Conair GMT8NCS Manual

Conair Ikke kategoriseret GMT8NCS

Læs nedenfor 📖 manual på dansk for Conair GMT8NCS (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/2
1. It is always best to begin with a clean, slightly
damp beard.
2. After you have combed through your beard in the
direction it grows naturally, you will want to outline
the desired shape, beginning under your jawline.
3. Begin defining your beard’s shape under your
chin and work upward on each side of your face
toward your ears. Then define
the upper outline of your beard
across your cheeks, past your
sideburns, and toward your
hairline.
B e a r d
&
Mus tach e
tr iMMer
M O D E L G M T 8 C S
I N S T R U C T I O N B O OK L E T
C O R D E D
•
P L U G - I N
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially when
children are present, basic safety precautions
should always be taken, including the following:
READ ALL INSTRUCTIONS
BEFORE USING
Keep away from water
DANGER – Any appliance is electrically
live, even when the switch is off.
To reduce the risk of death or injury by electric
shock:
1. Always unplug appliance from electrical
outlet immediately after using.
2. Do not place or store appliance where it
could fall or be pulled into a tub or sink.
3. Do not use appliance while bathing or in the
shower.
4. Do not place appliance in, or drop into, water
or other liquid.
5. If appliance has fallen into water, do not
reach for it. Unplug immediately.
6. Unplug this appliance before cleaning.
DO NOT REACH
INTO THE WATER
WARNING – To reduce the risk of
burns, electric shock, fire, or injury to persons:
1.
Never leave a plugged-in appliance unattended.
2. This appliance should not be used by, on,
or near children or individuals with certain
disabilities.
3. Use appliance only for its intended use as
described in this manual. Only use attach-
ments recommended by the manufacturer.
Do not use an extension cord to operate the
appliance.
4. Never operate the appliance if it has a
damaged cord or plug, is not working properly,
has been dropped or damaged, or dropped into
water. Return the appliance to a Conair service
center for examination and repair.
5. Keep the appliance cord away from heated
surfaces.
6. Do not pull, twist or wrap the cord around
the appliance.
7. Never drop or insert any object into any
opening of the appliance.
8. Do not place the appliance on any surface
while it is operating.
9. Do not use the appliance with a damaged
or broken comb or with teeth missing from the
blades, as injury may result. Before each use,
make certain the blades are aligned properly.
10. Do not use the appliance outdoors or
where aerosol (spray) products are being
used or oxygen is being administered.
11. Never operate the appliance with the air
openings blocks or while on a soft surface,
such as a bed or couch, where the air open-
ings may be blocked. Keep the air openings
free of lint, hair, and the like.
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY.
SAVE THESE
INSTRUCTIONS
USER MANUAL
This appliance is intended for household use.
Use on alternating current (120V AC 60HZ) only.
OPERATION
1. For dry location use only. Do not expose to
water.
2. When not in use, unplug unit completely.
3. Never operate this unit if the specification is
out of the rating.
4. When using this unit, a warm temperature
will be reached.
TROUBLESHOOTING
If your corded trimmer does not seem to be
functioning, take the following troubleshooting
steps before returning it for repair:
Be sure the electrical outlet is working by plug-
ging in another appliance to test the outlet.
OPERATING
INSTRUCTIONS
To reduce the risk of electric shock, this appli-
ance has a polarized plug (one blade is wider
than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully
into the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install
the proper outlet. Do not change the plug in
any way. Do not attempt to defeat this safety
feature.
USER MAINTENANCE
INSTRUCTIONS
TAKING CARE OF YOUR TRIMMER
OILING THE BLADES (OIL NOT INCLUDED)
About once a month you should oil the trimmer blades.
It is best to do this over a piece of newspaper. Turn the
trimmer on and hold it so that the blades are pointed
downward. Spread one drop of light mineral oil across
the blades, then turn the trimmer off and wipe away
the excess oil with a soft cloth.
Be careful not to use too much oil and don’t oil your
trimmer more than necessary, as this could damage
the motor. (Never attempt to oil the motor bearing, as it
is permanently lubricated.)
BLADE CARE
Because the trimmer blades are precision-made
for a very special use, they should always be
handled with care. Each time you finish using the
trimmer, brush away any loose hair that has col-
lected in the blades. Then store the trimmer until
the next use.
To promote the long life of the appliance, use
your trimmer only for the purpose intended by the
manufacturer – to trim your beard and mustache.
ON/OFF SWITCH
To operate, simply slide switch toward blade,
to stop, simply slide switch away from blade.
GROWING A BEARD AND MUSTACHE
There are three key factors that will determine
which beard or mustache style is best for you:
1. The shape and dimensions of your face.
2. The natural growth of your beard/ mustache.
3. The thickness of your beard/mustache. If you are
unsure about the type of beard or mustache that
would most suit your face, speak with a profes-
sional hair stylist and ask for an opinion on what
