Botex PDB-4 5P Manual
Læs nedenfor 📖 manual på dansk for Botex PDB-4 5P (1 sider) i kategorien Splitter. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/1
Thomann GmbH
Hans-Thomann-Straße 1 • 96138 Burgebrach
Germany • www.thomann.de
DocID: 469653_04.03.2020
EN
PDB-4 5P Power DMX Box
Features
1-in-4 power and DMX splitter
Ideal combination for the distribution of power and
DMX signals on stage, in a rig or for xed installations
Robust metal housing with two M10 threads on the
top
Compact and lightweight design
DMX input: XLR 5-pin
4×DMX output: XLR 5-pin
Power input: Power Twist
4×current output: Power Twist
Technical specications
Power supply: 230V ~ 50Hz
Power consumption: 5watt
Dimensions: 268×75×75mm
Weight: 1.26kg
Safety instructions
Intended use
This device is used to distribute power and DMX signals. Any other use
or use under other operating conditions is considered to be improper
and may result in personal injury or property damage. No liability will
be assumed for damages resulting from improper use.
Dangers for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are not
within reach of babies and young children. Choking hazard! Ensure that children
do not detach any small parts (e.g. knobs or the like) from the unit. They could
swallow the pieces and choke! Never let children unattended use electrical de-
vices.
Operating conditions
This device has been designed for indoor use only. To prevent damage, never
expose the device to any liquid or moisture. Avoid direct sunlight, heavy dirt,
and strong vibrations.
Risk of re if the maximum current is exceeded
The device can power other devices via a lockable Power Twist output socket.
The current consumption of all serially connected other devices must not ex-
ceed 10A, otherwise you risk injuries and irreparable damages of the device.
Connect just so many devices to the output socket that the maximum current
consumption is not exceeded.
Ensure the correct dimensioning (wire cross section) of the used power cords of
all serially connected devices.
Electric shock caused by high voltages inside
Within the device there are areas where high voltages may be present. Never
remove any covers. There are no user-serviceable parts inside.
Electric shock caused by short-circuit
Always use proper ready-made insulated mains cabling (power cord) with a
protective contact plug. Do not modify the mains cable or the plug. Failure to
do so could result in electric shock/death or re. If in doubt, seek advice from a
registered electrician.
Power supply
Before connecting the device, ensure that the input voltage (AC outlet) matches
the voltage rating of the device and that the AC outlet is protected by a residual
current circuit breaker. Failure to do so could result in damage to the device and
possibly injure the user.
Unplug the device before electrical storms occur and when it is unused for long
periods of time to reduce the risk of electric shock or re.
Handling the power cord
Do not place the device or speaker boxes or similar on the power cord and be
careful not to pinch it. Never tie a knot in the power cord or tie it with other
cables. Route the power cord so that no one steps on or trips over it. A damaged
power cord can cause a re or electric shock. Replace any broken cables.
Protecting the environment
For the transport and protective packaging, environmentally friendly
materials have been chosen that can be supplied to normal recycling.
Ensure that plastic bags, packaging, etc. are properly disposed of. Do not
just dispose of these materials with your normal household waste, but
make sure that they are collected for recycling. Please follow the notes
and markings on the packaging.
This product is subject to the European Waste Electrical and Electronic
Equipment Directive (WEEE) in its currently valid version. Do not dispose
of your old device with your normal household waste. Dispose of this
product through an approved waste disposal rm or through your local
waste facility. Comply with the rules and regulations that apply in your
country. If in doubt, consult your local waste disposal facility.
Produkt Specifikationer
| Mærke: | Botex |
| Kategori: | Splitter |
| Model: | PDB-4 5P |
Har du brug for hjælp?
Hvis du har brug for hjælp til Botex PDB-4 5P stil et spørgsmål nedenfor, og andre brugere vil svare dig
Splitter Botex Manualer
20 August 2024
19 August 2024
18 August 2024
18 August 2024
Splitter Manualer
- Splitter Scheppach
- Splitter Samsung
- Splitter IFM
- Splitter Audio-Technica
- Splitter Behringer
- Splitter Zipper
- Splitter D-Link
- Splitter InFocus
- Splitter Nedis
- Splitter Abus
- Splitter Hyundai
- Splitter Black Box
- Splitter König
- Splitter Texas
- Splitter Gembird
- Splitter NewStar
- Splitter Tripp Lite
- Splitter Mercury
- Splitter Digitus
- Splitter Fujitsu
- Splitter Marmitek
- Splitter APC
- Splitter LevelOne
- Splitter Monacor
- Splitter Sun Joe
- Splitter Radial Engineering
- Splitter Furuno
- Splitter Manhattan
- Splitter Kramer
- Splitter Ideal
- Splitter Audiovox
- Splitter MuxLab
- Splitter Akasa
- Splitter Xantech
- Splitter ATen
- Splitter Shure
- Splitter Aluratek
- Splitter Smart-AVI
- Splitter StarTech.com
- Splitter Crestron
- Splitter Lindy
- Splitter Rolls
- Splitter AMX
- Splitter Comprehensive
- Splitter Key Digital
- Splitter KanexPro
- Splitter Gefen
- Splitter C2G
- Splitter WyreStorm
- Splitter Icy Box
- Splitter ACG
- Splitter SIIG
- Splitter Televés
- Splitter Palmer
- Splitter Rose Electronics
- Splitter SmartAVI
- Splitter Rane
- Splitter Klover
- Splitter Atlona
- Splitter Omnitron Systems
- Splitter Club 3D
- Splitter CLUB3D
Nyeste Splitter Manualer
21 December 2024
21 December 2024
19 December 2024
19 December 2024
13 December 2024
9 December 2024
9 December 2024
9 December 2024
6 December 2024
6 December 2024