Chamberlain 041-0203-000 Manual

Chamberlain Lettelse 041-0203-000

Læs nedenfor 📖 manual på dansk for Chamberlain 041-0203-000 (4 sider) i kategorien Lettelse. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/4
Integrated LED Light Module
Replacement
Repair Parts 041-0200-000, 041-0201-000,
041-0202-000 and 041-0203-000
To prevent possible SERIOUS INJURY or DEATH: 
• Disconnect ALL electric and battery power BEFORE performing ANY
service or maintenance.
To prevent damage to the receiver logic board, DO NOT touch printed  
circuit board of replacement receiver/logic board during installation.
ALWAYS wear protective gloves and eye protection when changing the
battery or working around the battery compartment.
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer or
birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
Introduction
Use this instruction to replace the integrated LED light module. The images
throughout this manual are for reference only and your product may look
different.
You will need:
• 1/4" magnetic nut driver
• Long-nosed pliers
• 5/16" long-shafted magnetic nut driver and socket
• Flathead screwdriver
Instructions
1. Disconnect the electrical and battery power (if applicable) to the garage
door opener. Remove the battery and place in a safe location.
2. Remove the control door panel from both ends of
the opener. (A)
a. Separate the hinges in
opposite directions.
b. Remove the panels from
the hinge setting and
place in a safe location.
3. Disconnect the door control
wires from the RED and
WHITE terminals and the
safety reversal sensor wires
from the BLACK and WHITE
terminals. (B)
4. Remove the end panels from
both ends of the opener.
5. Remove the integrated LED
light module from the
opener. (C)
6. Disconnect the ORANGE and WHITE wire harness from plug to the
integrated LED light module and set aside cover / LED light module. (D)
7. Install the new integrated LED light module.
8. Connect the ORANGE and WHITE wire harness from the plug to the
Integrated LED Light Module. (D)
9. Align integrated LED light module to chassis screw holes.
10. Attach both end panels.
11. Reconnect the door control and safety reversal sensor wires. (B)
Door Control:
• WHITE wire into the WHITE terminal.
• WHITE/RED wire into the RED terminal.
Safety Reversal Sensors:
• WHITE wires into the WHITE terminal.
• WHITE/BLACK wires into the GRAY terminal.
12. Reattach the control door panels.
13. Reconnect power to the opener.
14. Test the Protector System.
RED
WHITE
WHITE
GREY
B
A
D
C
Integrated LED Light Module
Control Door Panel
End Panel

Produkt Specifikationer

Mærke: Chamberlain
Kategori: Lettelse
Model: 041-0203-000

Har du brug for hjælp?

Hvis du har brug for hjælp til Chamberlain 041-0203-000 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Lettelse Chamberlain Manualer

Chamberlain

Chamberlain 041-0203-000 Manual

26 Juli 2024
Chamberlain

Chamberlain 041-0194-000 Manual

24 Juli 2024

Lettelse Manualer

Nyeste Lettelse Manualer

Gemini

Gemini GDL13T Manual

16 December 2024
Gemini

Gemini GDL250 Manual

16 December 2024
Fuzzix

Fuzzix Orion Manual

16 December 2024
BeamZ

BeamZ Phoenix 1200 Manual

15 December 2024
Ranex

Ranex Zoe Manual

15 December 2024
Ranex

Ranex Mia Manual

15 December 2024
Ranex

Ranex Carlo Manual

15 December 2024
Vimar

Vimar 14394 Manual

15 December 2024
Vimar

Vimar 14393 Manual

15 December 2024
Vimar

Vimar 16440 Manual

15 December 2024