Canarm LBL167A10WACBK Manual

Canarm Verlichting LBL167A10WACBK

Læs nedenfor 📖 manual på dansk for Canarm LBL167A10WACBK (2 sider) i kategorien Verlichting. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
LED OUTDOOR
LIGHTING
INSTALLATION:
LBL167A10WACBK
01/19
Tel: (613) 342-5424, Fax: (800) 263-4598
1. Mount the mounting
bracket to outlet box using
outlet box screws (not
included). Make sure the studs
on the mounting bracket are
facing out from the outlet box.
2. Connect the ground wires
(bare copper or green) from
your fixture to the ground wire
(bare copper or green) or
ground screw in the electrical
outlet box. Connect black wire
from fixture to black wire in
outlet box and connect the
white wire from fixture to
white wire in outlet box.
NOTE: Do not disconnect any
pre-wired connections.
3. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
outlet box making sure no
bare wire is visible at the wire
nuts.
4. Install the light fixture to
the wall by aligning the
hole(s) in the fixture with the
studs on the mounting
bracket. Secure in place with
cap nut(s) and star washer (s).
5. After Installation, seal
around the top and side
perimeter between the
fixture and the wall surface
with weather resistant
caulking. The bottom should
be left un-caulked to prevent
moisture build-up. Apply a
small amount of weather
resistant caulking around the
side perimeter between the
cap nut and mounting plate.
Mounting
Bracket
Outlet
Box
Outlet Box Screws
(not included)
Studs
White
Black
House supply
Ground wire
Fixture
Ground wire
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver Wire Cutters
Pliers Wrench
Wiring supplies
as required by
local electrical
code
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN A ORDANCE WITH THE APPLICABLE INSTALLATION CC
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
4. NOT FOR USE IN LUMINAIRES CONTROLLED BY A DIMMER.
5. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH
A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
Weather Resistant
Caulking
(not included)
Weather Resistant
Caulking
(not included)
Star
Washer
Cap Nut


Produkt Specifikationer

Mærke: Canarm
Kategori: Verlichting
Model: LBL167A10WACBK

Har du brug for hjælp?

Hvis du har brug for hjælp til Canarm LBL167A10WACBK stil et spørgsmål nedenfor, og andre brugere vil svare dig




Verlichting Canarm Manualer

Canarm

Canarm LBL167A14WACBK Manual

26 September 2024
Canarm

Canarm LBL167A10WACBK Manual

26 September 2024

Verlichting Manualer

Nyeste Verlichting Manualer