Eureka Spitfire 2 Manual

Eureka Fuld Spitfire 2

Læs nedenfor 📖 manual på dansk for Eureka Spitfire 2 (2 sider) i kategorien Fuld. Denne guide var nyttig for 33 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Contents of Carry bag
Tent body
Tent fly
Pole bag: 2 poles with prebends to make hoops, 1 longer
(head-end pole) & 1 shorter (foot-end pole)
Stake bag: stakes & guyout cords
Setting up the Tent Body
1. Spread the tent body out, floor side down. Locate the
yellow webbing stake out loop, as this marks the head-end of
the tent. Securely stake the yellow webbing loop to the
ground.
2. Assemble the two poles, placing the longer pole near the
head-end of the tent & the shorter pole near the foot area.
3.Starting near the head-end of the tent, insert the tip of the
long pole into the grommet (metal ring) located in the black
webbing stake out loop. Insert the other pole tip into the
grommet on the opposite side of the tent. Reach down to the
tent body & connect all of the black plastic clips to the pole.
4. Repeat the process near the foot-end of the tent with
second, shorter pole
5. To raise your tent, grasp the black webbing loop with the
side-release buckle at the tip of the foot-end. As you pull the
webbing, the poles will raise. When fully tensioned, the poles
will be upright. Securely stake the black webbing loop to the
ground.
6. Futher secure the tent to the ground by using stakes in the
black webbing loops at the base of each pole.
Attaching the Fly Sheet
1. Unfold the fly & drape it over the tent matching the
yellow webbing on the fly with the yellow webbing on the
tent body. Align and center the fly on the tent body so the
fly’s seams follow the tent body’s poles.
2. Clip together the side-release buckle on the yellow
webbing.
3. Locate the bright green webbing guyout loops on the
outside of the flysheet, reaching under the guyout loops,
wrap the hook/loop closure around the underlying pole to
secure the fly to the pole. Secure the guyout loops at both
the head-end & foot-end poles.
4. Clip together the side-release buckles in the black
webbing at the tip of foot-end.
5. Now clip the buckles at the base of the foot-end pole.
6. Further tension the fly by pulling the webbing through
the 4 side-release buckles you have closed.
7. Using stakes, secure the two remaining stake-out loops
on the fly to create your vestibules.
8. Guyouts: Attach the two provided guyout cords to the
green webbing guyout loops on the head-end pole. If you
expect severe weather, utilize the guyouts on the foot-end
pole. Get in the habit of always using the guyouts, even in
good weather.
Eureka! Set-Up Instructions
Spitfire Solo (#2628314)
Spitfire 2 (#2628318)
REV 082714
Special Feature:
This tent features a poke-up vent in the fly. Lift the vent
open & prop it open with the stay. One can access the
vent from inside the tent through the zipper located in
the ceiling.
OTHER FEATURES
7. The tent body will now be erect, properly tensioned,
and anchored to the ground.
v
e
n
t
o
u
t
o
f
v
i
e
w


Produkt Specifikationer

Mærke: Eureka
Kategori: Fuld
Model: Spitfire 2

Har du brug for hjælp?

Hvis du har brug for hjælp til Eureka Spitfire 2 stil et spørgsmål nedenfor, og andre brugere vil svare dig