Casio Collection W-753-2AVES Manual

Casio Ur Collection W-753-2AVES

Læs nedenfor 📖 manual på dansk for Casio Collection W-753-2AVES (4 sider) i kategorien Ur. Denne guide var nyttig for 15 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/4
Operation Guide 2926
1
MO0503-EB
Getting Acquainted
Congratulations upon your selection of this CASIO watch. To get the most out of your
purchase, be sure to read this manual carefully and keep it on hand for later reference
when necessary.
Warning!
•The longitude, lunitidal interval, Moon phase indicator, tide graph data, and solar
azimuth data that appear on the display of this watch are not intended for
navigation purposes. Always use proper instruments and resources to obtain data
for navigation purposes.
•This watch is not an instrument for calculating low tide and high tide times. The
tide graph of this watch is intended to provide a reasonable approximation of tidal
movements only.
•When engaging in mountain climbing or other activities in which losing your way
can create a dangerous or life-threatening situation, always be sure to use a
second compass to confirm direction readings.
•CASIO COMPUTER CO., LTD. assumes no responsibility for any loss, or any
claims by third parties that may arise through the use of this watch.
About This Manual
•Button operations are indicated using the letters shown
in the illustration.
•Each section of this manual provides you with the
information you need to perform operations in each
mode. Further details and technical information can be
found in the “Reference” section.
(Light)
General Guide
•The illustration below shows which buttons you need to press to navigate between
modes.
•In any mode, press L to illuminate the display.
Moon / Tide Data Mode Countdown Timer Mode
Dual Time Mode
Timekeeping Mode
▲
▲
▲
Alarm Mode
▲
▲
Stopwatch Mode
Press C.
▲
Press .B
▲
Bearing Mode
Press .C
▲
Timekeeping
Use the Timekeeping Mode to set and view the current
time and date.
•The tide graph shows tidal movements for the current
date in accordance with the current time as kept in the
Timekeeping Mode.
•The Moon phase indicator shows the current Moon
phase in accordance with the current date as kept in the
Timekeeping Mode.
Important!
•Moon phase, tide graph data, Bearing Mode solar
azimuth data, and Moon/Tide Data Mode data will not
be displayed properly unless the Timekeeping Mode
current date and time settings and Home Site data are
configured correctly. See “Home Site Data” for more
information.
Day of week
Month – Day
Hour : Minutes Seconds
PM
indicator
Tide graph
Moon phase indicator
To set the time and date
1. In the Timekeeping Mode, hold down A until the
seconds start to flash, which indicates the setting
screen.
2. Press C to move the flashing in the sequence shown
below to select other settings.
Hour
Seconds
12/24-Hour
Format
Day Month Year
Minutes
3. When the setting you want to change is flashing, use D B and to change it as
described below.
|
|
|
|
|
|
|
|
|
|
|
|
|
Year
To change this setting
Seconds
Hour, Minutes, Year,
Month, Day
12/24-Hour Format
Perform this button operation
Press .D to reset to 00
Use D(+) and B(–) to change the setting.
Press D to toggle between 12-hour (12H) and
24-hour ( ) timekeeping.24H
4. Press A twice to exit the setting screen.
•The first press of A displays the GMT differential setting screen. Pressing A again
exits the setting screen.
•The 12-hour/24-hour timekeeping format you select in the Timekeeping Mode is
applied in all modes.
•The day of the week is displayed automatically in accordance with the date (year,
month, and day) settings.
Home Site Data
Tide graph data and Bearing Mode solar azimuth data will not be displayed properly
unless Home Site data (GMT differential, longitude, and lunitidal interval) is configured
correctly.
•The GMT differential is the time difference of the time zone where the site is located
from Greenwich Mean Time.
•Note that you must add one hour to the GMT differential for your time zone
whenever you change to Daylight Saving Time. Subtract one hour when you change
back to Standard Time.
•The lunitidal interval is the time elapsing between the Moon’s transit over a meridian
and the next high tide at that meridian. See “Lunitidal Interval” for more information.
•This watch displays lunitidal intervals in terms of hours and minutes.
•The “Site/Lunitidal Interval Data List” provides GMT differential, longitude, and
lunitidal interval information around the world.
•The following is the initial factory default Home Site data (Tokyo, Japan) when you
first purchase the watch and whenever you have the battery replaced. Change these
settings to match the area where you normally use the watch.
GMT differential (+9.0); Longitude (East 140 degrees); Lunitidal interval (5 hours,
20 minutes)
To configure Home Site data
1. In the Timekeeping Mode, hold down A until the
seconds start to flash, which indicates the setting
screen.
2. Press A again to display the GMT differential setting
screen.
3. Press C to move the flashing in the sequence shown
below to select other settings.
Lunitidal Interval
Hours Lunitidal Interval
Minutes
Longitude
GMT
Differential
4. When the setting you want to change is flashing, use and D B to change it as
described below.
GMT differential
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Setting
GMT Differential
Longitude
Lunitidal Interval
Hours, Minutes
Screen Button Operations
Use D(+) and B(–) to change the setting.
•Yo u can specify a value in the range of –11.0
to +14.0, in 0.5-hour units.
Use D(+) and B(–) to change the setting.
•Yo u can specify a value in the range of
179°W to 180°E, in 1-degree units.
Use D(+) and B(–) to change the setting.
5. Press A to exit the setting screen.
Bearing Mode
The Bearing Mode lets you determine approximate
directions using a displayed angle value that indicates the
angle to the sun (solar azimuth).
•All of the operations in this section are performed in the
Bearing Mode, which you can enter from the
Timekeeping Mode by pressing B.
Important!
Before the watch can calculate the solar azimuth (the
angle of the sun in relation to your location) correctly, you
must first set the correct current time, current date, and
Home Site in the Timekeeping Mode. You must also
specify whether the sun traverses the sky to the north or
to the south of your current position.
Solar azimuth
•Note that you cannot use the Bearing Mode to determine directions in the following
cases.
When the sun is not visibl
e
At night
When sun traverses the sky directly overhead or when you cannot determine if it
traverses to the north or south
To set the traverse direction of the sun
1. In the Bearing Mode, hold down A until N or S flashes
on the display. This indicates the setting screen.
2. Press D to toggle the setting between N (north) and S
(south).
3. Press A to exit the setting screen.
•At this time the watch uses the traverse direction setting
you just configured and the Timekeeping Mode data to
calculate and display the solar azimuth.
|
|
|
|
|
|
|
|
|
|
|
|
|

