Conair MiniPRO CS80N Manual

Conair Ikke kategoriseret MiniPRO CS80N

Læs nedenfor 📖 manual på dansk for Conair MiniPRO CS80N (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 14 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
STRAIGHTEN AND STYLE
BOL
of this product, always read the instruction
booklet carefully before using.
Respect the Ritual®
Model CS80CM
IMPORTANT
SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be taken,
including the following:
READ ALL
INSTRUCTIONS
BEFORE USING
KEEP AWAY
FROM WATER
DANGER Any appliance is
electrically live even when the switch is off.
To reduce the risk of death by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing or in the shower.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in, or drop into, water or
other liquids.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING To reduce the risk
of burns, electrocution, fire, or injury
to persons:
1. This appliance should never be left
unattended when plugged in.
2. This appliance should not be used by,
on, or near children or individuals with
certain disabilities.
3. Use this appliance only for its intended
use as described in this manual. Do not use
attachments not recommended by the
manufacturer.
4. Do not use an extension cord to
operate appliance.
5. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, if it has been dropped or
damaged, or dropped into water. Return
the appliance to an authorized service
center for examination and repair.
6. Keep the cord away from heated surfaces.
7. Do not pull, twist, or wrap line cord around
appliance, even during storage.
8. Never block the air openings of the
appliance or place it on a soft surface, such
as a bed or couch, where the air openings
may be blocked. Keep the air openings free
of lint, hair, and the like.
9. Never use while sleeping.
10. Never drop or insert any object into any
opening or hose.
11. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
12. This beard and mustache tool is hot
when in use. Do not let heated surfaces
touch eyes or skin.
13. Do not place the heated beard and
mustache tool directly on any surface or
on the appliance power cord while it is
hot or plugged in.
14. Before plugging in, read the information
about dual voltage contained in the
Operating Instructions section of this manual.
15. Do not attempt to touch the housing of
your appliance near the straightening plates,
as it is hot when in use.
16. Do not touch hot surfaces of the
appliance. Use the handles or knobs.
17. Do not operate with a voltage converter.
18. This appliance is not a toy. Keep away
from children.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This beard and mustache tool is intended for
household use. This unit is designed to
operate at 120–240 volts AC. Use on
Alternating Current (50/60 hertz) only.
This appliance has a polarized plug (one
blade is wider than the other). As a safety
feature, this plug will fit in a polarized outlet
only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
NOTE: Do not use this styling appliance
on hair extensions.
DUAL VOLTAGE
This beard and mustache tool will automati-
cally adjust to the proper voltage. Use an
adapter plug with correct configuration prior
to use in outlet.
GETTING STARTED
Plug the beard and mustache tool cord
into any household outlet 120V–240V.
Slide switch to ON position. Red LED light
will indicate power is on. The beard and
mustache tool will heat up very quickly. To
turn off, slide to OFF position. Red light will
go off. Never leave your beard and mustache
tool on and unattended.
WARNING: The beard and mustache tool’s
ceramic-coated plates will get very hot
within a few seconds and should not come
into contact with the skin after the has unit
been turned on.
STYLING WITH THE NEW EASY-GLIDE
CERAMIC-COATED PLATES
The plates of your new beard and mustache
tool have an easy-glide ceramic surface, the
latest in technological advances. The
ceramic even-heat distribution produces the
ultimate in silky, shiny, healthy-looking hair.
You’ll find that hair glides easily over the
surface of the plates as you’re straightening,
and that it is easier to clean styling product
residue, etc., off the plates after each use.
The ceramic surface also helps smooth down
flyaways and frizzies. As you smooth your
hair, heat is evenly distributed so that
the style you create has a silky smooth,
shiny finish. Hair also glides right through
the plates after it’s straightened.
GET TO KNOW YOUR
CERAMIC BEARD AND
MUSTACHE TOOL
The new ceramic technology is a pleasure
to work with — it makes styling your hair
easier and provides professional results.
TO STRAIGHTEN BEARD AND HAIR
Make sure beard and hair is fully dry.
1. Open the styler and place a hair section
between the two hot plates, close to the
