Conair BC8 Manual


Læs nedenfor 📖 manual på dansk for Conair BC8 (2 sider) i kategorien niet gecategoriseerd. Denne guide var nyttig for 4 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
STR AIGHTENING BRUSH
IMPORTANT
SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be taken, including
the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY
FROM WATER
DANGER – Any appliance is
electrically live, even when the switch is off. To
reduce the risk of death by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in, or drop into water or
other liquids.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING – To reduce the risk
of burns, electrocution, fire, or injury to persons:
1. This appliance should never be left
unattended when plugged in.
2. Do not pull, twist, or wrap line cord
around appliance.
3. This appliance should not be used by,
on or near children or individuals with
certain disabilities.
4. Use this appliance only for its intended use,
as described in this manual. Do not use
attachments not recommended by the
manufacturer.
5. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly or if it has been dropped or
damaged, or dropped into water. Return
the appliance to an authorized service center
for examination and repair.
6. Keep the cord away from heated surfaces.
7. Never use while sleeping or drowsy.
8. Never drop or insert any object into any
opening or hose.
9. Do not use outdoors or operate where aerosol
(spray) products are being used or where
oxygen is being administered.
10. Unit is hot when in use. Do not let heated
surfaces touch eyes or skin.
11. Do not place the heated unit directly on any
surface while it is hot or plugged in.
12. Never block the air openings of the
appliance or place it on a soft surface, such as a
bed or couch, where the air openings may be
blocked. Keep the air openings free of hair,
lint and other debris.
13. Do not use an extension cord with
this appliance.
14. Do not touch hot surfaces of the
appliance. Use handles or knobs.
15. Do not attempt to touch the housing of your
appliance near the heat plate, as it is hot when
in use.
16. To avoid tangling, never roll the hair around
the straightening brush.
17. Do not operate with a voltage converter.
18. This appliance is not a toy. Keep away
from children.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This straightening brush is intended for
household use. Use on Alternating Current (60
hertz) only. This unit is designed to be operated
at 120V AC.
This appliance has a polarized plug (one blade is
wider than the other). As a safety feature, this
plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to defeat this
safety feature.
NOTE: DO NOT USE THIS STYLING APPLIANCE
ON HAIR EXTENSIONS.
GETTING STARTED
The straightening brush’s high heat temperature
setting provides unique styling versatility for all
hair types.
STYLING WITH THE
CERAMIC-COATED
EASY-GLIDE PADDLE
The ceramic-coated surface helps smooth down
flyaways and frizz. It evenly distributes heat so
that the style you create has a salon-perfect,
silky smooth, shiny finish.
The unique combination of heated ceramic-
coated and nylon bristles provides better contact
and superior styling for beautifully defined,
lasting results. The ceramic-coated bristles
retain heat while styling, and the nylon bristles
gently guide hair.
TO STYLE HAIR
The straightening brush is perfect for everyday
styling and touch-ups. Simply slide the switch
on and follow these steps to detangle and
smooth hair.
1. Ensure hair is fully dry. Use a hairbrush to
remove any tangles from the hair and create
your part, getting ready for styling.
2. Place the brush underneath
the hair section close to the
roots with the bristles pointing
upward. Use your other hand to
pull the hair section taut
against the heated plate until
the bristles penetrate through the hair.
3. Glide the brush steadily
down toward the ends of the
hair. Continue to use the other
hand to keep the hair taut,
sliding it down the section
ahead of the brush. Please
note: The hand sliding down
the hair section must not be too
close to the brush to avoid any
heat contact.
4. As the brush nears the ends
of the hair, release the section
with the other hand and turn
the heated brush under to give
shape at the ends of the hair.
5. To finish your style and
smooth the top of the hair,
place the brush on the top of
the hair section. Use the other
hand to pull the section upward
and taut against the heated
plate until the bristles penetrate
through the hair. Take care to
avoid pressing the heated plate
against the scalp.
6. Glide the brush down toward
the ends of the hair, using the
other hand as before to keep
the section taut.
7. As the brush nears the ends
of the hair, release the hair
section from the other hand
and brush through to the ends.
GET TO KNOW YOUR
STRAIGHTENING BRUSH
ofessional
ivel Line Cord
Nylon
Bristles
Ceramic-
Coated
Paddle
Power
ON/OFF
Switch
Power
Indicator
Light
Ceramic-Coate
Bristles
WARNING: T will get he straightening brush
very hot within a few seconds and should not
come in contact with skin after it is turned on.
USER
MAINTENANCE
Your straightening brush is virtually
maintenance free. No lubrication is needed.
Keep all vents and openings clear of dirt and
dust. If cleaning becomes necessary, disconnect
the straightening brush from the power source,
let it cool, and wipe exterior with a cloth. If
any abnormal condition occurs, unplug the hot
brush, allow it to cool, and return it for repair
to an authorized service center only. No repairs
should be attempted by the consumer.
CAUTION
NEVER allow the power supply cord to be pulled
or twisted. Never wrap the cord around the
straightening brush. Damage will occur at the
high flex point of entry into the straightening
brush, causing it to rupture and short circuit.
Inspect the cord frequently for damage. Stop
use immediately if damage is visible or if unit
stops or operates intermittently.
STORAGE
When not in use, your appliance should be
disconnected, allowed to cool, and stored in a
safe, dry location, out of reach of children. Do
not jerk or strain cord at plug connections.
Do not wrap the line cord around the appliance.
Allow the cord to hang or lie loose and straight
at the point of entry into the appliance.
WARNING:
IF YOU THINK
THE POWER IS OFF
WHEN THE SWITCH
IS OFF,
YOU’RE WRONG.
KEEP AWAY FROM WATER
Everyone knows that electricity and water are a
dangerous combination. But did you know that
an electric appliance is still electrically live even
if the switch is off? If the plug is in, the power is
on. So when you are not using your appliances,
keep them unplugged.
ALWAYS UNPLUG
SMALL APPLIANCES
LIMITED FOUR-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your
unit free of charge for months from the 48
date of purchase if the appliance is defective in
workmanship or materials.
To obtain service under this warranty, return
the defective product to the service center listed
on back, together with your purchase receipt
and $7.50 for postage and handling. California
residents need only provide proof of purchase
and should call 1-800-3-CONAIR for shipping
instructions. In the absence of a purchase
receipt, the warranty period shall be months 48
from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS,
OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED IN
DURATION TO THE -MONTH DURATION OF 48
THIS WRITTEN, LIMITED WARRANTY. Some
states do not allow limitations on how long an
implied warranty lasts, so the above limitations
may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR CON-
SEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESS
OR IMPLIED, WHATSOEVER. Some states do
not allow the exclusion or limitation of special,
incidental, or consequential damages, so the
above limitation may not apply to you.
This warranty gives you specific legal rights,
and you may also have other rights, which vary
from state to state.
BEAUTY TIPS:
To achieve the looks you love and
for more great Conair® products,
visit: www.conair.com
Please register this product at:
www.conair.com/registration
For info on any Conair product call:
1-800-3-CONAIR or visit us on the web at:
www.conair.com
Service Center
Conair Corporation
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
©2017 Conair Corporation
150 Milford Road, East Windsor, NJ 08520
7475 N. Glen Harbor Blvd., Glendale, AZ 85307
17PA025621 IB-14512B


