Conair BC116R Manual
Conair
uden kategorisering
BC116R
Læs nedenfor 📖 manual på dansk for Conair BC116R (2 sider) i kategorien uden kategorisering. Denne guide var nyttig for 17 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/2
WITH
®
Instructions
& Styling
Guide
For your safety and
continued enjoyment
of this product, always
read the instruction book
carefully before using.
Model BC116-All Versions
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be taken, including
the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY
FROM WATER
DANGER – Any appliance is electrically
live even when the switch is off. To reduce the
risk of death or injury by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing or in the shower.
3. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
4. Do not place in, or drop into water or
other liquids.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING – To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. This appliance should never be left
unattended when plugged in.
2. This appliance should not be used by, on,
or near children or individuals with certain
disabilities.
3. Use this appliance only for its intended
use as described in this manual. Do not
use attachments not recommended by the
manufacturer.
4. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, if it has been dropped, damaged,
or dropped into water. Return the appliance
to a Conair Service Center for examination
and repair.
5. Keep the cord away from heated surfaces.
Do not pull, twist, or wrap line cord around
appliance, even during storage.
6. Never block the air openings of the appliance
or place it on a soft surface, such as a bed or
couch, where the air openings may be blocked.
Keep the air openings free of lint, hair, and
the like.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening or hose.
9. Do not use outdoors or operate where aerosol
(spray) products are being used or where
oxygen is being administered.
10. Do not use an extension cord to operate hot
air styler.
11. Do not direct hot air toward eyes or other
heat-sensitive areas.
12. Attachments may be hot during use.
Allow them to cool before handling.
13. Do not place appliance on any surface while
it is operating.
14. While using the appliance, keep your hair
out of it. Keep your hair away from the air inlets.
15. Do not use with a voltage converter.
16. This appliance is not a toy. Keep away
from children.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This appliance is intended for household use
only. Use on Alternating Current (60 hertz) only.
Standard hot air stylers are designed to operate
at 110 to 125 volts AC.
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature, this
plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to defeat this safety
feature.
NOTE: Do not use this styling appliance on
hair extensions.
CHECK ALCI SAFETY FEATURE EVERY TIME
YOU USE APPLIANCE.
This appliance is equipped with an Appliance
Leakage Circuit Interrupter (ALCI), a safety
feature that renders it inoperable under some
abnormal conditions, such as immersion in
water. To make sure the ALCI is functioning
properly, perform the following test. The
purpose of this test is to allow you to make sure
the water sensing system (ALCI) is working.
1. Plug in the appliance
and press test button on
plug (see diagram).
2. The appliance will stop
working. There will be an
audible click and reset
Reset
Test
button will pop out. This indicates the ALCI is
functioning properly.
3. To reset ALCI with a reset button, unit should
be unplugged. Then push reset button in and
reinsert plug into outlet.
4. If ALCI is not functioning properly, return
appliance to service center.
5. It is important that if immersion occurs, this
unit be brought to a service center. Do not try
to reset.
6. Be sure to repeat test every time you use the
unit to confirm ALCI is operational.
Should the appliance go off and the reset
button pop up during use, this could indicate a
malfunction in the unit. Remove plug from outlet
and allow the appliance to cool. Reinsert plug
into outlet.
The appliance should then function normally.
If not, return it to an authorized Conair Service
Center for evaluation and repair.
TOURMALINE CERAMIC
TECHNOLOGY
The hot air styler has tourmaline ceramic heat,
eliminating damaging hot spots for beautiful,
frizz-free shine.
IONIC TECHNOLOGY
Many aspects of modern living, including air con-
ditioning, contact with man-made fibers and air
pollution contribute to a buildup of static elec-
tricity in the hair. Even brushing and towel drying
the hair, can increase these levels, causing the
surface of the cuticle to become rough.
Consequently, hair may have a dull appearance.
Also high levels of static charge cause hair to be-
come flyaway and difficult to style.
The ion generator produces a stream of nega-
tive ions that act to neutralize the static charge,
smoothing the scales on the cuticle for shiny,
smooth and manageable hair, so you can achieve
your desired style easily.
THE IONIZING FUNCTION
Generates negative ions to:
• neutralize the generally positive charge on
flyaway, frizzy hair
• eliminate static electricity
• contribute to shine
NOTE: The unit may produce a clicking
sound at times, which is normal for a
high output ion generator.
GETTING STARTED
After shampooing your hair, towel-dry and
untangle it carefully with a large-toothed comb.
Always start untangling your wet hair at the
tips, then gradually work your way up. Gentle
untangling prevents split ends from forming.
You may now finish drying and styling your hair
using your hot air styler. Make sure your desired
attachment is locked into place. Plug styler into
outlet. Slide switch to turn appliance ON and
OFF.
FEATURES
• 1000W
• High-shine, ionic conditioning
• 3 heat settings, plus cool shot
• Professional power cord
ROUND BRUSH
176 Flexalite™ bristles. Just the right number,
spaced just the right way. Epoxy tips gently
massage scalp for painless detangling.
VOLUME PIK
For root lift and volume.
TO SWITCH ATTACHMENTS
Fit the attachments onto the body of the unit by
lining up the guides on the two parts and then
press the two together until you hear a click. To
remove an attachment, press on the unlocking
buttons located on the sides of the unit and
gently pull the attachment off.
HEAT/SPEED SETTINGS
Cool Setting: This position combines ideal
airflow and temperature setting for shaping
finer, damaged or treated hair.
Low Setting: Ideal airflow for medium, normal
hair.
High Setting: Combines ideal airflow with
higher temperature for thick hair.
