Boss DC-2W Manual

Boss Ikke kategoriseret DC-2W

Læs nedenfor 📖 manual på dansk for Boss DC-2W (1 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/1
Owner’s Manual
S/SDD-320 switch
Switches the sound variation.
S (Standard)
Reproduces the sound of the original DC-2.
SDD-320
Reproduces a sparkling sound of the SDD-320.
MODE SELECTOR [1]–[4] buttons
Select the sound. Higher numbers produce a deeper eect.
By pressing two buttons simultaneously you can combine the eects.
Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (supplied on a separate sheet).
After reading, keep the document(s) where it will be available for immediate reference.
Precautions When Connecting
5 To prevent malfunction and equipment failure, always turn
down the volume, and turn o all the units before making any
connections.
5 Once everything is properly connected, be sure to follow the
procedure below to turn on their power. If you turn on equipment
in the wrong order, you risk causing malfunction or equipment
failure.
When powering up: Turn on the power to your guitar amp last.
When powering down: Turn o the power to your guitar amp rst.
5 Before turning the unit on/o, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/o. However, this is normal and
does not indicate a malfunction.
Use of Battery
5 The life of the included battery may be limited as its primary
purpose was for testing during assembly.
5 If you handle batteries improperly, you risk explosion and uid
leakage. Make sure that you carefully observe all of the items
related to batteries that are listed in “USING THE UNIT SAFELY” and
“IMPORTANT NOTES” (supplied on a separate sheet).
5 When operating on battery power only, the unit’s indicator will
become dim when battery power gets too low. Replace the
battery as soon as possible.
5 Batteries should always be installed or replaced before connecting
any other devices. This way, you can prevent malfunction and
damage.
5 If operating this unit on battery, please use alkaline battery.
Changing the Battery
1. Hold down the
pedal and loosen
the thumbscrew,
then open the
pedal upward.
* The pedal can be
opened without
detaching the
thumbscrew
completely.
2. Remove the old battery from the battery housing, and
remove the snap cord connected to it.
3. Connect the snap cord to the new battery, and place
the battery inside the battery housing.
* Be sure to carefully observe the battery’s polarity (+ versus -).
4. Slip the coil spring onto the spring base on the back of
the pedal, and then close the pedal.
* Carefully avoid getting the snap cord caught in the pedal, coil
spring, and battery housing.
5. Finally, hold down the pedal while tightening the
thumbscrew into the guide bush hole.
OUTPUT Jacks
Mono output
Eect sound
Stereo output
Eect sound (R)Eect sound (L)
MEMO
The audio output of this unit does not support mono mix (stereo input /
mono output).
To obtain the optimal Dimension eect, we recommend that you use the
unit with stereo output.
Specications
Nominal Input Level -20 dBu
Input Impedance 2.2 MΩ
Nominal Output
Level -20 dBu
Output Impedance 1 kΩ
Recommended Load
Impedance 10 kΩ or greater
Power Supply Alkaline battery (9 V, 6LR61)
AC adaptor (PSA series: sold separately)
Current Draw 65 mA
* Expected battery life under continuous use:
Alkaline: 6 hours
These gures will vary depending on the
actual conditions of use.
Dimensions 73 (W) x 129 (D) x 59 (H) mm
2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inches
Weight 450 g / 1lb (including battery)
Accessories Leaet (“USING THE UNIT SAFELY,” “IMPORTANT
NOTES,” and “Information”)
Alkaline battery (9 V, 6LR61)
Options
(sold separately) AC adaptor (PSA-series)
* 0 dBu = 0.775 Vrms
* This document explains the specications of the product at the
time that the document was issued. For the latest information,
refer to the Roland website.
Intellectual Property Right
5 Roland, BOSS, and WAZA CRAFT are either registered
trademarks or trademarks of Roland Corporation in the United
States and/or other countries.
Thumbscrew
Battery Housing
Pedal
Spring Base
Coil Spring
Guide Bush
Hole
Battery Snap
Cord
Battery
Snap
9 V Battery
Thumbscrew
When this screw is loosened, the
pedal will open, allowing you to
change the battery.
* For instructions on changing
the battery, refer to “Changing
the Battery.”
AC Adaptor
(PSA series; sold separately)
Electric Guitar
Electronic Musical Instrument
(e.g., keyboards)
English
7This is a WAZA CRAFT series eect pedal crafted with a high-quality analog original circuit design.
7The “Dimension” eect add unique natural spaciousness and rich depth to your sound.
7This pedal also reproduces the sound of “SDD-320 Dimension D” used by countless recording studios, providing a more sparkling sound.
Main Features
Panel Descriptions
DC IN jack
In addition to 9-volt battery operation, this unit can also operate on a 9-volt AC adaptor (BOSS PSA series;
sold separately).
* Use only the specied AC adaptor (PSA series; sold separately), and connect it to an AC outlet of the
correct voltage.
* If the AC adaptor is connected while a battery is installed, the power
supply is drawn from the AC adaptor.
CHECK indicator
This indicator shows whether the eect is ON/OFF, and also doubles as the battery check
indicator. The indicator lights when the eect is ON.
* The brightness of the CHECK indicator (LED) will dim as the battery lowers. Replace the
battery when the LED is dim or does not light. For instructions, refer to “Changing the
Battery.”
Pedal switch
This switch turns the eect on/o.
OUTPUT B jack
Use this jack for stereo output.
By using this in conjunction with the
OUTPUT A (MONO) jack you can obtain
spacious sound.
OUTPUT A (MONO) jack
Outputs the eect sound in mono.
INPUT jack
Connect the output of your
electric guitar, electronic
musical instrument, or eect
unit to this jack.
* The INPUT A (MONO) jack
doubles as the power
switch. Power to the unit
is turned on when you
plug into the INPUT A
(MONO) jack; the power is
turned o when the cable
is unplugged. To prevent
unnecessary battery
consumption, be sure to
disconnect the plug from
the INPUT A (MONO) jack
when not using the eects
unit.
© 2018 Roland Corporation 03
Guitar Amplier
Guitar Amplier
5 CMSIS-RTOS RTX Version 4.70.1
Copyright (c) 1999-2009 KEIL, 2009-2015 ARM Germany GmbH All
rights reserved.
Redistribution and use in source and binary forms, with or without
modication, are permitted provided that the following conditions
are met:
7Redistributions of source code must retain the above copyright
notice, this list of conditions and the following disclaimer.
7Redistributions in binary form must reproduce the above copyright
notice, this list of conditions and the following disclaimer in
the documentation and/or other materials provided with the
distribution.
7Neither the name of ARM nor the names of its contributors may be
used to endorse or promote products derived from this software
without specic prior written permission.
THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND
CONTRIBUTORS “AS IS” AND ANY EXPRESS OR IMPLIED WARRANTIES,
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
ARE DISCLAIMED. IN NO EVENT SHALL COPYRIGHT HOLDERS AND
CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES;
LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR
OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE,
EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
For the USA
SUPPLIER’S DECLARATION OF
CONFORMITY
Compliance Information Statement
Model Name :
Type of Equipment :
Responsible Party :
Address :
Telephone :
DC-2W
Guitar Eects
Roland Corporation U.S.
5100 S. Eastern Avenue Los Angeles,
CA 90040-2938
(323) 890-3700

