Conair NPTCCB01 Manual


Læs nedenfor 📖 manual på dansk for Conair NPTCCB01 (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 12 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
The Curl
Collective
-in-
Blowout
ons
ng Guide
safety and
d enjoyment
product, always
he instruction
carefully before
ng.
odel NPTCCB01
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be taken, including
the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY
FROM WATER
DANGER Any appliance is electrically
live even when the switch is off. To reduce the
risk of death or injury by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing or in the shower.
3. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
4. Do not place in, or drop into water or
other liquids.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. This appliance should never be left
unattended when plugged in.
2. This appliance should not be used by, on,
or near children or individuals with certain
disabilities.
3. Use this appliance only for its intended
use as described in this manual. Do not
use attachments not recommended by the
manufacturer.
4. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, or if it has been dropped, damaged,
or dropped into water. Return the appliance
to a Conair Service Center for examination
and repair.
5. Keep the cord away from heated surfaces.
Do not pull, twist, or wrap line cord around
appliance, even during storage.
6. Never block the air openings of the appliance
or place it on a soft surface, such as a bed or
couch, where the air openings may be blocked.
Keep the air openings free of lint, hair, and
the like.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening or hose.
9. Do not use outdoors or operate where aerosol
(spray) products are being used or where
oxygen is being administered.
10. Do not use an extension cord to operate hot
air styler.
11. Do not direct hot air toward eyes or other
heat-sensitive areas.
12. Attachments may be hot during use.
Allow them to cool before handling.
13. Do not place appliance on any surface while
it is operating.
14. While using the appliance, keep your hair
out of it. Keep your hair away from the air inlets.
15. Do not use with a voltage converter.
16. This appliance is not a toy. Keep away
from children.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This appliance is intended for household use
only. Use on Alternating Current (60 hertz) only.
Standard hot air stylers are designed to operate
at 110 to 125 volts AC.
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature, this
plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to defeat this safety
feature.
NOTE: Do not use this styling appliance on
hair extensions.
IMPORTANT
SAFETY PLUG
INSTRUCTIONS
This hair dryer is equipped with an auto-
monitoring ALCI safety plug.
READ AND SAVE THE INSTRUCTIONS
PROVIDED IN A SEPARATE LEAFLET.
TOURMALINE CERAMIC
TECHNOLOGY
This hot air styler has tourmaline ceramic
heat, which eliminates damaging hot spots for
beautiful, frizz-free shine.
IONIC TECHNOLOGY
Many aspects of modern living, including air con-
ditioning, contact with man-made fibers and air
pollution contribute to a buildup of static elec-
tricity in the hair. Even brushing and towel-drying
the hair, can increase these levels, causing the
surface of the cuticle to become rough.
Consequently, hair may have a dull appearance.
Also, high levels of static charge cause hair to
become flyaway and difficult to style.
The ion generator produces a stream of nega-
tive ions that act to neutralize the static charge,
smoothing the scales on the cuticle for shiny,
smooth and manageable hair, so you can achieve
your desired style easily.
THE IONIZING FUNCTION
Generates negative ions to:
neutralize the generally positive charge on
flyaway, frizzy hair
eliminate static electricity
contribute to shine
NOTE: The unit may produce a clicking
sound at times, which is normal for a
high-output ion generator.
GETTING STARTED
After shampooing your hair, towel-dry and
untangle it carefully with a large-toothed comb.
Always start untangling your wet hair at the
tips, then gradually work your way up. Gentle
untangling prevents split ends from forming.
You may now finish drying and styling your hair
using your hot air styler. Make sure your desired
attachment is locked into place. Plug styler
into outlet. Slide switch to turn appliance
ON/OFF.
FEATURES
1000 Watts
High-shine ionic conditioning
3 heat settings, plus cool shot
Professional power cord
DRYER HANDLE
Use handle without attachment to remove
excess moisture from hair before styling.
OVAL BRUSH
Ceramic-coated barrel with nylon and epoxy-
tipped bristles for smooth volume.
ROUND BRUSH
Thermal 1½ in. brush with wavy bristles for
detailed styling.
PADDLE BRUSH
Smoothes and adds shine to all hair types
and lengths.
TO SWITCH ATTACHMENTS
Fit an attachment onto the body of the unit by
lining up the guides on the two parts and then
pressing the two parts together until you hear
a click. To remove an attachment, press on the
unlocking buttons located on the sides of the
unit and gently pull the attachment off.
HEAT/SPEED SETTINGS
Cool Setting: This position combines ideal
airflow and temperature setting for shaping
finer, damaged or treated hair.
Low Setting: Ideal airflow for medium,
normal hair.
High Setting: Combines ideal airflow with
higher temperature for thick hair.
Cool Shot: Using the cool shot button at the
end sets the style for a long-lasting effect.
GET TO KNOW YOUR STYLER
1½ in. round
hermal brush
rmaline ceramic
oval brush
Release/lock
attachment
buttons
Paddle brush
TO STYLE HAIR
1. After detangling hair, section damp hair into 4
to 8 equal parts, depending on hair type.
2. Select heat setting based on hair type and
desired effect.
3. Choose your desired brush attachment, place