Produkt Specifikationer

Mærke: Conair
Kategori: niet gecategoriseerd
Model: BC8

Har du brug for hjælp?

Hvis du har brug for hjælp til Conair BC8 stil et spørgsmål nedenfor, og andre brugere vil svare dig




niet gecategoriseerd Conair Manualer

Conair

Conair Man GMTL6000 Manual

6 September 2024
Conair

Conair LNT1 Manual

6 September 2024
Conair

Conair Man GMT189R Manual

6 September 2024
Conair

Conair CD117NN Manual

2 September 2024
Conair

Conair LLT2 Manual

2 September 2024
Conair

Conair CLS1X Manual

2 September 2024
Conair

Conair LT85 Manual

2 September 2024
Conair

Conair HS79 Manual

2 September 2024
Conair

Conair PG1000L Manual

2 September 2024
Conair

Conair FR02 Manual

2 September 2024

niet gecategoriseerd Manualer

Nyeste niet gecategoriseerd Manualer

IFM

IFM O6T207 Manual

16 September 2024
Güde

Güde LG 18-30 Manual

16 September 2024
Uniden

Uniden WPP 15W + D800 Manual

16 September 2024
JUNG

JUNG BTCCD508 Manual

16 September 2024
Samsung

Samsung AC036TN4PKC Manual

16 September 2024
Nedis

Nedis ACON2503AT Manual

16 September 2024
SVAN

SVAN SVTE050 Manual

16 September 2024
IFM

IFM EVC085 Manual

16 September 2024
IFM

IFM EVM042 Manual

16 September 2024
Denver

Denver VR-20 Manual

16 September 2024