Produkt Specifikationer

Mærke: Boss
Kategori: Ikke kategoriseret
Model: DC-2W

Har du brug for hjælp?

Hvis du har brug for hjælp til Boss DC-2W stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Boss Manualer

Boss

Boss BC-1X Manual

16 December 2024
Boss

Boss Super Chorus CH-1 Manual

16 December 2024
Boss

Boss Bass Equalizer GEB-7 Manual

16 December 2024
Boss

Boss Turbo Distortion DS-2 Manual

16 December 2024
Boss

Boss Multi Overtone MO-2 Manual

16 December 2024
Boss

Boss Tera Echo TE-2 Manual

16 December 2024
Boss

Boss Metal Core ML-2 Manual

16 December 2024
Boss

Boss Delay DM-2W Manual

16 December 2024
Boss

Boss NS-1X Manual

17 November 2024
Boss

Boss GT-1B Manual

17 November 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Atlona

Atlona AT-DVIF30S-IR Manual

29 December 2024
Atlona

Atlona AT-PRO3HD66M Manual

29 December 2024
Atlona

Atlona AT-3GSDI500 Manual

29 December 2024
BlueBuilt

BlueBuilt BBMAG2M Manual

29 December 2024
Atlona

Atlona AT-3GSDI-14 Manual

28 December 2024
Atlona

Atlona AT-COMP10SS Manual

28 December 2024
Atlona

Atlona AT-2VGA300SL Manual

28 December 2024
Atlona

Atlona AT-HD-V216 Manual

28 December 2024
Atlona

Atlona AT-VGA11S Manual

28 December 2024
True

True TC900 Manual

28 December 2024