Conair BC200N Manual


Læs nedenfor 📖 manual på dansk for Conair BC200N (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Hot Air Paddle Brush Styler
style
as
you dry
Model BC200
All versions
Instructions
& Styling
Guide
For your safety and
continued enjoyment
of this product, always
read the instruction book
carefully before using.
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be taken, including
the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER Any appliance is electrically
live even when the switch is off. To reduce the
risk of death or injury by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
4. Do not place in, or drop into water or other
liquids.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. This appliance should never be left
unattended when plugged in.
2. This appliance should not be used by, on,
or near children or individuals with certain
disabilities.
3. Use this appliance only for its intended use
as described in this manual. Do not use attach-
ments not recommended by the manufacturer.
4. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, if it has been dropped, damaged,
or dropped into water. Return the appliance
to a Conair Service Center for examination
and repair.
5. Keep the cord away from heated surfaces.
Do not pull, twist, or wrap line cord around
appliance, even during storage.
6. Never block the air openings of the appliance
or place it on a soft surface, such as a bed or
couch, where the air openings may be blocked.
Keep the air openings free of lint, hair, and the
like.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening or hose.
9. Do not use outdoors or operate where aero-
sol (spray) products are being used or where
oxygen is being administered.
10. Do not use an extension cord to operate hot
air styler.
11. Do not direct hot air toward eyes or other
heat-sensitive areas.
12. Attachments may be hot during use.
Allow them to cool before handling.
13. Do not place appliance on any surface while
it is operating.
14. While using the appliance, keep your hair
out of it. Keep your hair away from the air inlets.
15. Do not use with a voltage converter.
16. This appliance is not a toy. Keep away from
children.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This appliance is intended for household use
only. Use on Alternating Current (60 hertz) only.
Standard hot air stylers are designed to operate
at 110 to 125 volts AC.
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature, this
plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a quali-
fied electrician. Do not attempt to defeat this
safety feature.
NOTE: Do not use this styling appliance on
hair extensions.
CHECK ALCI SAFETY FEATURE EVERY TIME
YOU USE APPLIANCE.
This appliance is equipped with an Appliance
Leakage Circuit Interrupter (ALCI), a safety
feature that renders it inoperable under some
abnormal conditions, such as immersion in
water. To make sure the ALCI is functioning
properly, perform the following test. The
purpose of this test is to allow you to make sure
the water sensing system (ALCI) is working.
1. Plug in the appliance and press test button
on plug (see diagram).
2. The appliance will stop working. There will be
an audible click and reset button will pop out. This
indicates the ALCI is functioning properly.
3. To reset ALCI with a reset button, unit should
be unplugged. Then push reset button in and
reinsert plug into outlet.
Reset
Test
4. If ALCI is not functioning properly, return
appliance to service center.
5. It is important that if immersion occurs, this
unit be brought to a service center. Do not try
to reset.
6. Be sure to repeat test every time you use the
unit to confirm ALCI is operational.
Should the appliance go off and the reset
button pop up during use, this could indicate a
malfunction in the unit. Remove plug from outlet
and allow the appliance to cool. Reinsert plug
into outlet.
The appliance should then function normally.
If not, return it to an authorized Conair Service
Center for evaluation and repair.
FEATURES
• 600W
High-shine, ionic conditioning
2 heat settings, plus cool setting
Professional power cord
Heat-activated silicone for added shine
3 TYPES OF BRISTLES
Nylon guides hair for styling control
Silicone for added shine
Detangling for easier drying
THE IONIZING FUNCTION
generates negative ions to:
neutralize the generally positive charge on
flyaway, frizzy hair
eliminate static electricity
contribute to shine
NOTE: The unit may produce a clicking
sound at times, which is normal for a
high output ion generator.
3 HEAT/SPEED SETTINGS
Low Setting: This position combines ideal
airflow and temperature setting for shaping fine,
damaged or treated hair.
High Setting: Combines ideal airflow with higher
temperature for styling thick hair.
Cool Setting: Using the cool setting at the end
sets the style for a long-lasting effect.
GETTING STARTED
No need to dry, section or brush hair before use.
Plug styler into outlet. Slide switch to turn appli-
ance ON and OFF.
TO STYLE HAIR
1. Place the paddle brush attachment into the hair,
close to the roots, and brush through the section.
2. For added root lift and volume: Place the brush
underneath the hair section close to the roots with
the bristles pointing upward. Use your other hand
to pull the hair section taut against the silicone
paddle until the bristles penetrate through the hair.
3. FOR MORE VOLUME: Turn your head upside
down while you brush/dry.
GET TO KNOW YOUR STYLER
Detangling Bris
for easier drying
Silicone Bristles
for added shine
Nylon Bristle
guide hair for
styling contro
Power/heat-se
slide switch
This message about...
GROUND
FAULT
CIRCUIT
INTERRUPTERS
...can save a life!
IMPORTANT
Never immerse this product in water
or any other liquids.
