Ernitec 0070-08215 Manual

Ernitec Overvågningskamera 0070-08215

Læs nedenfor 📖 manual på dansk for Ernitec 0070-08215 (2 sider) i kategorien Overvågningskamera. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/2
2 2 Camera Dimensions.
Figure 2 2 - Dimensions (Unit: mm)
Special Announcement
, For more information please refer to website.
Fully understand this document before using this device,
and strictly observe rules in this document when using this
device. If you install this device in public places, provide the
tip "You have entered the area of electronic surveillance" in
an eye-catching place. Failure to correctly use electrical
products may cause fire and severe injuries.
ŸStrictly observe installation requirements when installing
the device. The manufacturer shall not be held responsible
for device damage caused by users' non-conformance to
these requirements.
ŸStrictly conform to local electrical safety standards and use
power adapters that are marked with the LPS standard
when installing and using this device. Otherwise, this
device may be damaged.
ŸUse accessories delivered with this device. The voltage
must meet input voltage requirements for this device.
ŸIf this device is installed in places with unsteady voltage,
ground this device to discharge high energy such as
electrical surges in order to prevent the power supply from
burning out.
ŸWhen this device is in use, ensure that no water or any
ŸAvoid heavy loads, intensive shakes, and soaking to
prevent damages during transportation and storage. The
warranty does not cover any device damage that is caused
during secondary packaging and transportation after the
original packaging is taken apart.
ŸProtect this device from fall-down and intensive strikes,
keep the device away from magnetic field interference, and
do not install the device in places with shaking surfaces or
under shocks.
ŸClean the device with a soft dry cloth. For stubborn dirt, dip
the cloth into slight neutral cleanser, gently wipe the dirt
with the cloth, and then dry the device.
ŸDo not jam the ventilation opening. Follow the installation
instructions provided in this document when installing the
device.
ŸKeep the device away from heat sources such as radiators,
electric heaters, or other heat equipment.
ŸKeep the device away from moist, dusty, extremely hot or
cold places, or places with strong electric radiation.
ŸIf the device is installed outdoors, take insect- and
moisture-proof measures to avoid circuit board corrosion
that can affect monitoring.
ŸRemove the power plug if the device is idle for a long time.
ŸBefore unpacking, check whether the fragile sticker is
damaged. If the fragile sticker is damaged, contact
customer services or sales personnel. The manufacturer
shall not be held responsible for any artificial damage of the
fragile sticker.
ŸAll complete products sold by the manufacturer are
delivered along with nameplates, quick setup guide and
accessories after strict inspection. The manufacturer shall
not be held responsible for counterfeit products.
ŸThe manufacturer will update this manual according to
product function enhancement or changes and regularly
update the software and hardware described in this manual.
Update information will be added to new versions of this
manual without prior notice.
ŸThis manual may contain misprints, technology information
that is not accurate enough, or product function and
operation description that is slightly inconsistent with the
actual product, the final interpretation of company is as a
standard.
ŸThis manual is only for reference and does not ensure that
the information is totally consistent with the actual product.
For consistency, see the actual product.
Precautions
Open the package, check the appearance of product for no
obvious damage, and confirm the item list for table 1-1 is
consistent.
Table 1 1- Packing list
2.1 Device Ports
Different devices may have different ports, multi-head cables,
and fill lights; Please refer to the actual product.
Different devices may have different dimensions; Please
refer to the actual product.
NOTE
NOTE
NOTE
liquid flows into the device. If water or liquid unexpectedly
flows into the device, immediately power off the device and
disconnect all cables (such as power cables and network
cables) from this device.
ŸDo not focus strong light (such as lighted bulbs or sunlight)
on this device. Otherwise, the service life of the image
sensor may be shortened.
ŸIf this device is installed in places where thunder and
lightning frequently occur, ground the device nearby to
discharge high energy such as thunder strikes in order to
prevent device damage.
It alerts you to moderate dangers which, if not
avoided, may cause minor or moderate injuries.
It alerts you to risks. Neglect of these risks may
cause device damage, data loss, device
performance deterioration, or unpredictable
results.
It provides additional information.
NOTE
CAUT IO N
WARNING
WARNING
CAUTION
1
Device Structure
2
Open Package Examination
Bullet Network Camera
Quick Setup Guide
Accessory Package
Installation Location Sticker
Component Quantity Remark
1
1
1
Figure2 1- Multi-head cable
1
Table 2-1 Multi-head cable description
Figure 2 3 -Install SD card
Port
1
2
3
4
5
IN
OUT
GG
Connect to a standard Ethernet
cable or PoE. The green light is on,
the network connection is normal;
The yellow light flashes when the
data is transmitted. Some models
maybe not have the lights; Please
refer to the actual product.
Connect to an external audio
device such as a speaker.
Applied for
camera with
audio
function
Receive an analog audio signal
from devices such as a sound
pickup device.
Connect to a 12V direct current
(DC) power supply.
Alarm output COM
Applied for
alarm
function
Alarm output terminal
Alarm input COM
Alarm input terminal
2
1
ID
3
5
Network
access port
Support PoE
supply.
Core Description Remark
Audio output
Power supply
(DC 12V)
Audio input
port
OUT
IN
G
G
4
Reset PWR SD
95
30
2-1/4UNC x8
4-φ4.5
98
70
70
100
275
107
273~~303 ajustable
A
B
Pedestrian direction
15°
If user requires higher
accuracy of personnel count,
we recommend the user to
install camera and draw the
line following a gure 2-4. s fi
Figure 2 4 - Installation of personnel count
CAUT IO N
Deimos Pro Network Camera
5MP Vari-Focal Lens with
IR-Active Deterrence
Quick Setup Guide
Item no.: 0070-08215

Produkt Specifikationer

Mærke: Ernitec
Kategori: Overvågningskamera
Model: 0070-08215

Har du brug for hjælp?

Hvis du har brug for hjælp til Ernitec 0070-08215 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Overvågningskamera Ernitec Manualer

Ernitec

Ernitec 0070-08117 Manual

2 September 2024
Ernitec

Ernitec Wolf Pro Manual

1 September 2024
Ernitec

Ernitec 0070-08112 Manual

22 August 2024
Ernitec

Ernitec 0070-08214 Manual

22 August 2024
Ernitec

Ernitec 0070-08215 Manual

22 August 2024
Ernitec

Ernitec 0070-08316 Manual

22 August 2024
Ernitec

Ernitec Orion DX 832 IR Manual

21 August 2024
Ernitec

Ernitec TAURUS DX 622 Manual

21 August 2024
Ernitec

Ernitec 0070-04344IR Manual

20 August 2024
Ernitec

Ernitec ORION DX 822IR Manual

19 August 2024

Overvågningskamera Manualer

Nyeste Overvågningskamera Manualer

QSC

QSC NC-110 Manual

21 November 2024
Sony

Sony SNC-DH160 Manual

16 November 2024
Bresser

Bresser DL-30MP Manual

15 November 2024
D-Link

D-Link DCS-6500LHV2 Manual

14 November 2024
D-Link

D-Link DCS-2803KT Manual

13 November 2024
D-Link

D-Link DCS-2804KT Manual

13 November 2024
D-Link

D-Link DCS-931L Manual

13 November 2024
D-Link

D-Link DCS-6100LHV2 Manual

13 November 2024
Philips

Philips Series 3000 HSP3800 Manual

13 November 2024
Emos

Emos H4060 Manual

13 November 2024