Extech 392052 Manual


Læs nedenfor 📖 manual på dansk for Extech 392052 (4 sider) i kategorien Miljøtermometer. Denne guide var nyttig for 3 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
392052-en-US_V1.1 12/14
INSTRUCTION MANUAL
Flat Surface Stem Dial Thermometer
Model 392052
Specifications
Display 2000 count liquid crystal display
Units oC/oF selectable by push-button
Measurement range -58 to 572oF (-50 to 300oC)
Resolution 0.1o to 199.9o, 1o > 199.9o
Accuracy ±1.8oF (1oC) from –22 to 452oF (-30 to 250oC) : ±4oF
(2oC) outside this range
Sensor length 5” (130mm)
Sensor tip diameter 0.57” (14.5mm)
Sensor material Stainless steel
Auto Power Off After one hour of operation
Operating temperature for display 14 to 122oF (-10 to 50oC) (dial display)
Battery One 1.5V LR44 cell or equivalent (A76/G13) cell
Operation
Battery Installation/Replacement
Using a coin or a screwdriver, turn the battery compartment cover a quarter turn to the left. Remove the
cover and install/replace the battery observing the proper polarity.
Taking Temperature Measurements
1. Press the ON/OFF button to turn the thermometer ON. The digital display will begin to indicate
temperature. If the display does not operate, replace the battery.
2. Press the oF/oC button to select the desired temperature units.
3. Place the sensor disk flat against the surface to be measured and read the temperature on the
display.
Considerations
For best results, the probe disk should be held flat against the surface and the surface are should
be free of any dirt or substance that will inhibit thermal contact.
The thermometer should not be placed inside any oven or microwave.
Remove the battery from the thermometer if it is not to be used for an extended time period.


Produkt Specifikationer

Mærke: Extech
Kategori: Miljøtermometer
Model: 392052

Har du brug for hjælp?

Hvis du har brug for hjælp til Extech 392052 stil et spørgsmål nedenfor, og andre brugere vil svare dig