Casablanca 99019 Manual

Casablanca Ikke kategoriseret 99019

Læs nedenfor 📖 manual på dansk for Casablanca 99019 (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 7 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

www.CasablancaFanCo.com 1.888.227.2178

M6009-01 • 06/26/12 • © Casablanca Fan Company

Model #99019

Universal

Remote Control

Transmitter &

Receiver

Installation

Wiring

OR OR OR

OFF

Remove the canopy. If uncertain

how to remove it, reference the fan’s

owner’s manual. With wiring exposed,

it may be helpful to note existing wire

connections or take a digital photo for

reference. Remove the wire connectors

that were connecting the wires from

the outlet box to the fan, leaving the

grounding wires connected.

CONNECT WIRES FROM RECEIVER TO FAN -Using the blue wire connectors connect the white wire from the

receiver (marked “common out”) to the white wire from fan. Connect the black wire from the receiver (marked

“fan out”) to the black wire from the fan. Connect the blue wire from the receiver (marked ”light out”) to the

blue wire (or possibly black with white stripe) from the fan.

Note: The red wire from the receiver has a pre-installed wire terminator. It is for fans with an optional up light;

otherwise it will not be used. Maximum 120 watts.

If you’re uncertain about wire colors or connections, please contact a qualied electrician.

CONNECT WIRES FROM RECEIVER TO WIRES FROM OUTLET BOX - Using an orange wire connector connect

the black wire (ungrounded) from the ceiling to the black wire from the receiver (marked “live in”). Connect

the white wire (grounded) from the ceiling to the white wire from the receiver (marked “neutral in”).

AFTER ALL WIRES ARE CONNECTED and secured with wire connectors, re-install the canopy.

Before installing the Universal Remote

Control Receiver, use the pull chains to

set the fan speed to HIGH and the light

to ON. Be sure power is OFF before

proceeding with installation.

Choose the hanging system that most closely resembles the one used by your fan and install the receiver and wire as directed.

Note: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire, leaving a minimum of 8” remaining. Re-strip the fan lead wires 1/2”. Place remaining excess