Conair GMT10NCS Manual


Læs nedenfor 📖 manual på dansk for Conair GMT10NCS (3 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/3
T R I M M E R
ALL ONE-IN-
BEARD
///
MUSTACHE
Instruction Booklet
For your safety and continued enjoyment
of this product, always read the instruction
booklet carefully before using.
TRIMMING YOUR MUSTACHE
1. For best results, start with a
clean, slightly damp mustache.
2. Comb through your mustache
in the direction it grows.
3. Place the 5-position comb over the facial hair
blade and snap it into position. It is a good idea
to start with the longest trim setting adjustment.
(You can always go back and cut your mustache
more closely with a shorter setting.) Always
trim your mustache from the top down.
4. After your mustache has
been trimmed to the desired
length, remove the 5-position
comb and, using the blade only,
define the outline of the bottom
of your mustache.
ON/OFF SWITCH
To operate, simply slide switch toward blade; to
stop, slide switch away from blade.
CARE OF YOUR TRIMMER
REPLACEMENT (REMOVAL) OF BLADE SET
To remove blade set from your
trimmer, make sure the trimmer
is in the OFF position. Remove the
blade set by placing thumb against
the smaller cutter and pushing for-
ward, releasing the cutter assem-
bly from the trimmer housing.
Replace with new cutting system and reverse
the removal procedure, only this time place your
thumb on the large cutter and snap into place.
BATTERY REMOVAL
1. Using a small Phillips head screwdriver, remove
the screws at the back of the trimmer.
2. Remove the bottom housing and cut the
battery out. Bring the battery to the nearest
collection center for proper disposal. DO NOT
throw the battery into the normal municipal
waste system.
Model GMT10RCSB
CONTAINS NICKEL METAL HYDRIDE BATTERY.
MUST BE COLLECTED, RECYCLED OR DISPOSED
OF PROPERLY. DO NOT DISPOSE OF IN THE
MUNICIPAL WASTE.
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially when
children are present, basic safety precautions
should always be taken, including the following:
READ ALL INSTRUCTIONS
BEFORE USING
FOR HOUSEHOLD USE ONLY
KEEP AWAY FROM WATER
DANGER – Any appliance is electrically
live, even when the switch is off.
To reduce the risk of death or injury by
electric shock:
1. Always unplug appliance from electrical
outlet immediately after using (except when
charging unit).
2. Do not place or store appliance where it could
fall or be pulled into a tub or sink.
3. Do not use appliance while bathing or in the
shower.
4. Do not place appliance in, or drop into, water
or other liquids.
5. If appliance has fallen into water, do not
reach for it. Unplug immediately.
6. Unplug this appliance before cleaning.
WARNINGTo reduce the risk of
burns, electric shock, fire, or injury to persons:
1.
Never leave a plugged-in appliance
unattended.
2. This appliance should not be used by, on, or near
children or individuals with certain disabilities.
3. Use appliance only for its intended use as
described in this manual. Use only attachments
recommended by the manufacturer. Do not use
an extension cord to operate the appliance.
4. Never operate the appliance if it has a
damaged cord or plug, is not working proper-
ly, has been dropped or damaged, or dropped
into water. Return the appliance to a Conair
Service Center for examination and repair.
5. Keep the appliance cord away from heated
surfaces.
6. Do not pull, twist or wrap the cord around the
appliance.
7. Never drop or insert any object into any
opening of the appliance.
8. Do not place the appliance on any surface
while it is operating.
9. Do not use the appliance with a damaged
or broken comb or with teeth missing from the
blades, as injury may result. Before each use,
make certain the blades are aligned properly
and oiled.
10. Do not use the appliance outdoors or where
aerosol (spray) products are being used or
oxygen is being administered.
SAVE THESE
INSTRUCTIONS
OPERATING INSTRUCTIONS
Before using the Class 2 Power Supply, read
these instructions carefully.
Use with adapter CA51
Rated input voltage: 100–240V AC, 50/60Hz
0.2A Max
Rated output: 6.0V DC 70mA
OPERATION
1. For dry location use only. Do not expose to water.
2. When not in use, unplug unit completely.
3. Unit will become warm during operation.
CAUTION
1. Dry location use only. Do not expose to liquid,
vapor, or rain.
2. Ensure jack is plugged into the trimmer unit
before plugging the adapter into the outlet.
3. Do not operate any appliance that has a
damaged output cord or housing.
4. Always unplug the unit before cleaning or
when not in use.
5. This power unit is intended to be correctly
