Conair LWD5RN Manual


Læs nedenfor 📖 manual på dansk for Conair LWD5RN (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 28 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
FOIL SHAVER
satiny smooth®
Instruction Booklet
For your safety and continued enjoyment
of this product, always read the instruction
booklet carefully before using.
LWD5 MODELS
Congratulations on the purchase of your new
portable shaver. For maximum satisfaction
when using this quality product, please take a
minute to read the following operating and
care instructions. Thank you for choosing
Conair, the #1 brand in personal care
appliances.
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance, basic safety
precautions should always be taken, including
the following:
READ ALL
INSTRUCTIONS
BEFORE USING
DANGER To reduce the risk of
death or serious injury from electrical shock:
1. Do not place or store shaver where it can
fall into a tub or sink. Do not place or drop
into water or other liquids.
2. Always turn this shaver off before cleaning.
3. Do not reach for an appliance that has
fallen into water.
WARNING
To reduce the risk of burns, fire, electrical
shock, or injury to persons:
1. This appliance should not be used by, on,
or near children or individuals with certain
disabilities.
2. Use this appliance only for its intended use
as described in this manual. Do not use
attachments not recommended by the
manufacturer.
3. Never drop or insert any object into any
opening.
4. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
5. Do not use this appliance with damaged or
broken foils, as injury may occur.
6. This appliance is not a toy. Keep away
from children.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
IMPORTANT
This shaver has been engineered to give you
a clean, close, smooth shave. It requires 2
AAA batteries (not included). We recommend
using longer-lasting, alkaline batteries in your
shaver. If you are not going to use your
shaver for a long period of time or if the
batteries are dead, remove or replace the
batteries from the unit.
At first, your shave might not be as close as
you expect. However, this is normal. It takes
time for your skin and hair to adjust to the
new procedure and for you to learn how to
effectively use the shaver. Caution: Most
blade users will push too hard and therefore
not get a satisfactory shave. You must press
gently so the hair can get into the holes of the
foil; pressing too hard makes the hair flat.
Please be patient; use your shaver 10 to 12
times before you judge its performance.
FOR HOUSEHOLD USE ONLY
OPERATING INSTRUCTIONS
1. Twist the clasp in the direction of the arrows
indicated on the battery door to remove the
battery compartment cover.
2. Insert the batteries according to the polarity
markings above the battery compartment.
3. Line up the dash (-) lines on both the battery
door and the shaver body to push the battery
compartment cover back into the shaver.
4. Turn the clasp back to its original position to
secure the battery door in place.
5. To use your shaver, remove the transparent
cover and press the ON/OFF button.
6. After you finish using your shaver, press
the ON/OFF button to turn the shaver off.
7. Ensure the batteries are installed correctly
with regard to polarity (+ and -).
8. Remove the batteries if the batteries are
no longer functional or if the shaver is left
unused for an extended period of time.
9. Clean the battery contacts and also those
of the device prior to battery installation.
10. Remove used batteries promptly.
11. Always purchase the correct size and grade
of battery most suitable for the intended use.
12. Replace all batteries of a set at the same
time.
13. Do not mix old and new batteries. Do not
mix alkaline, standard (carbon-zinc), or
rechargeable (nickel cadmium or nickel metal
hydride) batteries.
WET/DRY FEATURE
This device is water resistant. It may be exposed
to splashing water in the shower, and can be
rinsed clean under the faucet, but should never
be completely submerged in water.
CAUTION
Do not submerge the unit in water or other
liquids. The foil is delicate and must be handled
very carefully.
BEFORE SHAVING
1. Be certain that your skin is clean. If you
have sensitive skin, you may want to apply
talcum powder before and after you shave.
2. Clean your shaver after each use. This will
ensure the best performance. (Please refer to
“How to Clean Your Shaver” section for
further instructions.)
INSTRUCTIONS FOR USE
1. Press the ON/OFF button to turn on.
2. After each shave, switch the unit off and
clean shaver head.
SHAVING YOUR LEGS/BIKINI AREA
NOTE: Pushing the shaver against the skin too
hard will not allow the hairs to enter the foil
and be cut. Experience will show just the right
pressure to use to maximize performance.
1. Prepare your legs for wet or dry shaving.
2. Turn shaver on.
3. Shave with smooth, steady strokes up and
down your skin.
