Conair GlideLite GI500 Manual

Conair Jern GlideLite GI500

Læs nedenfor 📖 manual på dansk for Conair GlideLite GI500 (2 sider) i kategorien Jern. Denne guide var nyttig for 15 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
13. Do not place the soleplate directly on any
surface or on the appliance power cord
while the iron is hot or plugged in.
14. The plug must be removed from the
electrical outlet before the water reservoir is
filled with water.
15. Do not operate steam function without
properly filling the water tank with water.
16. The iron should always be turned off
before plugging in or unplugging from
an outlet. Never yank cord to disconnect
from outlet; instead, grasp plug and pull to
disconnect.
17. Burns could occur from touching hot metal
parts, hot water, or steam. Use caution
when turning a steam iron upside down to
empty water, as there may be hot water in
the reservoir.
18. If you need to clean the iron, unplug and
allow to cool. Use a slightly damp cloth and
wipe down the outside of the iron. DO NOT
use cleaning agents or place the iron in
water or cleaning fluids.
19. Do not hold hand in front of steam.
20. To reduce likelihood of circuit overload,
do not operate another high-wattage
appliance on the same circuit.
21. Never steam or iron clothes that are
being worn.
22. When emitting steam, this appliance may
cause burns if it is used too close to the
skin or eyes or if it is used incorrectly.
To reduce the risk of contact with hot
water emitting from the steam vents, test
appliance before use by holding it away
from the body.
IMPORTANT SAFETY
INSTRUCTIONS
When using your iron, especially when children
are present, basic precautions should always be
taken, including the following:
READ ALL
INSTRUCTIONS
BEFORE USING
DANGER Any appliance is electrically
live even when the switch is off.
To reduce the risk of death by electric shock:
1. Always unplug appliance immediately
after use and before cleaning.
2. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
3. Do not place in or drop into water or other
liquids.
4. Do not reach for an appliance that has fallen
into water. Unplug immediately.
5. Use only in a dry area.
WARNING To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. Children should be supervised to ensure
that they do not play with the appliance.
2. This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person
responsible for their safety.
3. The iron must not be left unattended while it
is connected to an electrical outlet.
4. Use this appliance only for its intended use
as described in this manual. Do not use
attachments not recommended by Conair.
5. The iron must be used and rested on a
stable surface.
6. If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid a hazard.
7. Do not allow cord to touch heated surfaces.
Do not pull or twist cord. Let appliance cool
completely before emptying or putting away.
Wrap the cord loosely around the iron when
storing.
8. This appliance has a polarized plug (one
blade is wider than the other). As a safety
feature, this plug will fit in a polarized outlet
only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
9. Never drop or insert any object into any
opening.
10. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
11. We recommend you do not use an
extension cord to operate this appliance. If
an extension cord is absolutely necessary,
a 15 ampere-rated cord should be used.
Cords rated for less amperage may
overheat. Care should be taken to arrange
the cord so that it cannot be pulled or
tripped over.
12. Surfaces of this appliance are hot when in
use. Do not let heated surfaces touch eyes
or skin.
23. When placing the iron on its base, ensure
that the surface on which the base is
placed is stable.
24. The iron is not to be used if it has been
dropped, if there are visible signs of
damage or if it is leaking.
25. Always disconnect the iron from the
electrical outlet before filling the reservoir
with water, emptying the water from the
reservoir, and when the iron is not in use.
26. Close supervision is required for any
appliance used by or near children. Do not
leave the iron unattended while the iron is
connected or on an ironing board.
SAVE THESE
INSTRUCTIONS
IMPORTANT
FOR HOUSEHOLD USE ONLY
DO NOT let children use the appliance.
DO NOT let untrained persons use the
appliance without supervision.
NEVER immerse the iron, cable or plug in any
liquids.
DO NOT leave the hot iron touching fabrics or
inflammable surfaces.
DO NOT leave the appliance unnecessarily
plugged in. Disconnect the plug from the outlet
when the appliance is not being used.
NEVER touch the appliance with wet or damp
hands.
DO NOT use the power cord or the appliance in
order to pull the plug out of the outlet.
DO NOT leave the appliance exposed to the
weather (rain, sun, etc.).
DO NOT leave the iron without supervision when
it is connected to the power supply.
DO NOT fill the reservoir with water before
removing the plug from the outlet.
PLEASE NOTE!
Do not use chemical additives, scented
substances or decalcifiers in the reservoir.
Failure to comply with the above-mentioned
regulations will lead to the loss of warranty.
OPERATING
INSTRUCTIONS
PREPARING FOR FIRST USE
Before first use, remove all labels from the
soleplate and housing. Plug iron in. Turn the
iron on, allow to heat up, then turn the iron off.
Unplug iron.
When using the iron for the first time, you may
notice a slight emission of smoke and hear some
sounds made by the expanding plastics. This
is quite normal and will stop after a short time.
We also recommend passing the iron over an
ordinary cloth before using it for the first time.
This GlideLite Iron features advanced One-Temp
technology. No settings are needed. The iron is
safe and effective on all fabric types.
FILLING THE RESERVOIR
1. The reservoir can be filled with ordinary tap
water. But distilled or demineralized water
is preferred.
a. Open the water reservoir door.
b. Using a clean measuring cup, slowly fill
the reservoir until the water reaches the
max fill indicator. DO NOT OVERFILL.
c. Close water reservoir door.
d. Wipe off any water that may have spilled
on the outside of the iron with a soft clean
cloth.
2. Set the iron on a stable, flat surface. We
recommend using a quality ironing board
as the pressing surface. Be sure to give
yourself enough room to maneuver the
iron when pressing.
FEDERAL COMMUNICATIONS
COMMISSION NOTICE
WARNING: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
users authority to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) This device must
accept any interference received, including
interference that may cause undesired
operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.
SUPPLIER’S DECLARATION
OF CONFORMITY
Brand: Conair®
Model No.: GI500
Description: Steam Iron
Responsible Party: Conair LLC,
1 Cummings Point Road, Stamford, CT 06902
(203) 351-9000
Standards: FCC Part 15 Subpart B, ANSI
C63.4-2014
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and (2) This device must
accept any interference received, including
interference that may cause undesired
operation.
DATE OF ISSUE: 10/18/2022


Produkt Specifikationer

Mærke: Conair
Kategori: Jern
Model: GlideLite GI500

Har du brug for hjælp?

Hvis du har brug for hjælp til Conair GlideLite GI500 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Jern Conair Manualer

Jern Manualer

Nyeste Jern Manualer