oriented in a vertical or floor mount position.
6. Be sure voltage is correct before plugging in.
For connection to a supply not in the U.S.A. use
an attachment plug adapter of the proper
configuration for power outlet.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Warning: Changes or modification to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
TROUBLESHOOTING
If your rechargeable trimmer does not seem to
be taking a charge, take the following trouble-
shooting steps before returning it for repair:
1. Be sure the electrical outlet is working by
plugging in another appliance to test the outlet.
2. Make sure the electrical plug is not con-
nected to a switch that turns power off when
lights are turned off.
3. Be sure you have inserted the adapter prop-
erly into the trimmer, that all connections are
secure, and that the trimmer switch is in the
OFF position.
OPERATING
INSTRUCTIONS
1. Before using the trimmer for the first time,
charge continuously for 16 hours. Maximum
battery capacity will be reached only after 3
charging and discharging cycles.
2. Always check to see if the charging light is on
when you firmly connect the unit with the adapter.
3. Plug the adapter into any wall outlet (at the
voltage listed on the label affixed to the adapter).
Unplug adapter when not in use.
4. The adapter may become warm while
charging. This is normal.
5. Preserving the batteries: in order to maintain
the optimum capacity of the rechargeable
batteries, the trimmer should be recharged for 16
hours approximately every 3 months.
USER MAINTENANCE
INSTRUCTIONS
OILING THE BLADE (oil not included)
About once a month you should oil the trimmer
blade with a light mineral oil. It is best to do this
over a piece of newspaper. Turn the trimmer on
and hold it so that the blades are pointed down-
ward. Spread one drop of oil across the blades,
then turn the trimmer off and wipe away the
excess oil with a soft cloth.
Be careful not to use too much oil and don’t oil
your trimmer more than necessary, as this could
damage the motor. (Never attempt to oil the motor
bearing, as it is permanently lubricated.)
BLADE CARE
Because the trimmer blade is precision-made for
a very special use, it should always be handled
with care. Each time you finish using the trimmer,
brush away any loose hair that has collected in
the blade.
Be especially careful when changing or adjusting
the blade. When you have your trimmer serviced,
be sure that the blade is sharpened or replaced at
the same time.
To promote the long life of the trimmer, use it only
for the purpose intended by the manufacturer – to
trim your beard and mustache.
GROWING A BEARD AND MUSTACHE
There are three key factors that will determine
which beard or mustache style is best for you:
1. The shape and dimensions of your face.
2. The natural growth of your beard/mustache.
3. The thickness of your beard/mustache. If you
are unsure about the type of beard or mustache
that would most suit your face, speak with a
professional hair stylist and ask for an opinion
on what style would be best. Once your beard
or mustache has been styled, it is essential that
you maintain its appearance. To do this, use your
trimmer to trim your beard/mustache weekly.
For the best trimming results, your beard should
be slightly damp (NOT WET) when using your
trimmer. This will prevent the trimmer from
removing more hair than desired.
TYPES OF BEARDS/MUSTACHES
GETTING STARTED
OUTLINING YOUR BEARD
1. It is always best to begin with a clean, slightly
damp beard.
2. After you have combed through your beard in
the direction it grows naturally, you will want to
outline the desired shape, beginning under your
jawline.
3. Begin defining your beard’s
shape under your chin and work
upward on each side of your
face toward your ears. Then
define the upper outline of your beard across
your cheeks, past your sideburns, and toward
your hairline.
TRIMMING YOUR BEARD
1. The trimmer includes a
5-position comb for use
with the hair trimming blade
(2–10mm) which provides
lengths of 3/32" (shortest) to
3/8" (longest).
2. To use the 5-position comb, slide the unit
over the trimmer blade and snap it down into
position. At first, until you become familiar with
the adjustments, use the longest trim setting.
(You can always go back and make your beard
a little shorter.)
3. Begin trimming your
beard using smooth,
even strokes. Start with
your sideburns and work
downward toward your
chin. (Never attempt to trim against the natural
growth of your beard because the hair will be
cut too short.)
4. If you decide you want a closer trim, you can
now adjust the 5-position comb attachment to
