Dension Gateway 500 Lite Manual

Dension Ikke kategoriseret Gateway 500 Lite

Læs nedenfor 📖 manual på dansk for Dension Gateway 500 Lite (1 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
Gateway 500 Lite & D2B
User’s Manual
v1.2
GWL-9202-3
1. Introduction
Dension Gateway 500 Lite enables music playback from
a USB storage or iPod through your vehicle’s
entertainment system, using the buttons of the car stereo
for basic control.
Gateway 500 Lite is designed to give easy to manage
control, in cars where it is not possible to display text,
therefore visualizing song information or browsing music
content is not possible.
Supported audio devices:
USB Flash Memory and Hard Disk Drive (UBS1.1
and higher)
File System: FAT16 or FAT32
Storage capacity: up to 64 GB
Music Format: MP3, WMA and WAV
Playlist Format: M3U and PLS
iPod* iPod (3rd and 4th generation)
iPod nano (1st, 2nd, 3rd and 4th generation)
iPod mini
iPod Photo 4G
iPod Video 5G
iPod Classic
iPod Touch (1st and 2nd generation)
iPhone and iPhone 3G
* Requires an optional iPod connection cable or
cradle.
In this manual the following conventions describe the
buttons of your car entertainment system:
Next/Back: Next and Previous track
FF/REW: Fast Forward and Rewind
CD1, CD2…: CD selection
Random: Random, Mix or Shuffle
Please refer to the manual of your car audio system for
specific details of operation.
Gateway 500 Lite needs to be installed and configured
correctly for your vehicle. For assistance with installation,
please refer to the Installation Guide.
2. Operation
General
Switch on your car radio and select CD changer as
source.
This is usually done by pressing the CDC button, or
pressing the CD button twice. If in doubt consult the
audio section of your car’s instruction manual.
Music will now play from your iPod or USB from the point
they last played. If both are connected, the one that was
used last will continue. Switching o the car or the radio
will stop playback and put the source devices to stand-by.
If neither the iPod nor USB storage is connected, than
CD1/Track99 is displayed, and the time counter is just
counting up.
Next/Back, FF/REW and Random/Repeat/Scan buttons
work as expected.
iPod
The original user interface of the iPod remains active (i.e.
the click wheel still works) so you can use it for browsing
as normal. The CD buttons have no effect on the iPod.
During playback the Radio displays CD1. The shown
track numbers and time counter are not synchronized
with the iPod.
Dension also offers an optional dash-mount cradle to
dock your iPod safely (not included).
The iPod is charged while connected to Gateway Lite.
2. Operation (continued)
USB
When the USB storage is inserted the first time, the
Gateway will start Play_All on the whole content.
You can choose Playlists or Folders stored in the root
directory by using the CD selection buttons.
Playlists and Folders are linked to the CD# buttons: first
playlist assigned in alphabetical order, then folders follow
similarly.. E.g. CD1 is assigned to the first playlist, CD2 to
the second, and so on.
During playback the Radio displays CD and Track
numbers and the elapsed time of the actual song.
Tips and Tricks:
You can easily define how the CD selection buttons
get assigned by naming the Folders or Playlists as:
1-Rock, 2-Blues, 3-Latin, etc.
If you want to listen to the whole content of a USB
storage again in Play_All mode, just remove it
during playback, and re-insert it after a few
seconds. Play_All will start again.
Alternatively you may also create a playlist with all
songs, and start it with a CD# button.
Play_All combined with Random gives you the
chance to find music that suits your mood. Start by
playing songs randomly. If a song does not fit your
mood, press Next. If you particularly like a song,
play the whole of that Folder by pressing Next and
Back within 1 sec.
When the playback of the last song in the Folder is
finished, Gateway returns to Random.
3. Service your car (Bypass mode)
Certain vehicles have complex system management
capabilities, and servicing may involve using a diagnostic
computer.
To avoid conflict with such diagnostics devices, put the
Gateway in Bypass mode, which temporarily disables the
operation of the Gateway.
In order to enter Bypass mode, first disconnect all
devices from the Gateway. The radio displays
Disc1/Track99.
Now press the Back button six times and the Gateway
switches to Bypass mode. At this point the Radio
switches back to FM or to the earlier selected audio
source.
The Gateway stays in Bypass mode even if you re-start
your car, and it is invisible to the electronic devices in
your car, or the diagnostics computers, just as if it was
not installed at all.
To exit Bypass mode, connect any device, wait a few
seconds, and select the CD changer source. Your
Gateway will start operating normally. (You may also
need to re-start certain vehicles to get the Gateway back
to normal mode.)
4. Help, Support & Warranty
If you need further assistance in using your Dension
Gateway, please contact your local supplier or visit
www.dension.com and click on ‘Support’.
Disclaimer
If your car’s electrical system begins to behave
erratically, please disconnect the Gateway interface
physically immediately and have it checked by your
installer. Dension and its authorized distributors and
retailers are not liable for any incidental consequential or
indirect damages or loss and do not assume liability for
any diagnostic fees.
The use of handheld devices while driving may be
subject to government legislation. Please ensure that
your use of the Dension device complies with applicable
traffic laws. Dension does not assume liability for any
events resulting from the illegal or irresponsible use of
handheld devices while driving.
Warranty
Dension devices carry a one-year limited warranty that
protects you from defects in material and workmanship of
products sold by Dension or its authorized distributors
and retailers. Dension does not warrant any installation
work or assume liability for any damage caused due to
negligence, improper installation or operation. For
warranty claims, proof of purchase is required.


Produkt Specifikationer

Mærke: Dension
Kategori: Ikke kategoriseret
Model: Gateway 500 Lite

Har du brug for hjælp?

Hvis du har brug for hjælp til Dension Gateway 500 Lite stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Dension Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Hendi

Hendi Uniq 860557 Manual

19 December 2024
Yamaha

Yamaha CTL-BN1 Manual

19 December 2024
Newline

Newline Huddle Cam Manual

19 December 2024
Newline

Newline Chromebox Manual

19 December 2024
Ketron

Ketron K8 Manual

19 December 2024
Hammond

Hammond EXP-100F Manual

19 December 2024
Hotone

Hotone Ampero Press Manual

19 December 2024
Studiologic

Studiologic FP50 Manual

19 December 2024