Cool Shot: Using the cool setting at the
end sets the style for a long-lasting effect.
GET TO KNOW YOUR STYLER
ume pik
root lift
line ceramic
brush
ock
uttons
settings
shot
TO STYLE HAIR
1. After detangling hair, section damp hair into 4
to 8 equal parts, depending on hair type.
2. Select heat setting based on hair type and
desired effect.
3. With brush attachment unit place the
appliance into the hair, close to the roots and
brush through the section until hair is dry.
4. To add volume at roots attach volume pik and
select desired heat setting. Gently insert volume
attachment into hair near the hair roots and hold
in place for 5–10 seconds. Then apply cool air to
lock roots in place. Repeat as needed.
5. Finish look with favorite styling spray.
SETTING HAIR TYPE
COOL Fragile, Fine/Thin Hair
LOW Medium/Normal Hair
HIGH Wavy/Curly/Coarse
Thick Hair
COOL SHOT Sets Style
This message about...
GROUND
FAULT
CIRCUIT
INTERRUPTERS
...can save a life!
IMPORTANT
Never immerse this product in water
or any other liquids.
IF YOU MUST USE YOUR HOT AIR STYLER IN
THE BATHROOM, INSTALL A GFCI* NOW!
Your local electrician can help you decide
which type is best for you – a portable unit that
plugs into the electrical outlet or a permanent
unit installed by your electrician. The National
Electrical Code now requires GFCIs in the
bathrooms, garages, and outdoor outlets of all
new homes.
WHY DO YOU NEED A GFCI? Electricity and
water don’t mix. If your hot air styler falls in
water while it’s plugged in, the electric shock
can kill you... even if the
switch is off. A regular
fuse or circuit breaker won’t
protect you under these
circumstances. A GFCI offers
you far greater protection.
A GFCI can save your life! Compared to that,
the price is small! Don’t wait... install one
now!
* GFCI is a sensitive device that reacts
immediately to a small electric current leak
by stopping the electricity flow.
CLEANING &
MAINTENANCE
• Unplug the ppliance and let cool completely
before cleaning it.
• Use a damp loth to clean carefully. Make
sure the appliance is completely dry before
using again.
• The rear filter should be cleaned on a regular
basis using a soft brush to help prevent buildup
and overheating. This will also prolong the
motor life.
USER MAINTENANCE
Your hot air styler is virtually maintenance free.
No lubrication is needed. For proper operating
performance, the hot air styler must be kept
clean. When cleaning is needed, unplug the
cord, allow to cool and clean dust and lint
from air intake openings with a small brush
or the brush attachment of a vacuum cleaner.
The outer surface of the hot air styler should
be wiped clean with a cloth only. Blocked or
clogged air intake vents will cause the hot
air styler to overheat. If overheating occurs,
an automatic safety device will shut the hot
air styler or the heat off to prevent damage or
personal injury. If the unit or the heat turns off,
unplug the cord and allow the hot air styler to
cool for 10 to 15 minutes before restarting.
Make sure the air vents are clean.
CAUTION
NEVER allow the power supply cord to be pulled,
twisted, or severely bent. Never wrap the cord
tightly around the hot air styler. Damage will
occur at the high flex point of entry into the hot
air styler, causing it to rupture and short. Inspect
the cord frequently for damage. Stop use
immediately if damage is visible or unit
stops or operates intermittently.
If the cord or hot air styler is damaged or does
not operate properly, return it for repair to an
authorized Conair service representative only.
No repairs should be attempted by the
consumer.
STORAGE – IMPORTANT
When not in use, your hot air styler should be
disconnected, allowed to cool and stored in a
safe, dry location, out of reach of children. Do
not wrap line cord around hot air styler. Allow
the cord to hang or lie loose and straight at the
point of entry into the hot air styler.
LIMITED THREE-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your
unit free of charge for 36 months from the
date of purchase if the appliance is defective
in workmanship or materials. To obtain service
under this warranty, return the defective product
to the service center listed, together with your
purchase receipt. California residents need
only provide proof of purchase and should call
1-800-3-CONAIR for shipping instructions. In
the absence of a purchase receipt, the warranty
period shall be 3 years from the date of
manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS,
OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED IN
DURATION TO THE 36-MONTH DURATION OF
THIS WRITTEN, LIMITED WARRANTY. Some
states do not allow limitations on how long an
implied warranty lasts, so the above limitations
may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESS
OR IMPLIED, WHATSOEVER.
Some states do not allow the exclusion or
limitation of special, incidental, or consequential
damages, so the above limitation may not apply
to you.
This warranty gives you specific legal rights,
and you may also have other rights, which vary
from state to state.
BEAUTY TIPS
To achieve the looks you love and for more
great InfinitiPRO by Conair®
products, visit infiniti.conair.com
Please register this product at
www.conair.com/registration
Service Center
Conair Corporation
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
For information on any Conair or InfinitiPRO by Conair
product, call 1-800-3-CONAIR or visit us
on the web at: www.conair.com/infiniti
©2020 Conair Corporation
7475 N. Glen Harbor Blvd., Glendale, AZ 85307
19PA065240 IB-16618
Produkt Specifikationer
| Mærke: | Conair |
| Kategori: | uden kategorisering |
| Model: | BC116R |
Har du brug for hjælp?
Hvis du har brug for hjælp til Conair BC116R stil et spørgsmål nedenfor, og andre brugere vil svare dig
uden kategorisering Conair Manualer
21 August 2024
uden kategorisering Manualer
Nyeste uden kategorisering Manualer
20 August 2024
21 Juni 2023