Dyson CR01 Flowcheck Manual

Dyson Vaskemaskine CR01 Flowcheck

Læs nedenfor 📖 manual på dansk for Dyson CR01 Flowcheck (13 sider) i kategorien Vaskemaskine. Denne guide var nyttig for 43 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/13
DYSON CR01
DRUM BEARING REPAIR
I have written this guide assuming that the reader has no knowledge on how to dismantle
any part of the Dyson CR01. Having never worked on a CR02, I am unaware if the
construction of that model differs greatly.
I have borrowed various images from the net and thank everyone for their contribution.
Read each paragraph twice before starting that phase of dismantling.
Tools required.
a) Set of Torx bits / screwdrivers
b) Large hammer
c) Bolster.
d) Set of metric spanners / sockets
e) Digital Camera. (Always a good idea to photograph in situ before your remove)
1) Disconnect from the water and electricity supply and remove hoses. Drain as much
water from the machine as possible by removing the coin trap cover and putting the drain
pipe as low as possible.
2) Remove the top cover. Remove the two Phillips screws at the rear of the cover and slide
it backwards
3) Remove soap dispenser. The yellow catch at the rear of the dispenser allows it to be
removed.
4) Remove front controls / display.
a)This is held on with two torx screws and when removed should be slid downwards.
This will release the plastic tabs that hold it in place.
b) Disconnect the ribbon cable from where it attached to the machine body.
c)Remove the pressure sensor pipe. This just pulls off.
d) Disconnect the four power cables to the main on / off switch. The position of the
cables should be recorded for reassembly.
The entire control panel assembly should now be free
5) Remove exterior door. This is held in place with spring clips / hinges that are visible. I
found it easy to insert a flat screw driver into the hinge and push down the yellow clip.
6) Remove front panel. This is held in place with 4 torx screws and a number of plastic
tabs. Care should be taking not to break the plastic tabs. 2 screws are clearly visible on
the top of the panel and the other two are recessed into the hinge of the exterior door. If
you have not already removed the coin trap cover then this is the time do it as the front


Produkt Specifikationer

Mærke: Dyson
Kategori: Vaskemaskine
Model: CR01 Flowcheck

Har du brug for hjælp?

Hvis du har brug for hjælp til Dyson CR01 Flowcheck stil et spørgsmål nedenfor, og andre brugere vil svare dig




Vaskemaskine Dyson Manualer

Vaskemaskine Manualer

Nyeste Vaskemaskine Manualer

Maytag

Maytag MFW7020RF Manual

1 Januar 2025
LG

LG WTL1-85W Manual

1 Januar 2025
Bosch

Bosch WGH2440AFG Manual

31 December 2025
Bosch

Bosch WGH256A9FG Manual

31 December 2025
Bosch

Bosch WGH246A5NL Manual

31 December 2025
Bosch

Bosch WGE0340SNL Manual

31 December 2025
Bosch

Bosch WAN2827BFG Manual

31 December 2025
Bosch

Bosch WGH24405FG Manual

31 December 2025
Bosch

Bosch WGH256ACFG Manual

31 December 2025
Bosch

Bosch WGH244ACFG Manual

31 December 2025