Conair LT85 Manual


Læs nedenfor 📖 manual på dansk for Conair LT85 (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 19 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
FIG. 1
lt85_18pg050897_ib_final.indd 1
lt85_18pg050897_ib_final.indd 1
lt85_18pg050897_ib_final.indd 1
lt85_18pg050897_ib_final.indd 1lt85_18pg050897_ib_final.indd 1 1/22/18 3:59 PM
1/22/18 3:59 PM
1/22/18 3:59 PM
1/22/18 3:59 PM1/22/18 3:59 PM
all-in-one facial trim system
SATINY SMOOTH®
always read the instruction book carefully before using.
MODEL LT85
SAVE THESE
INSTRUCTIONS
WARNING
1. Women whose skin is sensitive to cosmetics
or easily irritated by shaving, or who suffer from
a skin allergy, should test one section of the leg
or arm before using the shaver head.
2. Do not use this appliance with damaged or
broken foil and blade, as injury may occur.
3. When cleaning, use cold or warm water.
Do not use hot water, sea water, or cleaners,
as they can cause damage to the waterproof
seals.
4. Use in or out of the shower, but do not leave
the entire unit submerged in water.
5. This appliance is not a toy. Keep away
from children.
TROUBLESHOOTING
There are several things to look for if your unit
fails to operate:
1. Be sure the power handle is turned ON.
2. Make sure that the battery is properly placed
in the battery compartment. Test the battery to
be sure it is working.
3. Check the blades to see if they are clogged
with hair clippings; if so, use the cleaning brush
to remove hair.
4. If the unit still fails to operate, take or send
it to a Conair Service Center (see warranty
procedure and addresses).
OPERATING
INSTRUCTIONS
FOR YOUR ALL-IN-ONE
FACIAL TRIM SYSTEM
FOR HOUSEHOLD
USE ONLY
OPERATING INSTRUCTIONS
BATTERY INSTALLATION:
1. Twist bottom housing of unit to the left and
align triangles and
and pull (see FIG. 1).
2. Insert 1 AA battery
(not included).
3. Slide bottom housing
back in place and align
and .
4. Ensure the battery is
installed correctly
with regard to polarity
(+ and -).
5. Remove the battery if it is no longer functional
or if the trimmer is left unused for an extended
period of time.
6. Clean the battery contacts and also those of
the device prior to battery installation.
7. Remove used battery promptly.
8. Always purchase the correct size and grade
of battery most suitable for its intended use.
GETTING STARTED
TO SWITCH TRIMMER HEADS
1. Make sure the unit is turned off.
2. Turn head to the right, aligning triangles
and (see FIG. 2).
3. Switch the attachment head and put new
head on, then turn to the left and align with
(see FIG. 3).
FIG. 2 FIG. 3
INSTRUCTIONS FOR USE
1. Twist the battery cover to the left to unlock
battery cover.
2. Insert 1 AA battery according to the polarity
marking, return the battery cover, turn to the
right and align with “ and marks to lock,
and then twist to the right again. The unit will
start to work when the “ and marks
are alligned.
3. After use, turn off the power by making the
of the battery cover align with “ mark
(see FIG. 1).
BEFORE USE:
1. Test one small section of the leg or arm
before using any of the attachments on the rest
of the body.
2. If any sensitivity or allergic reactions occur,
discontinue use immediately.
3. Do not use on sensitive or irritated skin.
USING THE ROTARY SHAVER
Never use a foil that is damaged, as this can
result in injury. This appliance is suitable for dry
and wet shaving!
SHAVING
1. Attach the shaver head.
2. Twist the battery cover to the right and align
” and marks to start the unit.
3. Hold the shaving foil against the skin, moving
the shaver slowly and smoothly in circular
motions against the grain of your natural
hair growth.
4. Don’t push too hard against the skin as this
will cause irritation and may damage the foil.
5. As your skin may be sensitive after shaving,
test your moisturizer on a small patch of skin
and wait to see if irritation occurs.
6. Cleaning: After each use, you will need to
clean the shaver head to ensure continued
performance.
7. Twist the battery cover to the left and align
and marks to turn the unit off.
NOTE: If you are switching to an electric or
battery-operated shaver for the first time, it will
take 12 uses for your skin and hair to adjust
to this new method of removing hair. Do not
evaluate performance until you have allowed
your skin and hair time to adjust.
HOW TO CLEAN YOUR
SHAVER HEAD
This is a water-resistant appliance. The
appliance may be cleaned under warm or
cold water.
NOTE: When cleaning your unit, make sure the
unit is turned off.
CAUTION!
• To clean the external surfaces of the
appliance, use a damp cloth. Do not use strong
detergents or other chemicals.
To dry, wipe the surface of the appliance with
a dry towel. Do not use a hair dryer or heater to
dry the appliance.
CLEANING AFTER EVERY USE:
1. To take the shaver head off, twist the top of
the head from to the right and align the
arrows to remove (See FIG. A–C).
2. To take the shaver cover off, twist the top
cover of the head from to the left and align
the arrows to remove (see FIG. D–E).
3. Rinse the shaver cutter and foil frame under
running water or in a sink. Do not use hot water.
Use only warm or cold water (see FIG F–G).
4. After wet cleaning, allow the foil frame and
cutters to air-dry before closing foil frame and
shaver head. Replace shaver head back onto
the main unit until it clicks into place. Wipe the
surface of the main unit with a dry towel.
DEEPLY CLEANING EVERY MONTH:
1. Perform the cleaning steps FIG. A to FIG. E.
2. Remover the inner cutter lock away from the
cutters (see FIG. H).
3. Remove the cutters (see FIG. I).
