Casio PAG240 Manual

Casio Ur PAG240

Læs nedenfor 📖 manual på dansk for Casio PAG240 (10 sider) i kategorien Ur. Denne guide var nyttig for 13 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/10

Operation Guide 3173 3246

Congratulations upon your selection of this CASIO watch.

Applications

The built-in sensors of this watch measure direction, barometric pressure, temperature and altitude.

Measured values are then shown on the display. Such features make this watch useful when hiking,

mountain climbing, or when engaging in other such outdoor activities.

Warning !

• The measurement functions built into this watch are not intended for taking measurements that

require professional or industrial precision. Values produced by this watch should be considered

as reasonable representations only.

• When engaging in mountain climbing or other activities in which losing your way can create a

dangerous or life-threatening situation, always use a second compass to conﬁ rm direction

readings.

• Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any damage or loss

suffered by you or any third party arising through the use of this product or its malfunction.

About This Manual

• The operational procedures for Modules 3173 and 3246 are identical. All of the illustrations in this

manual show Module 3173.

• Depending on the model of your watch, display text appears either as dark ﬁ gures on a light

background, or light ﬁ gures on a dark background. All sample displays in this manual are shown using

dark ﬁ gures on a light background.

• Button operations are indicated using the letters shown in the illustration.

• Note that the product illustrations in this manual are intended for reference only, and so the actual

product may appear somewhat different than depicted by an illustration.

Things to check before using the watch

1. Check the battery power level.

Is “H” or “M” displayed for the battery power indicator?

Go to step 2.

Power is low. Charge the watch by placing it in a location

where it is exposed to light. For details, see “Charging the

Watch”.

NO YES

YES

Does any one of the following conditions exist?

• Battery power indicator shows “

L” and “LOW” is displayed in the

upper left corner of the screen.

• “C

” is displayed in the lower left corner of the screen.

• The face is blank.

The watch is charged

sufficiently.

For details about

charging, see

“Charging the Watch”.

Battery power

indicator

2. Check the Home City and the daylight saving time (DST) setting.

Use the procedure under “To conﬁ gure Home City settings” to conﬁ gure your Home City and daylight

saving time settings.

Important!

World Time Mode and Sunrise/Sunset Mode data depend on correct Home City, time, and date settings

in the Timekeeping Mode. Make sure you conﬁ gure these settings correctly.

3. Set the current time.

See “Conﬁ guring Current Time and Date Settings”.

The watch is now ready for use.

Charging the Watch

The face of the watch is a solar cell that generates power from light. The generated power charges a

built-in rechargeable battery, which powers watch operations. The watch charges whenever it is exposed

to light.

Charging Guide

Whenever you are not wearing the

watch, leave it in a location where it

is exposed to light.

• Best charging performance is

achieved by exposing the watch to

the strongest light available.

When wearing the watch, make sure

that its face is not blocked from light

by the sleeve of your clothing.

• The watch may enter a sleep state

if its face is blocked by your sleeve

even only partially.

Warning!

Leaving the watch in bright light for charging can cause it to become quite hot.

Take care when handling the watch to avoid burn injury. The watch can become particularly hot

when exposed to the following conditions for long periods.

• On the dashboard of a car parked in direct sunlight

• Too close to an incandescent lamp

• Under direct sunlight

Important!

• Allowing the watch to become very hot can cause its liquid crystal display to black out. The

appearance of the LCD should become normal again when the watch returns to a lower temperature.

• Turn on the watch’s Power Saving function and keep it in an area normally exposed to bright light when

storing it for long periods. This helps to ensure that power does not run down.

• Storing the watch for long periods in an area where there is no light or wearing it in such a way that it is

blocked from exposure to light can cause power to run down. Expose the watch to bright light

whenever possible.

(Light)(Light) (Light)

Module 3173

(Light)

Module 3246

(Light)(Light) (Light)

Module 3173

(Light)

Module 3246

Power Levels

You can get an idea of the watch’s power level by observing the battery power indicator on the display.

Level Battery Power Indicator Function Status

(H) All functions enabled.

(M) All functions enabled.

(L)

Illumination, beeper, and sensor operation

disabled.

(C)

Except for timekeeping and the

C (charge)

indicator, all functions and display

indicators disabled.

5 All functions disabled.

• The ﬂ ashing LOW indicator at Level 3 (

L) tells you that battery power is very low, and that exposure to

bright light for charging is required as soon as possible.

• At Level 5, all functions are disabled and settings return to their initial factory defaults. Once the battery

reaches Level 2 (M) after falling to Level 5, reconﬁ gure the current time, date, and other settings.

• Display indicators reappear as soon as the battery is charged from Level 5 to Level 2 (M).

• Leaving the watch exposed to direct sunlight or some other very strong light source can cause the

battery power indicator to show a reading temporarily that is higher than the actual battery level. The

correct battery level should be indicated after a few minutes.

• All data stored in memory is deleted, and the current time and all other settings return to their initial

factory defaults whenever battery power drops to Level 5 and when you have the battery replaced.