style would be best. Once your beard or mustache
has been styled, it is essential that you maintain its
appearance. To do this, use your trimmer to trim
your beard/mustache weekly.
For the best trimming results, your beard or mus-
tache should be slightly damp (NOT WET) when
using your trimmer. This will prevent the trimmer
from removing more hair than desired.
TYPES OF BEARDS/MUSTACHES
GETTING STARTED:
OUTLINING YOUR BEARD
TO TRIM YOUR BEARD OR MUSTACHE
1. The trimmer includes two jawline combs, which
provide lengths of 3mm (shortest) to 5mm (longest).
2. To use one of the attachments, press it down over
the trimmer blades until it clicks into position. At
first, until you become familiar with the combs, use
the longest comb first. (You can always go back and
make your beard or mustache a little shorter.).
3. Begin trimming your beard using smooth,
even strokes. Start with your sideburns and work
downward toward your chin. (Never attempt to trim
against the natural growth of your beard because
the hair will be cut too short.)
4. If you decide you want
a closer trim, you can
now switch to the shorter
comb (3mm) and go over
your beard again until you
achieve the desired length. Turn off the trimmer
and remove the attachment by gently pulling up
on the tab.
5. To trim your mustache, comb through your
mustache in the direction it grows.
6. Place the 5-position comb
over the facial hair blade
and snap it into position.
The 5-position comb provides
2-10mm.
7. After your mustache has been trimmed to the
desired length, remove the 5-position comb and,
using the blades only, define the outline of the
bottom of your mustache.
BLENDING THE JAWLINE
1. The two jawline attachments will also help you to
achieve a neat, finished trim under your chin.
2. Hold the trimmer in an upright position and begin
trimming under your jawline using short, even
strokes. Start with the longest comb and move to
the shorter combs for a closer trim.
CARE OF YOUR TRIMMER
REPLACEMENT (REMOVAL) OF BLADE SET
To remove blade set from
your trimmer, make sure
the trimmer is in the OFF
position. Remove the blade
set by placing thumb
against the smaller cutter
and pushing forward,
releasing the cutter assembly from the trimmer
housing. Replace with new cutting system and
reverse the removal procedure, only this time place
your thumb on the large cutter and snap into place.
GMT8CS
BEARD/MUSTACHE TRIMMER
5-position
Adjustable Comb
Multi-use Beard
& Mustache
Trimmer
Facial Hair Blade
LIMITED TWO YEAR WARRANTY
Conair will repair or replace (at our option) your unit free
of charge for 24 months from the date of purchase if the
appliance is defective in workmanship or materials.
To obtain service under this warranty, return the defective
product to the service center listed below, together with
your purchase receipt and $3.00 for postage and handling.
California residents need only provide proof of purchase
and should call 1-800-366-0937 for shipping instructions.
In the absence of a purchase receipt, the warranty period
shall be 24 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR
LIABILITIES, INCLUDING BUT NOT LIMITED TO THE
IMPLIED WARRANTY OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, SHALL BE
LIMITED IN DURATION TO THE 24 MONTH DURATION
OF THIS WRITTEN, LIMITED WARRANTY. Some states
do not allow limitations on how long an implied warranty
lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES
FOR BREACH OF THIS OR ANY OTHER WARRANTY,
EXPRESS OR IMPLIED, WHATSOEVER. Some states do
not allow the exclusion or limitation of special, incidental,
or consequential damages, so the above limitation may
not apply to you.
This warranty gives you specific legal rights, and you
may also have other rights, which vary from state
to state.
©2010 Conair Corporation
Service Center
Conair Corporation
Service Department
7475 North Glen Harbor Blvd.
Glendale, AZ 85307
09NG17000 IB-9666
TRIMMER REPLACEMENT PARTS & ACCESSORIES ORDER FORM
Pricing in effect through June 1, 2010. Orders postmarked after this date
will be accepted, and the customer will be notified if pricing has changed.
CUT HERE
Mail to:
Conair Corporation
Service Department
150 Milford Road
East Windsor, NJ 08520-9730
5-Position Attachment Comb AC-11 $2.25
2 Jawline Combs 2JAW-8 $3.70
Lubricating Oil HC-OIL $2.00
ITEM PART # PRICE QUANTITY AMOUNT
Subtotal
*Sales Tax
TOTAL
Enclose check or money order made payable to Conair. (We cannot accept cash, stamps or
C.O.D. orders.) CT, IL, AZ, and PA residents should add applicable state sales tax. Minimum
order of $10.00 or a $2.00 handling charge will be added to order.
All prices include handling and return postage. Prices are subject to change without
notice. Prices are valid only for shipments within the Continental United States. Please allow
4-6 weeks for delivery.
To avoid delays, please print clearly.
We must have a street address, as UPS cannot deliver to a P.O. box.
NAME _________________________________________________________________________________________________
ADDRESS ___________________________________________ APT. ______________________________________________
CITY ________________________________________________ _________ ZIP________________________________STATE
TELEPHONE ( ) _____________________________________________________________
(We call only if we have a question about your order.)
For information on other Conair® haircut kit parts call: 1-800-3-CONAIR.