4. Thoroughly rinse away any debris from inner
and outer cutters (see FIG. J).
5. Replace the inner cutters by matching the
inner cutters to the corresponding outer cutter
hub (see FIG. K).
6. Place inner cutter lock back into position by
sliding it back into the support until it snaps into
place (see FIG. L).
7. Snap shaver head assembly back onto
main unit.
USING THE BIKINI TRIMMER
1. Start with the guide comb attached for
first-time use.
2. Turn the unit on.
3. To fully remove hair or to outline the
bikini area, use the trimmer without the
attachment comb.
4. When removing hair, gently move the blades
against the direction of growth.
5. To outline, place the blades perpendicular
to the skin surface and apply the blades to the
edge of the hair. Use the blades to create the
desired outline.
6. For the cleanest finish, follow up with the
foil shaver.
7. For cutting hair without completely removing
it, attach the detail comb to the head. Place the
comb on the cutting blades first, align the comb
ribs with top surface of trimmer head housing
and then snap down onto the back of the
trimming head (see FIG. 4).
8. Snap off the comb guide to release from the
trimmer head (see FIG. 5).
FIG. 4
FIG. 5
USING THE EYEBROW TRIMMER
1. This trimmer comes with two trimming blades.
The larger blade can be used to trim body hair
and eyebrows. The smaller blade is ideal for
detailing. It also comes with a comb attachment
that helps you achieve an even cut when you
do not want to completely remove the hair.
The comb attachment has two sides: The long
tooth is for body hair, and the short tooth is for
eyebrow trimming.
2. Aligning the indicator with the 6mm mark on
the comb leaves hair longer, while aligning with
the 3mm mark leaves hair shorter (see FIG. 6).
3. To use the comb attachment, be sure the unit
is in the OFF position and slide the comb over
the trimming blades (see FIG. 7). Make sure that
the teeth of the comb are facing in the same
direction as the trimming blade, and that the top
of the comb is even with the top of the trimmer.
If you want to completely remove hair, use the
trimmer without the comb attachment.
4. To operate the trimmer, turn the battery cover
to the right so arrow points to the mark.
When fi nished trimming, turn the unit off by
turning the battery cover to the left, so arrow
points to mark.
5. To store the trimmer, slide the comb
attachment cover over the trimming blades.
FIG. 6
FIG. 7
TAKING CARE
OF YOUR TRIMMER
BLADE CARE
Because the trimmer blades are precision made
for a very special use, they should always
be handled with care. Each time you finish
using the trimmer, take the cleaning brush
provided and brush away any loose hair that
has collected in the blades, then rinse blades
under water only, allow to air-dry and store the
trimmer until the next use.
To promote the long life of the appliance, use
your trimmer only for the purpose intended by
the manufacturer.
CAUTION
1. When shaking off excess water, hold the
main unit firmly to prevent releasing the head
assembly or dropping the unit.
2. Do not use a dryer or heater to dry the
trimmer. This may result in malfunction or
damage to the trimmer.
LIMITED TWO-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your
unit free of charge for 24 months from the
date of purchase if the appliance is defective in
workmanship or materials.
To obtain service under this warranty, return the
defective product to the service center listed
on back, together with your purchase receipt
and $5.00 for postage and handling. California
residents need only provide proof of purchase
and should call 1-800-3-CONAIR for shipping
instructions. In the absence of a purchase receipt,
the warranty period shall be 24 months from the
date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS,
OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE SHALL BE LIMITED IN
DURATION TO THE 24-MONTH DURATION OF
THIS WRITTEN, LIMITED WARRANTY.
Some states do not allow limitations on how long
an implied warranty lasts, so the above limitations
may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESS OR
IMPLIED, WHATSOEVER.
Some states do not allow the exclusion or
limitation of special, incidental, or consequential
damages, so the above limitation may not apply
to you.
This warranty gives you specific legal rights, and
you may also have other rights, which vary from
state to state.
Please register this product at
www.conair.com/registration
©2018 Conair Corporation
Service Center
Conair Corporation
Service Department
7475 North Glen Harbor Blvd.
Glendale, AZ 85307
18PG050897
IB-15526


Produkt Specifikationer

Mærke: Conair
Kategori: Ikke kategoriseret
Model: LT85

Har du brug for hjælp?

Hvis du har brug for hjælp til Conair LT85 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Conair Manualer

Conair

Conair MASK2 Manual

1 Oktober 2024
Conair

Conair skn SFB11GK Manual

1 Oktober 2024
Conair

Conair Man GMTL6000 Manual

6 September 2024
Conair

Conair LNT1 Manual

6 September 2024
Conair

Conair Man GMT189R Manual

6 September 2024
Conair

Conair CD117NN Manual

2 September 2024
Conair

Conair LLT2 Manual

2 September 2024
Conair

Conair CLS1X Manual

2 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Gigabyte

Gigabyte ODIN GT 550W Manual

23 November 2024
Stamos

Stamos S-PLASMA 60U Manual

23 November 2024
Velbus

Velbus VMBPIRO-W-20 Manual

23 November 2024
Honor

Honor 90 Pro Manual

23 November 2024
Honor

Honor 80 SE Manual

23 November 2024
Medela

Medela Safe & Dry Manual

22 November 2024
Jane

Jane First Potty Manual

22 November 2024