Conair InfinitiPRO CS1001 Manual

Conair Ikke kategoriseret InfinitiPRO CS1001

Læs nedenfor 📖 manual på dansk for Conair InfinitiPRO CS1001 (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/2
models CS1000/CS1001 – all versions
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be taken, including
the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER – Any appliance is electrically
live even when the switch is off. To reduce the
risk of death by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing or in the shower.
3. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
4. Do not place in, or drop into water or
other liquids.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING – To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. This appliance should never be left
unattended when plugged in.
2. Do not pull, twist, or wrap line cord
around appliance.
3. This appliance should not be used by,
on or near children or individuals with
certain disabilities.
4. Use this appliance only for its intended
use, as described in this manual. Do not
use attachments not recommended by
the manufacturer.
5. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly or if it has been dropped, damaged,
or dropped into water. Return the appliance
to an Authorized Service Center for
examination and repair.
6. Keep the cord away from heated surfaces.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening or hose.
9. Do not use outdoors or operate where aerosol
(spray) products are being used or where
oxygen is being administered.
10. Unit is hot when in use. Do not let heated
surface touch eyes or skin.
11. Do not place the heated unit directly on
any surface while it is hot or plugged in.
12. Never block the air openings of the
appliance or place it on a soft surface, such as
a bed or couch, where the air openings may
be blocked. Keep the air openings free of hair,
lint and other debris.
13. Do not use an extension cord with
this appliance.
14. Do not touch hot surfaces of the appliance.
Use handles or knobs.
15. Do not attempt to touch the housing of your
appliance near the plates, as it is hot when
in use.
16. This appliance is not a toy. Keep away
from children.
17. Do not use with a voltage converter.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This appliance is intended for household use.
Use on Alternating Current (60 hertz) only. This
unit is designed to be operated at 120V AC.
This appliance has a polarized plug (one blade is
wider than the other). As a safety feature, this
plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to defeat this
safety feature.
NOTE: Do not use this styling appliance on
hair extensions.
STYLING WITH THE NEW TOURMALINE
CERAMIC, EASY-GLIDE FLOATING PLATES
Both plates of your new flat iron are designed
with a little give to “float” in the iron. This
provides better contact with hair and eliminates
gaps to achieve straighter results faster. The
plates of your new flat iron have a tourmaline
ceramic, easy-glide surface, the newest
technology. This means it’s not only simpler to
clean off styling product residue, etc., after each
use, but you’ll find that hair glides easily over
the surface of the plates as you straighten. The
tourmaline ceramic surface also helps smooth
down flyaways and frizzies.
It evenly distributes heat so that the style you
create has a salon-perfect, silky smooth, shiny
finish. Hair also slips right off the plates after
it's straightened.
Tourmaline ceramic has natural ions for less
frizz and more shine.
GETTING STARTED
SWITCH ACTIVATION CONTROL
IMPORTANT! This appliance features delayed
activation control. Immediately after turning the
appliance on, you are able to adjust the
temperature. After 5 seconds of the appliance
being turned on, the control buttons will
automatically lock. To adjust the controls, hold
down the heat control buttons "HIGH" or "LOW"
button for 1-2 seconds. This will deactivate the
lock mode and allow the settings to be changed.
To turn off the appliance while in lock mode,
hold down the ON/OFF button until the appliance
switches off.
Plug the iron cord into any household outlet
(120V). Press and hold the ON/OFF button for
approximately 1 second to turn the appliance
on. The unit will heat up very quickly. Press
HIGH or LOW button to select your desired
temperature. Once the temperature has stopped
blinking on the LED, the unit is ready to use.
To turn unit off, press and hold the power
ON/OFF button again until light goes off.
WARNING: The iron’s plates will get very hot
within a few seconds and should not be
placed in contact with the skin after the iron
has been turned on.
The iron’s unique 5 ultra-high heat temperature
settings and instant heat technology provide
styling versatility for all hair types. If you have
fine hair, a low temperature will provide the best
results. If you have thick, wavy or hard-to-curl
hair, keep the heat setting on high. You can vary
the iron’s temperature according to your
particular need!
TEMPERATURE SETTING GUIDE
Low 300°F Fragile Hair
Medium 340°F Fine Hair
Med-High 375°F Medium/
Normal Hair
High 410°F Wavy/Curly Hair
High/Max 455°F Textured/
Thick Hair
TO STRAIGHTEN HAIR
Hair should be clean and completely dry before
using the flat iron. For best results, use a light
styling product before blow-drying hair.
1. Start with a hair section that is 1½ inches
wide and no more than ½ inch thick.
2. Open the iron and place the hair section
between the two hot plates, close to the scalp.
Trap hair between the plates by firmly squeezing
the handles together.
3. While maintaining the tension, slowly pull the
unit down along the hair section toward the
ends. At the ends, release the pressure on the
handle and allow the hair to slide out.
4. Repeat the process on additional sections
of hair until you achieve the hairstyle you desire.
It may be necessary to repeat the process on
certain areas, depending on the texture of
your hair.
Some experience is necessary when learning to
use this flat iron. After using the iron several
times, you will learn the ideal way to straighten
and style your hair.
ADD VOLUME AND SHAPE
To add flips and waves, secure ends between
plates and wrap hair around the outer housing.
It’s an easy way to add shape to straight styles.
Turn your wrist up or under to create flips and
add curl or more body.
NOTE: Never leave your flat iron on and
unattended. However, should you fail to turn
the iron off, it will shut itself off automatically
within 60 minutes.
GET TO KNOW
YOUR FLAT IRON
rature
Tourm
Cera
Plate
CS10
CS10
FEDERAL COMMUNICATIONS
COMMISSION NOTICE
WARNING: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not
cause harmful interference, and (2) This
device must accept any interference received,
including interference that may cause
undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
SUPPLIER’S DECLARATION
OF CONFORMITY
Brand: InfinitiPRO by Conair®
Model No.: CS1000
Description: Flat Iron
Responsible Party: Conair LLC,
1 Cummings Point Road, Stamford, CT 06902
(203) 351-9000
Standards: FCC Part 15 Subpart B,
ANSI C63.4-2014
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and (2) This device must
accept any interference received, including
interference that may cause undesirable
operation.
DATE OF ISSUE: MM/DD/YYYY
USER MAINTENANCE
Your appliance is virtually maintenance free.
No lubrication is needed. Keep all vents and
openings clear of dirt and dust. If cleaning
becomes necessary, disconnect the unit from
the power source, allow to cool and wipe
exterior with a cloth. If any abnormal condition
occurs, unplug the unit, allow it to cool, and
return it for repair to an Authorized Service
Center only. No repairs should be attempted by
the consumer.
CAUTION
NEVER allow the power supply cord to be pulled,
twisted, or severely bent. Never wrap the cord
tightly around the appliance. Damage will occur
at the high flex point of entry into the appliance,
causing it to rupture and short circuit. Inspect
the cord frequently for damage. Stop use
immediately if damage is visible or if unit stops
or operates intermittently.
STORAGE
When not in use, your appliance is easy to store.
Allow appliance to cool, then simply store out of
reach of children in a safe, dry location. Do not
jerk or strain cord at plug connections. Do not
wrap the line cord around the appliance. Allow
the cord to hang or lie loose and straight at the
point of entry into the appliance.
WARNING:
IF YOU THINK
THE POWER IS OFF
WHEN THE
SWITCH IS OFF,
YOU’RE WRONG.
KEEP AWAY FROM WATER
Everyone knows that electricity and water are
a dangerous combination. But did you know
that an electric appliance is still electrically
live even if the switch is off? If the plug is in,
the power is on. So when you are not using
your appliances, keep them unplugged.
ALWAYS UNPLUG
SMALL APPLIANCES
LIMITED FIVE-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your
unit free of charge for 60 months from the date
of purchase if the appliance is defective in
workmanship or materials.
To obtain service under this warranty, return the
defective product to the service center listed on
back, together with your purchase receipt.
California residents need only provide proof of
purchase and should call 1-800-3-CONAIR for
shipping instructions. In the absence of a
purchase receipt, the warranty period shall be
60 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS,
OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED IN
DURATION TO THE 60-MONTH DURATION OF
THIS WRITTEN, LIMITED WARRANTY. Some
states do not allow limitations on how long an
implied warranty lasts, so the above limitations
may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESS OR
IMPLIED, WHATSOEVER. Some states do not
allow the exclusion or limitation of special,
incidental, or consequential damages, so the
above limitation may not apply to you.
This warranty gives you specific legal rights,
and you may also have other rights, which vary
from state to state.
BEAUTY TIPS
To achieve the looks you love and
for more great InfinitiPRO by Conair®
products, visit infiniti.conair.com
Please register this product at
www.conair.com/registration
For info on any Conair or InfinitiPRO by Conair
product, call or visit us 1-800-3-CONAIR
on the web at www.conair.com/infiniti
Service Center
Conair LLC
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
©2022 Conair LLC
22PA082571 IB-17464B

