Eureka Jade Canyon 6 Manual
Læs nedenfor 📖 manual på dansk for Eureka Jade Canyon 6 (2 sider) i kategorien Fuld. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/2
Contents of Carry bag
Tent body
Tent fly
Pole bag:4 steel straight poles (leg poles)
2 long bright green aluminum poles (roof poles)
Stake bag: 8 steel skewer stakes
E!LUMINATE SYSTEM: 2 silver panels
Eureka! Media Center (gear hammock with clear panel)
Gear Hammock
1. Spread the tent body out, floor side down. Locate the yellow webbing
stake out loop, as this marks the right front corner of the tent. Also locate
the black plastic elbow hub & grey fabric roof pole sleeves which cross in the
top center of the tent body.
2. Assemble the two bright green aluminum roof poles
3. Starting at the corner with the yellow webbing stake out loop, follow the
sewn seam past the plastic hub and insert one of the poles into the grey
fabric pole sleeve. Continue sliding the pole through the sleeve until it
reaches the black plastic hub at the opposite corner. Insert the pole ends
into the hub opening which has internal ribs. (NOTE: the other hub opening
is smooth & is used for the larger diameter leg poles.) Repeat process with
the second pole & sleeve. Correctly threaded, the poles will make a large X
shape, crossing in the middle of the tent.
4. Assemble the four leg poles & place one at each corner of the tent.
5. Starting at the yellow webbing stake out loop, insert the open end of the
leg pole into the smooth opening of the black plastic hub. Raising the pole &
hub, reach down and insert the tip of the pole into the outer-most grommet
(metal ring) on yellow webbing stake out loop. Moving to another corner,
repeat process with second pole, then a third, & lastly the fourth. Your tent
will now be standing.
6. Walk around the tent and connect all of the black plastic clips to their
respective poles.
Attaching the Fly Sheet
1. Unfold the fly & drape it over the tent matching the yellow
webbing on the fly with the yellow webbing on the tent body.
Align and center the fly on the tent body so the fly’s seams follow
the tent body’s poles.
2. Clip together the side-release buckle on the yellow webbing,
joining the fly to the tent body.
3. Locate the bright green triangular wing at the upper corner of
the fly. Reaching under the wing, wrap the hook/loop closure
around the underlying pole to secure the fly to the pole. Farther
down the pole & fly is another the hook/loop closure. Also wrap
this hook/loop closure around the pole to secure the fly to the
pole.
4. Repeat wrapping the hook/loop closures around all of the
three remaining leg poles to secure the fly to the tent’s pole
structure.
5. Clip together the side-release buckle on the three remaining
black webbing stake out loops.
6. Walk around the tent & equally tension all four corner
webbings by pulling the webbing through the buckle to tension
the fly.
7. Guyouts: The bright green triangular wings also contain
pockets which store the pre-attached guyout cords. Remove the
cord from the pocket & extend it to full length. Secure the guyout
cord to the ground with a stake. In high winds, an additional
guyout cord can be attached to the small black webbing loop
halfway up the leg pole. Get in the habit of always using the
guyouts even in good weather.
7. Secure the tent to the ground using the stakes provided. Start at the
yellow webbing stake out loop, next proceed to the diagonally opposite
corner. While firmly pulling on the black webbing stake out loop,
hammer in the stake. Repeat process with the other two corners.
8. The tent body will now be erect, properly tensioned, and secured to
the ground.
Eureka! Set-Up Instructions
Jade Canyon 4 (#2601276)
Jade Canyon 6 (#2601281)
REV 082714
Setting up the Tent Body
E!Luminate System:
Increases the brightness of floor-level lighting provided by LED lanterns
inside the tent. Two removable triangular silver-reflective E!Luminate
panels install in the ceiling with O-rings & toggles The panels reflect a
lantern’s light downwards to the floor, increasing the brightness of
floor-level light up to 3 times. A reinforced webbing hang loop with D-ring
securely holds LED lanterns at the tent’s peak. An elegant, yet simple &
effective solution to brighten the nighttime camping experience.
NOTE: Only for use with battery powered LED lanterns.
EUREKA! Media Center:
Watch video on tablets & other small electronic devices from the comfort
of your sleeping bag. The clear center panel of the Media Center is
touchscreen friendly. The Media Center attaches with hooks to pre-in-
stalled O-rings located in each corner of the tent. Also secure the center
of the Media Center with the cord & hook to support heavier items.
Gear Hammock:
The gear hammock attaches with hooks to pre-installed O-rings located
in each corner of the tent. Secure the center of the hammock with the
cord & hook to support heavier items.
E! Power Port:
The zippered E! Power Port allows you to bring an electrical power cord
inside the tent.
Produkt Specifikationer
| Mærke: | Eureka |
| Kategori: | Fuld |
| Model: | Jade Canyon 6 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Eureka Jade Canyon 6 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Fuld Eureka Manualer
21 Maj 2024
5 April 2024
30 Marts 2024
20 Marts 2024
16 Marts 2024
21 Februar 2024
19 Januar 2024
9 December 2023
23 November 2023
7 November 2023
Fuld Manualer
- Fuld Thule
- Fuld Biltema
- Fuld Isabella
- Fuld Crivit
- Fuld Dometic
- Fuld Outwell
- Fuld Thermex
- Fuld Skandika
- Fuld Vango
- Fuld Wood's
- Fuld Trigano
- Fuld Rollei
- Fuld Perel
- Fuld Bestway
- Fuld Fiamma
- Fuld Black Diamond
- Fuld Asaklitt
- Fuld MSR
- Fuld Sierra Designs
- Fuld Outdoor Connection
- Fuld SereneLife
- Fuld Kelty
- Fuld Dwt-Zelte
- Fuld Wechsel
- Fuld Grand Canyon
- Fuld Jamet
- Fuld TOOLPORT
- Fuld Nordisk
- Fuld Yamazen
Nyeste Fuld Manualer
11 November 2024
5 November 2024
23 Oktober 2024
10 Oktober 2024
10 Oktober 2024
10 Oktober 2024
30 September 2024
30 September 2024
12 August 2024
12 August 2024