the appliance into the hair, close to the root, and
brush through the section until hair is dry.
4. After styling, use the cool shot to set your look
for long-lasting results.
5. Finish look with your favorite styling spray.
select your setting
speed/temp.
hair type
cool
fragile or fine/thin hair
low
medium/normal hair
wavy, curly, coarse or thick
high hair
sets style in place for all
cool shot
hair types
This message about...
GROUND
FAULT
CIRCUIT
INTERRUPTERS
...can save a life!
IMPORTANT
Never immerse this product in water
or any other liquids.
IF YOU MUST USE YOUR HOT AIR STYLER IN
THE BATHROOM, INSTALL A GFCI* NOW!
Your local electrician can help you decide
which type is best for you – a portable unit that
plugs into the electrical outlet or a permanent
unit installed by your electrician. The National
Electrical Code now requires GFCIs in the
bathrooms, garages, and outdoor outlets of all
new homes.
WHY DO YOU NEED A GFCI? Electricity and
water don’t mix. If your hot air styler falls
in water while it’s plugged in, the electric
shock can kill you...even if
the switch is off. A regular
fuse or circuit breaker won’t
protect you under these
circumstances. A GFCI offers
you far greater protection.
A GFCI can save your life! Compared to that,
the price is small! Don’t wait...install one
now!
* A GFCI is a sensitive device that reacts
immediately to a small electric current leak
by stopping the electricity flow.
CLEANING &
MAINTENANCE
Unplug the appliance and let cool completely
before cleaning it.
Use a damp cloth to clean carefully. Make
sure the appliance is completely dry before
using again.
• The rear filter should be cleaned on a regular
basis using a soft brush to help prevent buildup
and overheating. This will also prolong the
motor life.
USER MAINTENANCE
Your hot air styler is virtually maintenance free.
No lubrication is needed. For proper operating
performance, the hot air styler must be kept
clean. When cleaning is needed, unplug the
cord, allow to cool and clean dust and lint
from air intake openings with a small brush
or the brush attachment of a vacuum cleaner.
The outer surface of the hot air styler should
be wiped clean with a cloth only. Blocked or
clogged air intake vents will cause the hot
air styler to overheat. If overheating occurs,
an automatic safety device will shut the hot
air styler or the heat off to prevent damage or
personal injury. If the unit or the heat turns off,
unplug the cord and allow the hot air styler to
cool for 10 to 15 minutes before restarting.
Make sure the air vents are clean.
CAUTION
NEVER allow the power-supply cord to be pulled,
twisted, or severely bent. Never wrap the cord
tightly around the hot air styler. Damage will
occur at the high flex point of entry into the hot
air styler, causing it to rupture and short circuit.
Inspect the cord frequently for damage. Stop
use immediately if damage is visible or unit
stops or operates intermittently.
If the cord or hot air styler is damaged or does
not operate properly, return it for repair to an
authorized Conair service representative only.
No repairs should be attempted by the
consumer.
STORAGE – IMPORTANT
When not in use, your hot air styler should be
disconnected, allowed to cool and stored in a
safe, dry location, out of reach of children. Do
not wrap line cord around hot air styler. Allow
the cord to hang or lie loose and straight at the
point of entry into the hot air styler.
LIMITED TWO-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your
unit free of charge for 24 months from the
date of purchase if the appliance is defective
in workmanship or materials. To obtain service
under this warranty, return the defective product
to the service center listed, together with your
purchase receipt. California residents need
only provide proof of purchase and should call
1-800-3-CONAIR for shipping instructions. In
the absence of a purchase receipt, the warranty
period shall be 2 years from the date of
manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS,
OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED IN
DURATION TO THE 24-MONTH DURATION OF
THIS WRITTEN, LIMITED WARRANTY. Some
states do not allow limitations on how long an
implied warranty lasts, so the above limitations
may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESS
OR IMPLIED, WHATSOEVER.
Some states do not allow the exclusion or
limitation of special, incidental, or consequential
damages, so the above limitation may not apply
to you.
This warranty gives you specific legal rights,
and you may also have other rights, which vary
from state to state.
BEAUTY TIPS
To achieve the looks you love and for more
great InfinitiPRO by Conair®
products, visit infiniti.conair.com
Please register this product at
www.conair.com/registration
Service Center
Conair LLC
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
For information on any Conair or InfinitiPRO by Conair
product, call 1-800-3-CONAIR or visit us
on the web at www.conair.com/infiniti
©2022 Conair LLC
7475 N. Glen Harbor Blvd., Glendale, AZ 85307
21NP077302 IB-17161


Produkt Specifikationer

Mærke: Conair
Kategori: Ikke kategoriseret
Model: NPTCCB01

Har du brug for hjælp?

Hvis du har brug for hjælp til Conair NPTCCB01 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Conair Manualer

Conair

Conair NPTCCA01 Manual

10 December 2024
Conair

Conair NPTCCA02 Manual

10 December 2024
Conair

Conair MASK2 Manual

1 Oktober 2024
Conair

Conair skn SFB11GK Manual

1 Oktober 2024
Conair

Conair Man GMTL6000 Manual

6 September 2024
Conair

Conair LNT1 Manual

6 September 2024
Conair

Conair Man GMT189R Manual

6 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Smeg

Smeg KIT6PX Manual

23 December 2024
Smeg

Smeg KIT6CX Manual

23 December 2024
Smeg

Smeg GTA-6 Manual

23 December 2024