Produkt Specifikationer

Mærke: Casio
Kategori: Ur
Model: Collection W-753-2AVES

Har du brug for hjælp?

Hvis du har brug for hjælp til Casio Collection W-753-2AVES stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ur Casio Manualer

Casio

Casio Baby-G BGA-320 Manual

28 Oktober 2024
Casio

Casio Baby-G BGA-200-1E2ER Manual

6 Oktober 2024
Casio

Casio Edifice EFA-112D-1AVEF Manual

6 Oktober 2024
Casio

Casio BA-110DC-2A1 Manual

3 Oktober 2024
Casio

Casio MTP-1302D-7A1VEF Manual

30 September 2024
Casio

Casio Baby-G BG-5600WH-7ER Manual

29 September 2024
Casio

Casio Edifice EF-316D-1AVEF Manual

25 September 2024
Casio

Casio MTD-1064D-1AVEF Manual

22 September 2024
Casio

Casio DW-5600E-1VER Manual

20 September 2024
Casio

Casio G-Shock GMA-B800 Manual

20 September 2024

Ur Manualer

Nyeste Ur Manualer

Breitling

Breitling Chronomat 28 Manual

24 Oktober 2024
Jaguar

Jaguar J644 Manual

14 Oktober 2024
Rolex

Rolex Submariner Manual

8 Oktober 2024
Fossil

Fossil Q Explorist Gen 4 FTW4015 Manual

7 Oktober 2024
Auriol

Auriol IAN 67176 Manual

6 Oktober 2024
Citizen

Citizen Cal 411X Manual

6 Oktober 2024
Fossil

Fossil Q Venture Gen 4 FTW6012 Manual

6 Oktober 2024
TFA

TFA 60.3539.02 Manual

6 Oktober 2024
Spin Master

Spin Master Dumas SP-5081-11 Manual

4 Oktober 2024
Citizen

Citizen CAL B800 Manual

4 Oktober 2024