Produkt Specifikationer

Mærke: Conair
Kategori: Ikke kategoriseret
Model: GMT8NCS

Har du brug for hjælp?

Hvis du har brug for hjælp til Conair GMT8NCS stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Conair Manualer

Conair

Conair MiniPRO CS80N Manual

1 Oktober 2024
Conair

Conair MASK2 Manual

1 Oktober 2024
Conair

Conair skn SFB11GK Manual

1 Oktober 2024
Conair

Conair Man GMTL6000 Manual

6 September 2024
Conair

Conair LNT1 Manual

6 September 2024
Conair

Conair Man GMT189R Manual

6 September 2024
Conair

Conair InfinitiPRO 998 Manual

3 September 2024
Conair

Conair CD117NN Manual

2 September 2024
Conair

Conair LLT2 Manual

2 September 2024
Conair

Conair CLS1X Manual

2 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Elektron

Elektron Overbridge Manual

26 November 2024
Elektron

Elektron Sidstation Manual

26 November 2024
SKROSS

SKROSS World Adapter Pro+ Manual

26 November 2024
SKROSS

SKROSS PRO – World & USB Manual

26 November 2024
SoundTube

SoundTube IPD-RS82-EZ Manual

26 November 2024
Kramer

Kramer 4x1VB Manual

26 November 2024
Kramer

Kramer RC-63A Manual

26 November 2024
SoundTube

SoundTube IPD-HP82-EZ Manual

26 November 2024
Kramer

Kramer RK-KVM-1U-PP3 Manual

26 November 2024
Gioteck

Gioteck VX-2 (PS3) Manual

26 November 2024