Draper Traveller Manual

Draper Projektionsskærm Traveller

Læs nedenfor 📖 manual på dansk for Draper Traveller (1 sider) i kategorien Projektionsskærm. Denne guide var nyttig for 36 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

Operating Instructions

Traveller Portable Projection Screen by Draper

Setting Up the Screen Collapsing the Screen

① Generally reverse procedures used for screen setup.

Caution: Do not let go of the screen bail when collapsing the screen;

damage to screen could result. Slowly allow screen to roll into the case.

① Rotate legs (attached to bottom) until they are perpendicular to screen

case (see Fig. 1).

Troubleshooting

Screen will not fully extend:

Make sure the screen surface is not “catching” on anything. Make sure case

lid is fully open. Make sure roller is properly seated.

Screen will not close:

Check roller to make sure nothing is interfering with operation.

Screen tips forward or backward:

Make sure legs are perpendicular to screen case. If they are, screen may be

located on too severe an incline.

Case Latches will not open:

Press gently down on screen case just above each latch while opening.

Case Latches will not close:

Press gently down on screen case just above each latch while closing.

Carrying strap will not rotate out of the way so case will open:

Loosen or remove carrying strap altogether (see below).

Figure 2 (side view)

Caution

① Read instructions through completely before proceeding, and save for

future reference.

② Nothing should be fastened to screen case or viewing surface.

③ Do not write on viewing surface.

④ Do not let go of the screen handle when collapsing the screen; damage

to the screen could result. Slowly allow the screen to roll into the case.

⑤ Do not use solvents or abrasives for cleaning.

⑥ Beware of pinching hands and ﬁ ngers when adjusting upright.

NOTE: Screen has been thoroughly inspected and tested at factory and

found to be operating properly prior to shipment.

Figure 3

⑤ Place upright in upright stand, located inside case and centered on back

of screen. Adjust upright according to necessary screen height (see

Fig. 3).

⑥ Grasp screen bail and pull up in steady motion to raise screen. Hook bail

onto upright gooseneck (see Fig. 4). Adjust upright again if necessary.

Figure 4

② Rotate carrying strap so it does not interfere with opening case. You can

also remove the carrying strap by sliding down then off (see Fig. 2).

Figure 1

③ Unlatch and open screen case.

④ Remove upright from clips in case behind screen.

If you encounter any difﬁ culties installing or ser vic ing your Traveller, call your

dealer or Draper, Inc., in Spiceland, Indiana, 765/987-7999; or fax 765/987-7142.

A dienceu

Telescoping

Upright

Screen case

Lid

Legs

Case latches

Caution:

Beware of pinching

hands and ﬁ ngers when

adjusting upright.

Caution:

Beware of pinch-

ing hands and

ﬁ ngers when

adjusting upright.

Produkt Specifikationer

Mærke:	Draper
Kategori:	Projektionsskærm
Model:	Traveller
Vægt:	9525 g
Naturligt aspektforhold:	15:9
Samlet skærmstørrelse (højde x bredde):	147 x 88 cm
Diagonal:	68 "