IF YOU MUST USE YOUR HOT AIR STYLER IN
THE BATHROOM, INSTALL A GFCI* NOW!
Your local electrician can help you decide which
type is best for you – a portable unit that plugs into
the electrical outlet or a permanent unit installed
by your electrician. The National Electrical Code
now requires GFCIs in the bathrooms, garages, and
outdoor outlets of all new homes.
WHY DO YOU NEED A GFCI? Electricity and
water don’t mix. If your hot air styler falls in water
while its plugged in, the electric shock can kill
you... even if the switch is off.
A regular fuse or circuit breaker
won’t protect you under these
circumstances. A GFCI offers you
far greater protection.
A GFCI can save your life! Compared to that,
the price is small! Don’t wait... install one now!
* GFCI is a sensitive device that reacts immediately
to a small electric current leak by stopping the
electricity flow.
CLEANING &
MAINTENANCE
Unplug the appliance and let cool completely
before cleaning it.
Use a damp cloth to clean carefully. Make sure
the appliance is completely dry before using again.
The rear filter should be cleaned on a regular
basis using a soft brush to help prevent buildup and
overheating. This will also prolong the motor life.
USER MAINTENANCE
Your hot air styler is virtually maintenance free.
No lubrication is needed. For proper operating
performance, the hot air styler must be kept clean.
When cleaning is needed, unplug the cord, allow to
cool and clean dust and lint from air intake open-
ings with a small brush or the brush attachment
of a vacuum cleaner. The outer surface of the hot
air styler should be wiped clean with a cloth only.
Blocked or clogged air intake vents will cause
the hot air styler to overheat. If overheating
occurs, an automatic safety device will shut the
hot air styler or the heat off to prevent damage
or personal injury. If the unit or the heat turns off,
unplug the cord and allow the hot air styler to cool
for 10 to 15 minutes before restarting. Make sure
the air vents are clean.
CAUTION
NEVER allow the power supply cord to be pulled,
twisted, or severely bent. Never wrap the cord
tightly around the hot air styler. Damage will occur
at the high flex point of entry into the hot air styler,
causing it to rupture and short. Inspect the cord
frequently for damage. Stop use immediately if
damage is visible or unit stops or operates
intermittently.
If the cord or hot air styler is damaged or does not
operate properly, return it for repair to an authorized
Conair service representative only. No repairs
should be attempted by the consumer.
STORAGE – IMPORTANT
When not in use, your hot air styler should be
disconnected, allowed to cool and stored in a safe,
dry location, out of reach of children. Do not wrap
line cord around hot air styler. Allow the cord to
hang or lie loose and straight at the point of entry
into the hot air styler.
LIMITED TWO-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your
unit free of charge for 24 months from the
date of purchase if the appliance is defective in
workmanship or materials. To obtain service under
this warranty, return the defective product to the
service center listed, together with your purchase
receipt and $7.50 for postage and handling.
California residents need only provide proof of
purchase and should call 1-800-3-CONAIR for
shipping instructions. In the absence of a purchase
receipt, the warranty period shall be 2 years from
the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR
LIABILITIES, INCLUDING BUT NOT LIMITED TO
THE IMPLIED WARRANTY OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE,
SHALL BE LIMITED IN DURATION TO THE
24-MONTH DURATION OF THIS WRITTEN,
LIMITED WARRANTY. Some states do not allow
limitations on how long an implied warranty lasts,
so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR
ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES FOR BREACH OF THIS OR ANY
OTHER WARRANTY, EXPRESS OR IMPLIED,
WHATSOEVER.
Some states do not allow the exclusion or
limitation of special, incidental, or consequential
damages, so the above limitation may not apply
to you.
This warranty gives you specific legal rights, and
you may also have other rights, which vary from
state to state.
BEAUTY TIPS:
To achieve the looks you love and for more
great InfinitiPRO by Conair®
products visit: infiniti.conair.com
Please register this product at:
www.conair.com/registration
Service Center
Conair Corporation
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
For information on any Conair or InfinitiPRO by Conair
product, call 1-800-3-CONAIR or visit us
on the web at: www.conair.com/infiniti
©2017 Conair Corporation
150 Milford Road, East Windsor, NJ 08520
7475 N. Glen Harbor Blvd., Glendale, AZ 85307
IB-14582
16PA023008


Produkt Specifikationer

Mærke: Conair
Kategori: Ikke kategoriseret
Model: BC200N

Har du brug for hjælp?

Hvis du har brug for hjælp til Conair BC200N stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Conair Manualer

Conair

Conair MASK2 Manual

1 Oktober 2024
Conair

Conair skn SFB11GK Manual

1 Oktober 2024
Conair

Conair Man GMTL6000 Manual

6 September 2024
Conair

Conair LNT1 Manual

6 September 2024
Conair

Conair Man GMT189R Manual

6 September 2024
Conair

Conair CD117NN Manual

2 September 2024
Conair

Conair LLT2 Manual

2 September 2024
Conair

Conair CLS1X Manual

2 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Gigabyte

Gigabyte ODIN GT 550W Manual

23 November 2024
Stamos

Stamos S-PLASMA 60U Manual

23 November 2024
Velbus

Velbus VMBPIRO-W-20 Manual

23 November 2024
Honor

Honor 90 Pro Manual

23 November 2024
Honor

Honor 80 SE Manual

23 November 2024
Medela

Medela Safe & Dry Manual

22 November 2024
Jane

Jane First Potty Manual

22 November 2024