Eltako ER12-001-UC Manual

Eltako Ikke kategoriseret ER12-001-UC

Læs nedenfor 📖 manual på dansk for Eltako ER12-001-UC (1 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 34 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

Switching and Control Relays ER12-001-UC

1 CO contact potential free 16 A/250V AC, incandescent lamp load up to

2000W. No standby loss.

Modular device for DIN-EN 60715 TH35 rail mounting.

1 module = 18 mm wide, 58mm deep.

State-of-the-art hybrid technology combines advantages of nonwearing electronic control with

high capacity of special relays. Universal control voltage 8 to 230 V UC.

Low control power demand, therefore substantially less heat is generated.

Integrated free-wheeling anti-surge diode (A1 = +, A2 = -).

Safe disconnection to VDE 0106, Part 101; therefore, these devices can also be used as

coupling relays.

By using a bistable relay coil power loss and heating is avoided even in the on mode.

The relay contact can be open or closed when putting into operation. It will be synchronised at

first operation.

This relay is not suitable to feed back the switching voltage signal of a dimmer switch.

Use only relays ESR12DDX-UC, ESR12NP-230V+UC or ESR61NP-230V+UC for this

purpose.

The electronics does not have an internal power supply and therefore no standby loss.

The microcontroller is activated when the control contact closes. This switches the bistable

relay to the correct direction. The bistable relay switches back either when the control contact

opens or when the control voltage falls.

ER12- 001-UC

ER12-001-UC 1 CO 16 A EAN 4010312205365 40,30 €/pc.

Recommended retail prices excluding VAT.

Technical data page 12-13.

Housing for operating

instructions GBA12,

see accessoirs, chapter Z.

Produkt Specifikationer

Mærke:	Eltako
Kategori:	Ikke kategoriseret
Model:	ER12-001-UC
Produktfarve:	Blue,White
Strøm:	16 A
Driftstemperatur (T-T):	-20 - 50 °C
Antal moduler:	1
Antal poler:	1
DC spændingsområde:	10 - 230 V
AC udgangsspænding:	250 V
Antal kontakter:	1