Cambridge Minx Go V2 Manual

Cambridge Højttaler Minx Go V2

Læs nedenfor 📖 manual på dansk for Cambridge Minx Go V2 (1 sider) i kategorien Højttaler. Denne guide var nyttig for 12 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
Successful pairing will be signalled by a ‘beep’ from the unit and the
LED will stop flashing.
Pairing a second device
The charging LED will indicate orange whilst charging and
green when fully charged.
Press and hold the power button on the top of the unit for two
seconds to turn it on.
Battery Safety
Your Go contains a high performance battery and charging system that is
designed to work in temperatures that do not exceed 50°C (122°F). Leaving
this product in an automobile where temperatures may exceed this limit may
result in permanent battery damage, fire or explosion. Do not leave your
product in any location where temperatures may exceed this limit. Please
recharge the battery every two months to maintain the battery in optimal
condition.
Bluetooth set-up
Press the button to select the Bluetooth input.
To pair a different device, press and hold the button for two seconds to
enter pairing mode and pair your Bluetooth device as described in the
Bluetooth instructions.
1.
2.
Press and hold the button for two seconds to enter Bluetooth pairing
mode. The flashing blue LED, indicates pairing mode.
Enable Bluetooth connectivity on your Bluetooth device (eg. phone, tablet
etc) and pair with the Go (you may need to consult your phone or tablet
operating instructions).
Pairing Your Device Manually
User manual
To talk call + to us, 44 (0 514 5 )203 1 21 (UK Local)
or 1-87 -3 7-8204 (USA 7 5 )
Auto power down
To save power, your Go will automatically turn off after 30 minutes if no
music is playing. Press the power button to turn the Go back on.
Low battery warning
A flashing red LED indicates that the battery is too low and the Go will
enter a standby mode where no music can be played. This LED will
continue flashing for 30 minutes after which the Go will turn off.
TOP TIPS
!
USB Charging
The Go can be used to charge compatible mobile devices. If the charging
adaptor is not connected this will drain the battery.
Important !
Connect the charging adaptor to the Go and charge for
4 hours before first use.
You may need to ensure Bluetooth is enabled on
your device.
Touch your NFC device against the logo on
top of the Go.
Go will enter automatic pairing mode and
‘Go’ should appear on your device.
NFC
1.
2.
If your Bluetooth device is NFC enabled
GOPORTABLE BLUETOOTH
SPEAKER
Aux input
Press the button to select the Aux input. There is an Aux input
on the rear of the unit that allows any analogue device to be connected.
LED will turn green to indicate Aux input is selected.


Produkt Specifikationer

Mærke: Cambridge
Kategori: Højttaler
Model: Minx Go V2

Har du brug for hjælp?

Hvis du har brug for hjælp til Cambridge Minx Go V2 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Højttaler Cambridge Manualer

Cambridge

Cambridge SX-120 Manual

26 Februar 2024
Cambridge

Cambridge SX-80 Manual

8 Februar 2024
Cambridge

Cambridge Aero 3 Manual

7 Januar 2024
Cambridge

Cambridge Minx XL Manual

20 December 2023
Cambridge

Cambridge X301 Manual

16 December 2023
Cambridge

Cambridge Yoyo (L) Manual

12 December 2023
Cambridge

Cambridge Aero 5 Manual

27 September 2023
Cambridge

Cambridge S50 Manual

21 September 2023

Højttaler Manualer

Nyeste Højttaler Manualer