Boss MR500UAB Manual

Boss Ikke kategoriseret MR500UAB

Læs nedenfor 📖 manual på dansk for Boss MR500UAB (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

Push-To-Talk

Press the icon button (VOL knob) to access to smartphone voice

assistant capability via Bluetooth.

Adjust Menu Options (SEL)

• Press and hold the SEL button (volume knob) to enter into setting menu,

then press the SEL button (volume knob) repeatedly to select setting items:

- ILL MID/HI/LOW: This receiver is equipped with 3 brightness settings.

Rotate the volume knob to preset the illumination to middle, high or low.

- BASS/TREBLE:-7, -6, ~, 1, 0, +1,~, +6, +7

Note: BASS and TREBLE settings are only enabled when EQ setting is turned OFF.

- BALANCE:L7, L6,~, L1, 0, R1,~,R6, R7

- FADER:R7, R6, ~, R1, 0, F1, ~ ,F6, F7

- Loudness: LOUD ON/OFF

- EQ(Equalizer) Setting: OFF, FLAT, CLASSIC, POP, ROCK, JAZZ

- Stereo/Mono: Switches between MONO and STEREO reception mode

for radio frequencies.

- DX/LOCAL: Enables or disables the local broadcast mode (LOCAL).

- CLOCK 12/24: Select between 12 hours and 24 hours display.

- AREA US/EU: This car radio is equipped the USA / Europe frequency.

Rotate the volume knob to switch between USA and Europe frequency.

The system will change the frequency setting in about 3 seconds.

• Rotate the VOL knob to change values.

Clock display, Clock setting

Press the button, CLOCK CLOCK button to display time. Press and hold the

the hours digits start flashing on the display. Set hours by rotating the VOL

knob. Briefly press the CLOCK button, the minute digits start flashing.

Set minutes by rotating the knob.VOL

Mute On/Off

Press the button to toggle mute on or off. MUTE

USB Port

Connect to a USB storage device for audio play, or charging of a mobile

phone.

Hands-free Microphone

To receive your voice when you calling by using this bluetooth handsfree

system.

Aux Audio Input Jack

Connect to the headphone jack on an external device (e.g. a mobile phone

or MP3 player) for audio play.

Installation

Connect all wiring harness and slide the head unit into the

mounting sleeve until it clicks into place.

Turn Unit on/off, Change the Source

• Press the button to turun on the unit. Press and hold the OFF/SRC OFF/

SRC button to turn off the unit.

• Press the button to select the different modes: Radio, USB(withOFF/SRC

USB device inserted) and BT(Bluetooth) modes.

Adjust the volume (VOL)

Rotate the VOL knob to increase or decrease the volume level.

- Only support speakers of 4 ohms or above.

- +12V DC Negative Ground.

- The maximum current of the Amp remote trigger is 200mA.

Wiring Connections

Overview of the Components

General Operation

General Operation General Operation

Radio Operation

Switch Between USA area and Europe area Frequency

In radio mode, press and hold the SEL button (volume knob) to enter into

setting menu, then press the SEL button (volume knob) repeatedly to access

the state of the USA and Europe frequency, then rotate the volume knob to

switch between USA and europe frequency. The system will change the

frequency setting in about 3 seconds.

Change Bands

In radio mode, shortly press the button to switch between the FM1BAND

(F1), FM2(F2), FM3(F3) and AM1(A1), AM2(A2) bands.

To Store / Recall Preset Stations

The radio can be stored 6 preset stations for each band (FM1, FM2, FM3,

AM1 and AM2) for a total of 30 preset stations.

- To memorize a station:

Press and hold the desired preset buttons (1-6) to save a radio station.

- To recall a preset station:

Briefly press the respective station button (1-6) to recall the corresponding

preset station.

Manual Tuning

In the radio mode:

Press and hold the or button to enter the manual tuning mode.

In manual tuning mode, briefly press the or button to search the next

or previous frequency step by step.

Seek Tuning

In radio mode, press the or button, the automatic search will start, it

will search upward or downward for the strong signal radio station within the

current band. The auto searching will stop until find a station.

Automatic Store Station / preset station scan

Press and hold the button to store 18 FM stations and 12 AM stations

automatically.

ANT F-R R-R

F-L R-L

Radio Antenna

White

Front Left

Speaker

Rear Left

Speaker

Front Right

Speaker

Rear Right

Speaker

White/Black

ACC + (Red)

GND - (Black)

ANT + (Blue)

Power B+ (Yellow)

Gray/Black

Purple

Purple/Black

Green

Green/Black

Gray

Red: Front Right PRE-AMP Output

White: Front Left PRE-AMP Output

White: Rear Left PRE-AMP Output

Red: Rear Right PRE-AMP Output

Installation

Installation Procedures

First complete the electrical connections and then check for correctness of

connection.

Insert the mounting sleeve into the dashboard. Then bend the tabs

on the mounting sleeve with a screwdriver to achieve fastening of

the mounting sleeve.

Make sure that lock lever is flush with the mounting sleeve( not

projecting outward).

Installation Opening

This unit can be installed in any dashboard which has an opening as shown

below.

2.05 inches

7.20 inches

B ket keyrac

Mounting sleeve

B ket keyrac Plastic trim out

Reset

Push the RESET button with a thin object with a pointed end to reset the unit.

This function may be used when the LCD does not display normally or

sound is distorted, or when any of controls are disabled.

1. (pause/play), Preset station 1 button

2. INT (intro), Preset station 2 button

3. IR remote sensor

4. VOL(volume) knob, SEL(select/menu) button

5. LCD Display

6. BAND button, (automatic store station, automatic music search) button

7. -OFF(power on/off) / SRC(source) button

8. RDM (random), Preset station 4 button

9. RPT (repeat), Preset station 3 button

10. -10(previous 10 tracks), DIR- (previous folder), Preset station 5 button

11. +10(next 10 tracks), DIR+(next folder), Preset station 6 button

12. CLOCK(Clock display, Clock setting) button

13. MUTE button

14. Hands-free Microphone

15. Reset button

16. (Push-To-Talk) button

17. (Answer Call / End Call) button

18. (tune/seek down, previous track, fast reverse) button

19. (tune/ seek up, next track, fast forward) button

20. USB Port

Produkt Specifikationer

Mærke:	Boss
Kategori:	Ikke kategoriseret
Model:	MR500UAB

Har du brug for hjælp?

Hvis du har brug for hjælp til Boss MR500UAB stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Boss Manualer

17 November 2024

17 November 2024

3 September 2024

2 September 2024

Boss Gigcaster 8 GSC-8 Manual

1 September 2024

Boss TU-80 Manual

31 August 2024

Boss Reverb RV-6 Manual

31 August 2024

Boss Reverb RV-200 Manual

28 August 2024

Boss GKC-AD Manual

25 August 2024

Boss SDE-3000D Manual

25 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Elektron Overbridge Manual

26 November 2024

Elektron Sidstation Manual

26 November 2024

SKROSS World Adapter Pro+ Manual

26 November 2024

SKROSS PRO – World & USB Manual

26 November 2024

SoundTube IPD-RS82-EZ Manual

26 November 2024

Kramer 4x1VB Manual

26 November 2024

Kramer RC-63A Manual

26 November 2024

SoundTube IPD-HP82-EZ Manual

26 November 2024

Kramer RK-KVM-1U-PP3 Manual

26 November 2024

Gioteck VX-2 (PS3) Manual

26 November 2024