Produkt Specifikationer

Mærke: Conair
Kategori: Ikke kategoriseret
Model: InfinitiPRO CS1001

Har du brug for hjælp?

Hvis du har brug for hjælp til Conair InfinitiPRO CS1001 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Conair Manualer

Conair

Conair MiniPRO CS80N Manual

1 Oktober 2024
Conair

Conair MASK2 Manual

1 Oktober 2024
Conair

Conair skn SFB11GK Manual

1 Oktober 2024
Conair

Conair Man GMTL6000 Manual

6 September 2024
Conair

Conair LNT1 Manual

6 September 2024
Conair

Conair Man GMT189R Manual

6 September 2024
Conair

Conair InfinitiPRO 998 Manual

3 September 2024
Conair

Conair CD117NN Manual

2 September 2024
Conair

Conair LLT2 Manual

2 September 2024
Conair

Conair CLS1X Manual

2 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Gigabyte

Gigabyte ODIN GT 550W Manual

23 November 2024
Vitec

Vitec MGW Diamond-HX OG Manual

23 November 2024
Stamos

Stamos SWG-PTABLE-100PCT Manual

23 November 2024
Stamos

Stamos S-PLASMA 60U Manual

23 November 2024
Velbus

Velbus VMBPIRO-W-20 Manual

23 November 2024
Honor

Honor 90 Pro Manual

23 November 2024
Honor

Honor 80 SE Manual

23 November 2024
Medela

Medela Safe & Dry Manual

22 November 2024
Stamos

Stamos S-PLASMA 70-IGBT Manual

22 November 2024
Jane

Jane First Potty Manual

22 November 2024