Dension Gateway 500S Manual

Dension Bilradio Gateway 500S

Læs nedenfor 📖 manual på dansk for Dension Gateway 500S (4 sider) i kategorien Bilradio. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
INSTALL GUIDE
ice4Link Gateway 500 MOST
State of the art car integration
for media players, USB and
Bluetooth devices
GW5-9210-8
Set the DIP switches to the following
position and install the Gateway
500 as illustrated below:
2
3.
Car side
CDC
1a.
Remove the blue locking clip from the
middle of the bre optic housing.
Strain the hook carefully with a
sharp tool, while pulling out the
optical bre from the housing.
1b.
1c.
Installation Type 1:
Vehicles supporting multiple CD changers
and equipped with a CD changer
• Audi A4/S4/RS4/A5/A6/S6/RS6/A8/Q7
with MMI-2 High (colour)
These vehicles allow selection of Gateway audio sources
and the original CD changer through the existing car audio
controls.
1
Introduction
Gateway 500 emulates a CD changer and uses CD changer controls to access
oboard audio sources including iPod, USB devices and Dension Gateway
accessories. If your car is not already equipped with a CD changer, it may be
necessary to have the car programmed by your dealer in order to use the
GW500 with it.
Programming the car for GW500
Audi
No programming required
BMW non iDrive-4
If original CD changer tted and MP3 capability is available: no programming
is required.
If original CD changer tted and no MP3 capability is available:
a) Retrot “KMP3” option with service computer
b) Used in non text capable BMW mode
If original CD changer not tted or E60 M-ASK used: install GW500 and retrot
“IPOD option with service computer
BMW with iDrive-4
If original CD changer tted: no programming is required
If original CD changer not tted: install an original BMW CD changer and
retrot “CD Changer” temporarily option with service computer
Mercedes
Generally no programming is required but in some cases (e.g. no device was
connected onto the optical ring) it is needed to enable a CD changer with the
service computer.
Porsche
Generally it is needed to enable a CD changer with the service computer but
in rare cases the PCM accept the GW500 without this enabling process.
Saab 9-3
It is needed to enable a CD changer with the service computer using an
original CD changer.
Installation Type 2a:
Vehicles with an existing CD changer
These vehicles allow selection of Gateway audio sources and
the original CD changer by switching the mode between CD
Changer and Gateway mode.
Audi (MMI-2 Basic Monochrome)
Saab 9-3 (Rear CDC)
Porsche (CDR 23/24 and PCM I/II/2.1)
for longer CDC and car side cable use
FOA1PO1
Mercedes (NTG1-, NTG2- Audio 20/50 and
Comand)
CDR PCM
Text capable BMW E87, E90, E91, E92, E93,
E60/61, E63/E64, E65/E66 (03/2005-), E70
and Mini (non iDrive-4)
Non text capable BMW E65/E66 (-03/2005)
(non iDrive-4)
3
Package Content & Electrical Installation
1
2
3
DIP switch
Car side
CDC side
Power
harness
4
Power harness:
-red wire
(+12V non switched)
-black (GND)
Car side CDC side
BMW E90, E91, E92, E93 with iDrive-4


Produkt Specifikationer

Mærke: Dension
Kategori: Bilradio
Model: Gateway 500S

Har du brug for hjælp?

Hvis du har brug for hjælp til Dension Gateway 500S stil et spørgsmål nedenfor, og andre brugere vil svare dig




Bilradio Dension Manualer

Bilradio Manualer

Nyeste Bilradio Manualer

Sony

Sony MEX-N4380BT Manual

18 December 2024
Alpine

Alpine MRV-T757 Manual

16 December 2024
Renkforce

Renkforce RF-ARAR-400 Manual

15 December 2024
Boss

Boss MR63UAB Manual

11 December 2024
Alpine

Alpine MRP-M850 Manual

8 December 2024
Alpine

Alpine CTA-1505R Manual

8 December 2024
Pioneer

Pioneer AVH-A240DAB Manual

7 December 2024
Pyle

Pyle PLMR14BW Manual

6 December 2024
Pyle

Pyle PLMR2DNBK Manual

6 December 2024
Pyle

Pyle PLTS73FX Manual

6 December 2024