Cotech EMT448 Manual

Cotech Ikke kategoriseret EMT448

Læs nedenfor 📖 manual på dansk for Cotech EMT448 (5 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 3 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/5
UNITED KINGDOM • CUSTOMER SERVICE
tel 020 8247 9300 customerservice@clasohlson.co.uk www.clasohlson.co.uk 10 – 13 Market Place, Kingston upon Thames, Surrey, KT1 1JZe-mail internet postal
1
2
3
4
5
6
7
8
Ver. 20180924
Engine Block Heater Timer with
Temperature Sensor
Art.no 36-6047 Model EMT448
Please read theentire instruction manual before using theproduct and then
save it for future reference. We reserve theright for any errors in text or images
and any necessary changes made to technicaldata. In theevent of technical
problems or other queries, please contact our Customer Services.
Safety
• Never try to dismantle, repair or modify theproduct in anyway.
• Make sure that theelectrical socket that theproduct is plugged into is
easily accessible in case it and theconnected product need to be quickly
disconnected from themains electricity.
• Do not connect products of this type to each other.
• Do not cover theproduct.
Buttons and functions
Operating instructions
Note: Thetimer has abuilt-in battery which is charged when thetimer is
plugged into awall socket (charging time is 2 hours). Itis therefore possible to
make settings (if thebattery is charged) even when thetimer is not plugged into
thewall socket. Thedisplay backlight cannot be lit when thetimer is unplugged
from thewall socket.
Setting the clock
1. Hold in [ OK ] until thehoursflash.
2. Press or hold in [ +1 ] or [ −1 ] to set thehours.
3. Press [ OK ] – theminutes display willflash.
4. Press or hold in [ +1 ] or [ −1 ] to set theminutes.
5. Press [ OK ] to confirm and exit theclock setmode.
Setting the departure time
1. Press [ SET ]. Thehours will then begin toflash.
2. Press or hold in [ +1 ] or [ −1 ] to set thehours.
3. Press [ OK ] – theminutes display willflash.
4. Press or hold in [ +1 ] or [ −1 ] to set theminutes.
5. Press [ OK ] to confirm and exit thesettingsmode.
Display backlight
Note: Thedisplay backlight can only be lit when thetimer is plugged into
awallsocket.
• Thebacklight will come on for 10 seconds whenever any of thebuttons
ispressed.
• Hold in [ SET ] for 3 seconds to switch thebacklight to “always on”mode.
• Hold in [ SET ] again to switch off thebacklight and set it to “on for
10seconds when button pushed”mode. Afteryou have held in Note:
thebutton for 3 seconds to change thebacklight from “always on” mode,
thebacklight will shine for 10 seconds before goingout.
Preset programmes
If you have for
example set your
departure time to ...
and thetemperature
where thetimer is
located is ...
thetimer will switch
theheater on at
07:00 5 °C ± 2 °C 30min before departure
07:00 0 °C ± 2 °C 60min before departure
07:00 −5 °C ± 2 °C 90min before departure
07:00 −10 °C ± 2 °C 120min before departure
07:00 −15 °C ± 2 °C or lower 180min before departure
• Thetimer will not switch theheater on if
thetemperature where thetimer is located is above
5 °C. Ifthetemperature rises to above 7 °C when
theheater is on, thetimer will switch theheateroff.
• Theheater will stay on 30 minutes past theset
departuretime. Itis −10 °C and thetimer Example:
switches theheater on 120 min before theset
departure time (see above). During these two hours,
thetemperature drops to −15 °C, thetimer does not
react to thechange in temperature but operates in
accordance with theinitial temperature detection of −10 °C.
• It takes about 45 minutes for thetimer to adapt to
anew temperature such as when it is taken out into
thecold from awarm indoor environment.
• Always make sure to insert thetimer into thewall
socket so it is orientated as shown in thepicture.
1. Clock
2. Departuretime
3. [ SET ] departure time setting
4. [ OK ] clock setting, confirm
5. Time elapsed since theheater was switched on
6. [ −1 ] Setting
7. [ RST ] Reset all settings (thedeparture time resets to adefault setting of 07:00)
8. [ +1 ] Setting
Note:
Time elapsed since theheater has been switched on only
shows when theheater is switchedon.
Care and maintenance
• Clean thetimer by wiping it with adrycloth.
• Thetimer should be unplugged from thewall socket if it is not to be used for
alongtime.
Troubleshooting guide
Thetimer
does
notwork.
• Check theclock and timer settings and adjust if necessary.
• Try plugging theengine/car heater directly into thewall
socket without thetimer, to see if everythingworks.
• Make sure that thecable between thetimer and thecar is
intact and properly plugged into both thetimer andcar.
• Check that thecar heater is switched on, that thecable is
intact and properly plugged into theoutlet in thepassenger
compartment.
• Try plugging thecar heater into another electrical outlet to
make sure that itworks.
• Is thewall socket that thetimer is plugged intolive?
Responsible disposal
This symbol indicates that this product should not be disposed of
with general householdwaste. Thisapplies throughout theentire EU.
Inorder to prevent any harm to theenvironment or health hazards
caused by incorrect waste disposal, theproduct must be handed in
for recycling so that thematerial can be disposed of in aresponsible
manner. Whenrecycling your product, take it to your local collection
facility or contact theplace of purchase. Theywill ensure that
theproduct is disposed of in anenvironmentally sound manner.
Specifications
Power supply 230V AC, 50/60Hz
Load capacity 3680W, 16A
Operating temperature −20 to 45 °C
IP rating IP44

Produkt Specifikationer

Mærke: Cotech
Kategori: Ikke kategoriseret
Model: EMT448

Har du brug for hjælp?

Hvis du har brug for hjælp til Cotech EMT448 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Cotech Manualer

Cotech

Cotech HT7715 Manual

18 September 2024
Cotech

Cotech K-CPL-LS4W-IR-S3 Manual

16 September 2024
Cotech

Cotech J1x-JF2-210/20 Manual

14 September 2024
Cotech

Cotech TD9511-3 Manual

12 September 2024
Cotech

Cotech S1J-AJ8-10 Manual

31 August 2024
Cotech

Cotech J5218D Manual

27 August 2024
Cotech

Cotech 50053 Manual

27 August 2024
Cotech

Cotech 51097X23 Manual

27 August 2024
Cotech

Cotech HT8750-EUCLA Manual

27 August 2024
Cotech

Cotech 36-6286 Manual

27 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Elektron

Elektron Overbridge Manual

26 November 2024
Elektron

Elektron Sidstation Manual

26 November 2024
SKROSS

SKROSS World Adapter Pro+ Manual

26 November 2024
SKROSS

SKROSS PRO – World & USB Manual

26 November 2024
SoundTube

SoundTube IPD-RS82-EZ Manual

26 November 2024
Kramer

Kramer 4x1VB Manual

26 November 2024
Kramer

Kramer RC-63A Manual

26 November 2024
SoundTube

SoundTube IPD-HP82-EZ Manual

26 November 2024
Kramer

Kramer RK-KVM-1U-PP3 Manual

26 November 2024
Gioteck

Gioteck VX-2 (PS3) Manual

26 November 2024