4. Keep the full shaving head in contact with
your skin.
5. For best results, shave against the direction
of hair growth.
6. When you finish shaving, turn the shaver off.
Important: After several uses, you will be able
to determine the optimum shaving method for
your legs and bikini area.
SHAVING YOUR UNDERARMS
1. Prepare your underarms for shaving.
(Be sure that your skin is clean and free of
deodorant.)
2. Turn the shaver on.
3. Lift your arm until the skin under the arm
stretches slightly.
4. Hold the shaver so that it is in full contact with
your skin, and shave with gentle strokes.
5. It is important to press lightly. Pressing too
hard may lead to skin irritation.
6. When finished shaving, turn the shaver off.
Important: After several uses, you will be able to
determine the optimum shaving method for your
underarms.
HOW TO CLEAN YOUR SHAVER
1. Make sure unit is in the OFF position before
cleaning your shaver.
2. Hold unit and lift up shaver head from both
sides. (FIG. 1) Be careful not to push on the foil. It is
delicate and can easily be damaged.
FIG. 1
Lift
Hold here
Hold here
3. Rinse the shaver head under running water or in
a sink. Do not use hot water. Use only warm or
cold water. Never completely submerge the unit.
4. After wet cleaning, allow the shaver head to
air-dry before replacing. Replace shaver head back
onto the shaver until it clicks into place. Wipe the
surface of the main unit with a dry towel. Do not
dry the foil area. Let the shaving foil air-dry.
5. If the body of the shaver becomes dirty, wipe
off with a damp cloth and mild detergent or soap.
Never use thinners, other solvents, or any harsh
cleaners.
6. Once dry, carefully replace the protective cap.
CAUTION
1. When shaking off excess water, hold the
main unit firmly to prevent releasing the head
assembly or dropping the unit.
2. Do not use a dryer or heater to dry the shaver.
This may result in malfunction or damage to the
shaver.
REPLACING THE
SHAVER HEAD
Replace the shaver head when you find you
have to push harder on the shaver to get a
close shave, or if you have to go over an area
more often to get a smooth result. It is also
time to replace the shaver head if you
experience skin irritation. Replacement time
will depend on how often you use your shaver
and how quickly your hair grows.
FIG. 2
Lift
Hold here
Hold here
1. Remove the shaver head. (FIG. 2)
Guide down
Hold here
Hold here
FIG. 3
2. Hold the replacement shaver head firmly on
the sides and guide it gently into the inner
mount until it locks into place. (FIG. 3)
Snap into place
FIG. 4
3. Press firmly until the shaver head snaps into
place. (FIG. 4)
LIMITED ONE-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your unit free
of charge for 12 months from the date of purchase if
the appliance is defective in workmanship or materials.
To obtain service under this warranty, return the
defective product to the service center listed on
back, together with your purchase receipt and
$5.00 for postage and handling. California residents
need only provide proof of purchase and should call
1-800-3-CONAIR for shipping instructions. In the
absence of a purchase receipt, the warranty period
shall be 12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR
LIABILITIES, INCLUDING BUT NOT LIMITED TO THE
IMPLIED WARRANTY OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, SHALL BE
LIMITED IN DURATION TO THE 12-MONTH DURATION
OF THIS WRITTEN, LIMITED WARRANTY.
Some states do not allow limitations on how long an
implied warranty lasts, so the above limitations may
not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR
ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES FOR BREACH OF THIS OR ANY OTHER
WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER.
Some states do not allow the exclusion or limitation of
special, incidental, or consequential damages, so the
above limitation may not apply to you.
This warranty gives you specific legal rights, and
you may also have other rights, which vary from state
to state. Please register this product at
www.conair.com/registration
Service Center
©2017 Conair Corporation
Service Department
7475 North Glen Harbor Blvd.
Glendale, AZ 85307
16PG025249 IB-14750


Produkt Specifikationer

Mærke: Conair
Kategori: Ikke kategoriseret
Model: LWD5RN

Har du brug for hjælp?

Hvis du har brug for hjælp til Conair LWD5RN stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Conair Manualer

Conair

Conair NPTCCA01 Manual

10 December 2024
Conair

Conair NPTCCA02 Manual

10 December 2024
Conair

Conair MASK2 Manual

1 Oktober 2024
Conair

Conair skn SFB11GK Manual

1 Oktober 2024
Conair

Conair Man GMTL6000 Manual

6 September 2024
Conair

Conair LNT1 Manual

6 September 2024
Conair

Conair Man GMT189R Manual

6 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Smeg

Smeg KIT6PX Manual

23 December 2024
Smeg

Smeg KIT6CX Manual

23 December 2024
Smeg

Smeg GTA-6 Manual

23 December 2024