Dell PowerEdge 830 Manual

Dell Server PowerEdge 830

Læs nedenfor 📖 manual på dansk for Dell PowerEdge 830 (28 sider) i kategorien Server. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/28
w w w . d e l l . c o m | s u p p o r t . d e l l . c o m
About Cautions
CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.
Installing the DRAC 4/P
NOTICE: Read these installation instructions before installing your DRAC 4/P expansion card.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the
online or telephone service and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that came with the product.
This document provides special instructions for installing the Dell™ Remote Access Controller 4/P
(DRAC 4/P) card into a Dell PowerEdge™ system.
CAUTION: To help prevent damage to the DRAC 4/P card, ensure that the system is unplugged from its
AC power source before installing the card.
1
Shutdown the system and unplug it from its AC power source.
Your system’s
Product Information Guide
provides a sequence of safety steps that you should
perform before opening the cover of your system, including turning off the system and
disconnecting it from its AC power source. However, the DRAC 4/P card can be damaged if it
is installed in the system that is turned off, but still attached to its AC power supply. Ensure
that the system is unplugged from its AC power supply before installing the DRAC 4/P card.
2
Open the system. See "Opening the System" in the
Installation and Troubleshooting Guide
for
instructions.
3
Determine which expansion slot is most appropriate for the DRAC 4/P card.
Ideally, the DRAC 4/P card should be installed in the PCI expansion slot nearest the RAC
connector on the system board. See "System Board Connectors" in "Jumpers, Switches, and
Connectors" in the
Installation and Troubleshooting Guide
for an illustration of your system
board’s connectors.
4
Connect the DRAC 4/P card interface cable from the card to the system’s RAC connector on
the system board. See Figure 1.
NOTE: The interface cable and connectors are keyed and can be connected only one way.
5
Install the DRAC 4/P card into expansion slot:
a
Position the DRAC 4/P card so that the card-edge connector aligns with the system-board
card connector on the system board. See Figure 1.
September 2004


Produkt Specifikationer

Mærke: Dell
Kategori: Server
Model: PowerEdge 830

Har du brug for hjælp?

Hvis du har brug for hjælp til Dell PowerEdge 830 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Server Dell Manualer

Server Manualer

Nyeste Server Manualer

Asus

Asus RS300-E10-RS4 Manual

21 September 2024
D-Link

D-Link DP-G310 Manual

18 September 2024
APC

APC BK650EI Manual

18 September 2024
NEC

NEC Express5800 GT110d Manual

16 September 2024
Planet

Planet ICS-2400T Manual

14 September 2024
EXSYS

EXSYS EX-61001 Manual

14 September 2024
Megasat

Megasat SAT>IP Server Manual

13 September 2024
QNAP

QNAP TS-431P2-1G Manual

13 September 2024