a shorter setting (such as 3/32" or 5/32") and
go over your beard again until you achieve the
desired length.
BLENDING THE JAWLINE
1. Two all-purpose attachments, AC14, which
provides lengths of 3mm (shortest) and AC13,
which provides lengths of 5mm (longest), will
help you to achieve a neat, finished trim under
your chin. To use one of the attachments, press it
down over the trimmer blades until it clicks into
position.
2. Hold the trimmer in an upright position and
begin trimming under your jawline, using short,
even strokes.
3. After your beard is blended, turn off the
trimmer and remove the attachment by gently
pulling up on tab.
JAWLINE COMB AC14 JAWLINE COMB AC13
MODEL GMT10RCSB
BEARD/MUSTACHE TRIMMER
5-Position
Adjustable Comb
Adapter
& Mustache
Trimmer
Facial Hair Blade
2 2 All-PurAll-Purpose pose CCombsombs
Multi-Multi-use use BeBeard ard
LIMITED TWO-YEAR WARRANTY
Conair will repair or replace (at our option) your
unit free of charge for 24 months from the
date of purchase if the appliance is defective in
workmanship or materials.
To obtain service under this warranty, return the
defective product to the service center listed on
back, together with your purchase receipt and
$3.00 for postage and handling. California resi-
dents need only provide proof of purchase and
should call 1-800-366-0937 for shipping instruc-
tions. In the absence of a purchase receipt, the
warranty period shall be 24 months from the
date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR
LIABILITIES, INCLUDING BUT NOT LIMITED TO
THE IMPLIED WARRANTY OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE,
SHALL BE LIMITED IN DURATION TO THE
24-MONTH DURATION OF THIS WRITTEN,
LIMITED WARRANTY. Some states do not allow
limitations on how long an implied warranty lasts,
so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESS OR
IMPLIED, WHATSOEVER. Some states do not
allow the exclusion or limitation of special, inci-
dental, or consequential damages, so the above
limitation may not apply to you.
This warranty gives you specific legal rights, and
you may also have other rights, which vary from
state to state.
5POS-189
2JAW-189
Please register this product at:
www.conair.com/registration
©2013 Conair Corporation
Service Center
Conair Corporation
Service Department
7475 North Glen Harbor Blvd.
Glendale, AZ 85307
13PG140638 IB-12092
CUT HERE
TRIMMER REPLACEMENT PARTS & ACCESSORIES ORDER FORM
Pricing in effect through June 1, 2015. Orders postmarked after this date
will be accepted, and the customer will be notified if pricing has changed.
5-Position Comb Attachment 5POS-189 $2.25
2 Jawline Combs 2JAW-189 $5.50
ITEM PART # PRICE QUANTITY AMOUNT
Mail to:
Conair Corporation
Service Department
150 Milford Road
East Windsor, NJ 08520-9730
Subtotal
Sales Tax*
TOTAL
Enclose check or money order made payable to Conair. (We cannot accept cash,
stamps or C.O.D. orders.) *CT, IL, AZ, and PA residents should add applicable state
sales tax. Minimum order of $10.00 or a $2.00 handling charge will be added to order.
All prices include handling and return postage.
Prices are subject to change without notice.
Prices are valid only for shipments within the continental United States.
Please allow 4–6 weeks for delivery.
To avoid delays, please print clearly.
We must have a street address, as UPS cannot deliver to a P.O. box.
NAME _________________________________________________________________________________________________
ADDRESS ___________________________________________ APT. ______________________________________________
CITY ________________________________________________STATE _________ ZIP________________________________
TELEPHONE ( ) _____________________________________________________________ (We call only if we have a question about your order.)
For information on other Conair haircut kit parts call: 1-800-3-CONAIR.


Produkt Specifikationer

Mærke: Conair
Kategori: Ikke kategoriseret
Model: GMT10NCS

Har du brug for hjælp?

Hvis du har brug for hjælp til Conair GMT10NCS stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Conair Manualer

Conair

Conair NPTCCA01 Manual

10 December 2024
Conair

Conair NPTCCA02 Manual

10 December 2024
Conair

Conair MASK2 Manual

1 Oktober 2024
Conair

Conair skn SFB11GK Manual

1 Oktober 2024
Conair

Conair Man GMTL6000 Manual

6 September 2024
Conair

Conair LNT1 Manual

6 September 2024
Conair

Conair Man GMT189R Manual

6 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Smeg

Smeg KIT6PX Manual

23 December 2024
Smeg

Smeg KIT6CX Manual

23 December 2024
Smeg

Smeg GTA-6 Manual

23 December 2024