically:

a. If your device does not reconnect automatically once it is back in range, press

BOSS AUDIO ATV in your devices settingsBluetooth

b. The MFC will now reconnect to the device

Tips:

STREAMING MUSIC

Make sure your device Bluetooth volume is set at 100% level

before stowing

AUX-INPUT

Make sure your device headphone volume is set at 100% level

before stowing.

Tips: Tips:

MULTI-FUNCTION CONTROLLER MOUNTING

LEFT or RIGHT

FOR ILLUSTRATION PURPOSES

YOUR VEHICLE MAY VARY

TOOLS NEEDED:

- 12mm Socket, Wrench or Pliers

- 6mm Allen Wrench

BEFORE INSTALLING THIS PRODUCT

When replacing the fuse, be sure to only use a fuse of the rating specied on

this product. To avoid short-circuiting, cover any disconnected leads with insulating

tape. It is especially important to insulate any unused wires, which if left uncovered

may cause a short circuit. When connecting other devices to this product, refer to

the manual for the product to be connected. The black cable is ground, make sure

to connect the ground wire rst. Ensure that the ground wire is properly connected

to metal parts of the vehicles body frame or direct to the battery if your vehicle

does not have a grounded chassis frame The ground wire of this units power amp

and a second powered system must be connected to the frame separately with

dierent screws. If the screw for the ground wire loosens or falls out, it could result

in re or malfunction.

To avoid potential shorts in the electrical

system, be sure to disconnect the (–) bat-

tery cable before installation. Use this unit

with a 12-Volt battery and negative ground-

ing only. Failure to do so may result in a

re or malfunction.

SPEAKER MOUNTING SUGGESTIONS

QUICK START GUIDE

SPECIFICATIONS

WIRE DIAGRAM

8.65”

(220mm)

32.20”

(818mm)

14.20”

(361mm

20A

Fuse and fuse holder

(not included)

Chassis

ground

point

BATTERY

Mini-DIN

Connector

Fuse is located inside the power adaptor

Turn counter clockwise to open

Replace with 15A AGC Fuse type only

INSERT

Normally open switch

(not included)

INSERT

OPTIONAL DIRECT BATTERY WIRING CIRCUIT

RED

BLACK

Chassis

ground

point

QUICK RELEASE

POWER ADAPTOR

(INCLUDED)

POWER ADAPTOR

15A

Ground wire

Metal frame

Recommended 12 ~ 14ga Wire

(not included)

Align arrows

(Cable not included)

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Route strap

through the hole

and to vehicle

frame

Route strap

around the speaker body to vehicle frame

Route strap

through the hole

and to vehicle

frame

CAUTION!!

Mounting straps should be double checked to be sure they are

pulled tight and secure before each use of the vehicle.

MFC - MULTIFUNCTION CONTROLLER

POWER ON - Press and hold for 3 second

NEXT TRACK

PLAY/PAUSE

BLUETOOTH PAIRING - BLUE COLOR

PREVIOUS TRACK

VOL DOWN

VOL UP

3.5mmAUX-IN

CABLE NOT INCLUDED

1A USB

CHARGING

NOT FOR AUDIO PLAYBACK

MULTIFUNCTION CONTROLLER BLUETOOTH OPERATION

1) Press the 4 PLAY/PAUSE PLAYonce to start playing music or press the button from

your devices touch screen

2) To skip songs or advance, press the 3NEXT TRACK button

3) To select the previous song, press the 6PREVIOUS TRACK button

VOLUME CONTROL

4) To raise the volume press the 8 VOL UP button

5) To lower the volume press the 7 button VOL DOWN

MULTIFUNCTION CONTROLLER AUX-IN OPERATION

1) Power on the ATVB90 by pressing and holding down the 2POWER button for

3 seconds

2) Disconnect any paired in your devices Bluetooth Bluetooth device by turning o

Settings Menu

3) Connect your 3.5mm cable located on the front of the to your devices AUX-IN MFC

headphone jack, the LED will illuminate color when in modeRED AUX-IN

4) Route the wire back to the , secure your device in a safe positionMFC

VOLUME CONTROL

5) To raise the volume press the 8 VOL UP button

6) To lower the volume press the 7 button VOL DOWN

7) To MUTE the volume press the 4 PLAY/PAUSE button

ATVB90 can play audio

from any device that has a

3.5mm headphone audio jack.

YOUR DEVICE 8

BLUETOOTH

• Version: 3.0 w/ EDR

• A2DP / AVRCP

• Range: 33ft (10m) Class 2

SPEAKERS

• Dimensions: 8”

• Impedance: 4Ω + 4Ω

• Cone Type: PP CARBON + RESIN CLOTH

• Tweeter Size: 1” PEI SOFT DOME

AMPLIFIER

• Maximum Output Power: 700 Watts

• Class: AB

• Input impedance: 10kΩ

• Frequency Response: 45Hz-25kHz

GENERAL

• Operational Power: 14.4VDC (10-16V allowable)

• MAX Current Draw: 13.7A

• USB Charging: 1A @ 5VDC +/- 5%

• Replacement Fuse: 15A AGC TYPE

• Color: Black

• Weight: 16.50lbs / 7.48Kg

• Dimensions cm WxHxD: 81.80 x 21.97 x 36.07

• Dimensions Inches WxHxD: 32.20 x 8.65 x 14.20

• Storage Temperature: 5oF to 113oF / -15oC to 45oC

• Operation Temperature: 14 oF to 140oF / -10oC to 60oC

LIFT TO OPEN

ALWAYS CLOSE WHEN NOT IN USE

NEVER USE AUX-IN WHEN IN MUD or WATER

Produkt Specifikationer

Mærke:	Boss
Kategori:	Højttaler
Model:	ATVB90

Har du brug for hjælp?

Hvis du har brug for hjælp til Boss ATVB90 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Højttaler Boss Manualer

Boss BOLT Manual

16 December 2024

Boss BEHDIN98 Manual

3 September 2024

Boss MC625BA Manual

22 August 2024

Boss MCBC425BA Manual

22 August 2024

Boss MCBK475BA Manual

20 August 2024

Boss MCBK625BA Manual

19 August 2024

Boss MCBK425BA Manual

19 August 2024

Boss MR52W Manual

17 August 2024

Boss MC475BA Manual

17 August 2024

Boss MC425BA Manual

17 August 2024

Højttaler Manualer

Nyeste Højttaler Manualer

Nikkei NWS04 Manual

17 December 2024

Denon DJ SM50 Manual

17 December 2024

Audac CIRA724I Manual

17 December 2024

Audac ATEO6M Manual

17 December 2024

Coastal Source EB102W710BN Manual

17 December 2024

Coastal Source B10SW8BN Manual

17 December 2024

Coastal Source EB82W6.5BN Manual

17 December 2024

NGS WILD Space 2 Manual

17 December 2024

Canton Chrono SL 520.2 Manual

16 December 2024

Canton GLE 456 Center Manual

16 December 2024