Power Recovery Mode

• Performing multiple sensor, illumination, or beeper operations during a short period may cause all of

the battery power indicators (H,M, and L) to start ﬂ ashing on the display. This indicates that the watch

is in the power recovery mode. Illumination, alarm, countdown timer alarm, hourly time signal, and

sensor operations will be disabled until battery power recovers.

• Battery power will recover in about 15 minutes. At this time, the battery power indicators (

H,M,L) will

stop ﬂ ashing. This indicates that the functions listed above are enabled again.

• If all of the battery power indicators (H,M,L) are ﬂ ashing and the

C (charge) indicator also is ﬂ ashing,

it means the battery level is very low. Expose the watch to bright light as soon as possible.

• Even if battery power is at Level 1 (

H) or Level 2 (M), the Digital Compass Mode, Barometer/

Thermometer Mode, or Altimeter Mode sensor may be disabled if there is not enough voltage available

to power it sufﬁ ciently. This is indicated when all of the battery power indicators (

H,M,L) are ﬂ ashing.

• Frequent ﬂ ashing of all of the battery power indicators (H

,M,L) probably means that remaining battery

power is low. Leave the watch in bright light to allow it to charge.

Charging Times

Exposure Level (Brightness)

Daily

Operation

Level Change *2

Level 5 Level 4 Level 3 Level 2 Level 1

Outdoor sunlight (50,000 lux) 5 min. 2 hours 12 hours 4 hours

Sunlight through a window (10,000 lux)

24 min. 5 hours 59 hours 16 hours

Daylight through a window on a

cloudy day (5,000 lux) 48 min. 9 hours 120 hours 32 hours

Indoor ﬂ uorescent lighting (500 lux) 8 hours 95 hours – – – – – –

*1 Approximate amount of exposure time required each day to generate enough power for normal daily

operation.

*2 Approximate amount of exposure time (in hours) required to take power from one level to the next.

• The above exposure times all are for reference only. Actual exposure times depend on lighting

conditions.

• For details about the operating time and daily operating conditions, see the “Power Supply” section of

the Speciﬁ cations.

Power Saving

When turned on, Power Saving enters a sleep state automatically whenever the watch is left for a certain

period in an area where it is dark. The table below shows how watch functions are affected by Power

Saving.

• There actually are two sleep state levels: “display sleep” and “function sleep”.

Elapsed Time in Dark Display Operation

60 to 70 minutes (display sleep) Blank, with

PS ﬂ ashing Display is off, but all functions are enabled.

6 or 7 days (function sleep) Blank, with

PS not ﬂ ashing All functions are disabled, but timekeeping is

maintained.

• The watch will not enter a sleep state between 6:00 AM and 9:59 PM. If the watch is already in a sleep

state when 6:00 AM arrives, however, it will remain in the sleep state.

• The watch will not enter a sleep state while it is in the Stopwatch Mode or Countdown Timer Mode.

To recover from the sleep state

Move the watch to a well-lit area, press any button, or angle the watch towards your face for reading.

To turn Power Saving on and off

1. In the Timekeeping Mode, hold down E until the currently selected

city code starts to ﬂ ash. This is the city code setting screen.

• Before the city code starts to ﬂ ash, the message SET Hold

will appear on the display. Keep E depre ssed un til SET Hold

disappears and the cit y code starts to ﬂ ash.

2. Use D to display the Power Saving On/Off screen shown nearby.

3. Press

A to toggle Power Saving on (

) and off ( OFF).

4. Press

E twice to exit the setting screen.

• The Power Savi ng on indicator (PS) is on the display in all modes

while Power Sav ing is tur ned on.

Battery power

indicator

Battery power

indicator

Power saving

on indicator

Power saving

on indicator

MO1007-EB

Produkt Specifikationer

Mærke:	Casio
Kategori:	Ur
Model:	PAG240
Bredde:	57.3 mm
Dybde:	50.9 mm
Højde:	15.3 mm
Vægt:	65.4 g
Armbånd, materiale:	Resin
Vandfast:	Ja
Kalender:	Ja
Ur-indstilling:	12t/24t
Stopur:	Ja
Elektronisk kompas:	Ja
Barometer:	Ja
Højdemåler:	Ja
Termometer:	Ja
Indikator for batteriniveau:	Ja
Urtype:	Armbåndsur
Batterilevetid:	0.5 År
Alarmfunktion:	Ja
Produktdesign:	Sport
Mekanismetype:	Tough solar
Kronometer:	Ingen
Se opkaldstype:	LCD-skive
Vandbestandigt tryk:	10 ATM
Vandbestandig dybde:	100 m
Husets farve:	Sort
Båndets hovedfarve:	Sort
Etui form:	Rund
Køn:	Unisex
Nøjagtighed:	15 sek/md
Kalendertype:	Dato
Kronograf:	Ingen
Nedtællingsur:	Ja
Verdenstid funktkon:	Ja