root.
2. Trap hair between the plates by firmly
squeezing the handles together.
3. While maintaining the tension, slowly pull
the unit down along the hair section toward
the ends.
4. At the end of hair section, release the
pressure on the handle and allow the hair
section to slide out.
5. Repeat the process on additional sections
of hair until you achieve the hairstyle you
desire.
It may be necessary to repeat the process
on certain areas, depending on the texture
of your hair.
Some experience is necessary when
learning to use this beard and mustache
tool. After using the iron several times, you
will learn the ideal way to straighten and
style your hair easily.
USER MAINTENANCE
Your beard and mustache tool is virtually
maintenance free. No lubrication is needed.
Keep all vents and openings clear of dirt and
dust. If cleaning becomes necessary,
disconnect the unit from the power source,
allow to cool and wipe exterior with a cloth. If
any abnormal condition occurs, unplug the
unit, allow it to cool, and return it for repair to
an authorized service representative only. No
repairs should be attempted by the consumer.
CAUTION
NEVER allow the power supply cord to be
pulled, twisted, or severely bent. Never
wrap the cord tightly around the appliance.
Damage will occur at the high flex point of
entry into the appliance, causing it to rupture
and short circuit. Inspect the cord frequently
for damage. Stop use immediately if damage
is visible or if unit stops or operates
intermittently.
STORAGE
When not in use, your appliance is easy to
store. Allow appliance to cool, then store out
of reach of children in a safe, dry location.
Do not jerk or strain cord at plug
connections. Do not wrap cord tightly
around appliance. Allow the cord to hang or
lie loose and straight at the point of entry
into the appliance.
WARNING:
IF YOU THINK
THE POWER IS OFF
WHEN THE SWITCH
IS OFF,
YOU’RE WRONG.
KEEP AWAY
FROM WATER
Everyone knows that electricity and water
are a dangerous combination. But did you
know that an electric appliance is still
electrically live even if the switch is off?
If the plug is in, the power is on. So when
you are not using your appliances, keep
them unplugged.
ALWAYS UNPLUG
SMALL APPLIANCES
LIMITED TWO-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace, at our option,
your appliance free of charge for 24 months
from the date of purchase if the appliance is
defective in workmanship or materials.
To obtain service under this warranty, return
the defective product to the service center
listed on back, together with your purchase
receipt. California residents need only
provide proof of purchase and should call
1-800-3-CONAIR for shipping instructions.
In the absence of a receipt, the warranty
period shall be 24 months from the date
of manufacture.
ANY IMPLIED WARRANTIES, OBLIGA-
TIONS, OR LIABILITIES, INCLUDING BUT
NOT LIMITED TO THE IMPLIED WARRANTY
OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE, SHALL BE
LIMITED IN DURATION TO THE 24-MONTH
DURATION OF THIS WRITTEN, LIMITED
WARRANTY. Some states do not allow
limitations on how long an implied warranty
lasts, so the above limitations may not
apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH
OF THIS OR ANY OTHER WARRANTY,
EXPRESS OR IMPLIED, WHATSOEVER. Some
states do not allow the exclusion or limitation
of special, incidental, or consequential
damages, so the above limitation may not
apply to you. This warranty gives you specic
legal rights, and you may also have other
rights, which vary from state to state.
Please register this product at
www.conair.com/registration
SERVICE CENTER
CONAIR LLC
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
©2021 Conair LLC
For info on any Conair product,
call 1-800-3-CONAIR or visit us
on the web at www.conair.com
21PA077894 IB-17208


Produkt Specifikationer

Mærke: Conair
Kategori: Ikke kategoriseret
Model: MiniPRO CS80N

Har du brug for hjælp?

Hvis du har brug for hjælp til Conair MiniPRO CS80N stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Conair Manualer

Conair

Conair NPTCCA01 Manual

10 December 2024
Conair

Conair NPTCCA02 Manual

10 December 2024
Conair

Conair MASK2 Manual

1 Oktober 2024
Conair

Conair skn SFB11GK Manual

1 Oktober 2024
Conair

Conair Man GMTL6000 Manual

6 September 2024
Conair

Conair LNT1 Manual

6 September 2024
Conair

Conair Man GMT189R Manual

6 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Inglesina

Inglesina Front Manual

22 December 2024
Inglesina

Inglesina Welcome Pod Manual

22 December 2024
Protector

Protector AS-5120 Manual

22 December 2024
Zipper

Zipper ED500FW Manual

22 December 2024
Roland

Roland PDQ-8 Manual

22 December 2024
Panasonic

Panasonic DMW-LMCH62E Manual

21 December 2024
Philips

Philips DLP2015 Manual

21 December 2024